If a comb-drive is connected with the signal generators and voltage sources according to the following schematic diagram. Apply Vb = 20 Volts, and Vac = 20cos(2pft) Volts. Scan the frequency f from 5 kHz to 12 kHz with small incremental steps. What is the expected frequency response of the device? Sketch it in Fig. 5 and briefly explain why. Please indicate how many peaks you expect, where they locate, and their expected amplitudes based on the data obtained in session 2 experiment 1.
It is not necessary to be very accurate in the sketch, and you may hand-draw directly in Fig.5 below.
We need at least 10 more requests to produce the answer.
0 / 10 have requested this problem solution
The more requests, the faster the answer.
summatize the following info and break them into differeng key points. write them in yojr own words
apartus
6.1 Introduction—The design of a successful hot box appa- ratus is influenced by many factors. Before beginning the design of an apparatus meeting this standard, the designer shall review the discussion on the limitations and accuracy, Section 13, discussions of the energy flows in a hot box, Annex A2, the metering box wall loss flow, Annex A3, and flanking loss, Annex...
summarizr the followung info and write them in your own words and break them into different key points. 6.5 Metering Chamber: 6.5.1 The minimum size of the metering box is governed by the metering area required to obtain a representative test area for the specimen (see 7.2) and for maintenance of reasonable test accuracy. For example, for specimens incorporating air spaces or stud spaces, the metering area shall span an integral number of spaces (see 5.5). The depth of...
> picture of diagram: https://imgur.com/a/L0WGbgd
Alexblue Tue, Mar 30, 2021 10:08 PM