4. Determine the x-y and n-t components of the 13-kip force Facting on the simply-supported beam....
Chapter 2, Problem 2/009 Determine the x-y and n-t components of the 12.0 kip force Facting on the simply supported beam. F = 12.0 kips 40° 13' B Answers: kips kips kips kips
Chapter 2, Problem 2/009 Determine the x-y and n-t components of the 15.0 kip force F acting on the simply supported beam F 15.0 kips 35 20' 38' 15° Answers: kips kips kips kips Click if you would like to Show Work for this question: Open Show Work
Q.2: An angle is used as a simply supported beam, 48 in. long. The beam carries a 1.0-kip load at its midspan as shown in Figure. Determine (1) the angle between the neutral axis and the horizontal; and (2) the maximum bending stress in the beam 1.0 kips 24 in. 24 in Q.2: An angle is used as a simply supported beam, 48 in. long. The beam carries a 1.0-kip load at its midspan as shown in Figure. Determine (1)...
4. The simply supported beam is subjected to the loading shown. Determine the deflection at its center C by using superposition method (diagrams are in the Appendix C). 2 kip/ft 40 kip.ft F 104 | 10 10 ft 10 ft
Determine: (a) the x, y and z components of the 520 kip force shown below, and (b) the angles ?x, ?y and ?z defining the direction.
4. For a simply supported beam AB with concentrated load at C, determine step-by-step (a) the graph for bending moment, (b) the elastic curve y(x) for 0<x< Land (b) the deflection at point C. The length of the beam L-a+b.
Determine the internal normal force, shear force, and moment at points and D in the simply supported beam. Point Dis located just to the left of the F = 14 kN concentrated load.(Figure 1)
a simply supported beam shown has a span length of 16 ft. the beam is laoded with to concentrated service live loads of 40 kips and 80 kips as shown. if lateral support is provided only at both ends, select the lightest w section of A992 steel that can carry these applied loads. neglect the weight of the beam. ***Need this answered ASAP please*** ***Please show ALL steps*** steel design - please show what tables the values come from. thank...
4. A 5m long simply supported cantilever steel beam with a cross section of 0.1 x 0.1 m 800 N,E shown below. Determine the overall deflection of the beam. W 650 N/m, F = 200 GPa) (Ans: -0.05 m) F 800 N W-650 N/m
Problem #4 (20 points): For the following simply supported beam: a) Determine equations for V(x) and M(x) for sections 0<x< 2 and 2<x< 8. Box your answers. b) Roughly sketch the shear and bending moment diagram for the beam. c) Determine the maximum bending moment (magnitude), Mmax and where it occurs, Xmax 4 kN/m XA 2m- - 6 m 3 KN