Question

Stage I water restrictions begin when the aquifer level reached 660 feet Stage II water restrictions begin when the aquifer l

I really need help with these I would appreciate it so much

0 0
Add a comment Improve this question Transcribed image text
Answer #1

Answer 6)If the water level falls roughly at this rate then there will be scarcity of water and we will enter into the stage 3 of pumping

Answer 7) The aquifer water elevation is directly proportional to the rainfall. The rains causes an increasing in the water level in the aquifers

Answer 8) The two dates are 25/1 and 29/1 when the rise in aquifer level is high with increase in rainfall

Answer 9) The elevation of the water table in the aquifer was low in the mentioned dates, thus the pumping had to be reduced

Answer 10) A positive correlation is present between the aquifer elevation and the rate of pumping. The rate of pumping decreases as the elevation of the aquifer decreases.

Add a comment
Know the answer?
Add Answer to:
I really need help with these I would appreciate it so much Stage I water restrictions...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions
  • Hello! thank you so much for helping me, I really appreciate it. Below are the questions...

    Hello! thank you so much for helping me, I really appreciate it. Below are the questions but I will also write them out: Statement: Crane Limited equipment on September 30,2018, for $41,120 cash. The equipment originally cost $153,380 when purchased on Jan 1, 2016. It has an estimated residual value of $4,240 and a useful life of five years. Depreciation was last recorded on Dec 31, 2017, the company's year end. Record debit side accounts first followed by credit side...

  • I need help drawing these intermolecular forces with dissolving in water Part Apply your learning and...

    I need help drawing these intermolecular forces with dissolving in water Part Apply your learning and relate to intermolecular forces Der a picture in the space below of wis h the following dissolving in water. Be sure to show the facts with the dissolved p les and provide a key where c ry. Noter you will not find these compends on the simulation Need help Nead section in your textbook or read the Khan Academy article aramalaran intermolecular force MgSO,...

  • Hi, I need help with this Chemistry problem, much like General Chemistry but I am really...

    Hi, I need help with this Chemistry problem, much like General Chemistry but I am really confused when I look at the solution. I will provide you the solution of the problem together with the problem. What I need you to do is to walk me through all the reasonings, logical steps that lead to the solution provided. I appreciate your help and I will give you feedback as to how clear your answer is. And here is the solution...

  • Need help with 6 questions. Thank you so much! I really appreciate it! Have a great...

    Need help with 6 questions. Thank you so much! I really appreciate it! Have a great day! :) 1. An infant is admitted to the hospital to rule out sepsis. The infant weighs 8 lb. Ampicillin is prescribed. The recommended dosage is 200 - 400 mg/kg/24 h. Calculate the 24-hour dosage range for this infant with a possible severe infection. 2. The MD has ordered 210 mg of acetaminophen q4–6 h for pain and fever for a postoperative child. The...

  • Please help me with this. I'm so lost. If you could be detailed/help explain, I would...

    Please help me with this. I'm so lost. If you could be detailed/help explain, I would appreciate it a lot. Thank you. Topic: Onions, Lily Anther, Mitosis and Meiosis!: Prophase I, Prometaphase I, Metaphase I, Anaphase I, Telophase I, Cytokinesis Prophase II, Metaphase II, Anaphase II, Telophase II, Cytokinesis II Tetrads Intro Pretend you were in the lab and you took some onion root tips and some lily and viewed them under the lab in a microscope. We are Concerned...

  • I could really use some help with this. Shown is 3 parts: the questions I need...

    I could really use some help with this. Shown is 3 parts: the questions I need help with, the diagram, and additional info for each piece of the system, if needed. If you can, please answer fully and explain where necessary. Please also write legibly. Thank you for your time and help! a) What are the powers required by the condensate pump and feedwater pump? What is the heat transfer rate to the water in the boiler? Describe why they...

  • hey i really need help for the molality to mass question. the solvent is water and...

    hey i really need help for the molality to mass question. the solvent is water and 100g. SOS! Table 3: Data obtained for the boiling point elevation simulation. (3 marks) Solute Molality (mol/kg) Solution Boiling Point (°C) NaCl(s) 0.0000 100.00 AT) (°C) 0.0 NaCl(s) 0.1711 NaCl(s) 0.3422 NaCl(s) 0.6844 NaCl(s) 1.3688 CaCl2(s) 0.1711 C12H22011(s) 0.1711 Molality to Mass Sample Calculation: (1 mark) PART 3 BOILING POINT ELEVATION 16. Visit this webpage: https://pages, oregon.edu/tgreenbo/colligative.html; the screenshot (Figure 5) below should be...

  • Hi! Really need help with this problem! I saw that my question has been answered before...

    Hi! Really need help with this problem! I saw that my question has been answered before but it was confusing. The conductivity I got for NaCl in part II was 12,030 Heres the previous question. I already answered it. I just need help with the math on Q13 Q.13. Calculate the mass of CuCl2:2 H2O that would be needed to prepare a 50.00-ml aqueous solution that would yield the same conductivity as the NaCl(aq) solution that you prepared in Part...

  • Hi.Can you help me answer these questions.thank you so much for your help.I appreciate it These...

    Hi.Can you help me answer these questions.thank you so much for your help.I appreciate it These are the clearer pic of the questions.i hope you can help me Hello.I think that these are clear enough.If you cannot answer and read all questions,can you help me answer some of them which are readable because i really need your help.thanks a lot. 31. 01. Using the appendix value given for Thermodynamics, find the temperature of which the following ne action becomes spontaneous...

  • please help on all questions and explain because i really need help in this!!! :) 1) After rinsing the buret with w...

    please help on all questions and explain because i really need help in this!!! :) 1) After rinsing the buret with water, filling the buret with the solu forgot to do this? the buret with water, why was it rinsed three times with the NaOH solution before uret with the solution? How would this affect your final molarity of NaOH, if you 2) Does the amount of water used to dissolve the KHP affect the molarity of the NaOH solution?...

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT