A steam power plant is intended to be used for heating as well as power generation....
A steam power plant is intended to be used for heating as well as power generation. The net power required from this installation is 5 MW and the heating power is 12 MW. While the steam produced at 4 MPa, 440 degrees Celsius in the boiler expands in the isentropic turbine, the steam to be used in heating is drawn from the turbine at 140 kPa and it is condensed in the heating installation and mixed with water from the condenser with a pressure reducer after cooling down to 40 degrees Celsius. In addition, intermediate steam is taken at 0.4 MPa to be sent to ten mixed mixtures. The pumps are isentropic and the condenser temperature is 40 degrees Celsius.
a) Calculate the flow rate of the steam used for heating.
b) Find the flow rate of the steam and intermediate steam produced in the boiler.
C) Calculate the heat given in the boiler and the heat taken from the condenser at once.
Homework Answers
Add Answer to:
A steam power plant is intended to be used for heating
as well as power generation....
A Rankine Cycle based steam power plant produces 200 MW of power. Steam exits the boiler...
A Rankine Cycle based steam power plant produces 200 MW of power. Steam exits the boiler at 3 MPa and 500° C. The turbine exit is at 40 kPa. Isentropic efficiencies of the turbine and pump are 75% and 70% respectively. Show the cycle on a T-s diagram Calculate the mass flow rate of steam Determine the heat transfer rates in the boiler and condenser in MW Determine the cycle efficiency Determine the mass flow rate of the condenser cooling...
2) An ideal power plant produces steam at 3.5 MPa, 600°C in the boiler. The condenser with the ca...
Please solve question using questions numbers not the ones in
Solution Manual
2) An ideal power plant produces steam at 3.5 MPa, 600°C in the boiler. The condenser with the capacity of 12 MW is maintained at 50°C. The first turbine section expands to 600 kPa and then flow is reheated followed by the expansion in the low pressure turbine where the state is saturated vapor. a. Find the reheat temperature. b. Find the total turbine power output and the...
1. A thermoelectric steam generation plant operates on a Rankine cycle with reheating and two boiler...
1. A thermoelectric steam generation plant operates on a Rankine cycle with reheating and two boiler feed water heaters, one open and one closed. Steam enters the high pressure turbine at P8 and 500 ° C and the low pressure turbine at P10 and 500 ° C. The condenser pressure is 40 kPa. Steam is drawn from the turbine at a pressure P11 for the closed feed water heater and at a pressure P12 for the open feed water heater....
In the power plant shown in Figure P2 below, steam leaves the boiler at p3 P2...
In the power plant shown in Figure P2 below, steam leaves the boiler at p3 P2 6 MPa and ??-320°C, flows through the throttling valve, which drops the pressure to p4-4 MPa. then enters the turbine in which it expands to the condenser pressure of p5-10 kPa. The water then leaves the condenser at p 10 kPa and T1-40°C. The net power output is 450 MW. The turbine isentropic efficiency is 85% and that of the pump is 78%. Determine:...
A power plant operates on a regenerative vapor power cycle with one open feedwater heater. Steam...
A power plant operates on a regenerative vapor power cycle with one open feedwater heater. Steam enters the first turbine stage at 12 MPa, 560°C and expands to 1 MPa, where some of the steam is extracted and diverted to the open feedwater heater operating at 1 MPa. The remaining steam expands through the second turbine stage to the condenser pressure of 6 kPa. Saturated liquid exits the open feedwater heater at 1 MPa. The net power output for the...
A power plant operates on a regenerative vapor power cycle with one open feedwater heater. Steam...
A power plant operates on a regenerative vapor power cycle with one open feedwater heater. Steam enters the first turbine stage at 12 MPa, 560°C and expands to 1 MPa, where some of the steam is extracted and diverted to the open feedwater heater operating at 1 MPa. The remaining steam expands through the second turbine stage to the condenser pressure of 28 kPa. Saturated liquid exits the open feedwater heater at 1 MPa. The net power output for the...
In Geothermal-steam power cycle, the source of heat is the hot water from well. The heat...
In Geothermal-steam power cycle, the source of heat is the hot
water from well. The heat exchanger receive hot water at Tg1= 105
oC and the water leaves at 40 oC as shown in Figure 3. Steam exits
the boiler at 40 bar, 300 oC, and it exits the turbine at 1 bar.
Saturated liquid water exits the condenser at 1 bar. The plant
operate to generate 20 MW electric power with generator efficiency
of 0.95. The isentropic efficiency of...
A cogeneration plant is similar to a power plant, but some of the thermal energy in the working fluid is used for process heat
A cogeneration plant is similar to a power plant, but some of the thermal energy in the working fluid is used for process heat (for example heating buildings, steel making, or oil refining). An ideal reheat Rankine cycle with regeneration is modified to a cogeneration plant by adding a process heater as shown in the figure below. The process heater acts as a heat removal step where the enthalpy of the steam is reduced by the heat output (qprocess=h7-h3). The...
C and D please. AGL Energy is expanding the capacity of the Liddell Power Station. The plan is to commission a steam tu...
C and D please.
AGL Energy is expanding the capacity of the Liddell Power Station. The plan is to commission a steam turbine power plant that operates on a regenerative Rankine cycle and has a net power output of 150 MW where steam enters the turbine at 10 MPa and 500°C, and the condenser at 10 kPa. The isentropic efficiency of the turbine is 80 percent, and that of the both pump is 95 percent. Steam is extracted from the...
1. An industrial plant needs 20,000 lbm of saturated steam at 280°F per hour for heating...
1. An industrial plant needs 20,000 lbm of saturated steam at 280°F per hour for heating purposes and ten MW of electrical power. A small turbine system is to be designed to handle both of these needs. Steam is supplied to a turbine at 400 psia pressure from a boiler and expanded until 280°F saturated steam is obtained whereupon the steam needed for heating is extracted. The rest of the steam is expanded in a second turbine to a condenser...
Please solve question using questions numbers not the ones in
Solution Manual
2) An ideal power plant produces steam at 3.5 MPa, 600°C in the boiler. The condenser with the capacity of 12 MW is maintained at 50°C. The first turbine section expands to 600 kPa and then flow is reheated followed by the expansion in the low pressure turbine where the state is saturated vapor. a. Find the reheat temperature. b. Find the total turbine power output and the...
In the power plant shown in Figure P2 below, steam leaves the boiler at p3 P2 6 MPa and ??-320°C, flows through the throttling valve, which drops the pressure to p4-4 MPa. then enters the turbine in which it expands to the condenser pressure of p5-10 kPa. The water then leaves the condenser at p 10 kPa and T1-40°C. The net power output is 450 MW. The turbine isentropic efficiency is 85% and that of the pump is 78%. Determine:...
A power plant operates on a regenerative vapor power cycle with one open feedwater heater. Steam enters the first turbine stage at 12 MPa, 560°C and expands to 1 MPa, where some of the steam is extracted and diverted to the open feedwater heater operating at 1 MPa. The remaining steam expands through the second turbine stage to the condenser pressure of 6 kPa. Saturated liquid exits the open feedwater heater at 1 MPa. The net power output for the...
In Geothermal-steam power cycle, the source of heat is the hot
water from well. The heat exchanger receive hot water at Tg1= 105
oC and the water leaves at 40 oC as shown in Figure 3. Steam exits
the boiler at 40 bar, 300 oC, and it exits the turbine at 1 bar.
Saturated liquid water exits the condenser at 1 bar. The plant
operate to generate 20 MW electric power with generator efficiency
of 0.95. The isentropic efficiency of...
C and D please.
AGL Energy is expanding the capacity of the Liddell Power Station. The plan is to commission a steam turbine power plant that operates on a regenerative Rankine cycle and has a net power output of 150 MW where steam enters the turbine at 10 MPa and 500°C, and the condenser at 10 kPa. The isentropic efficiency of the turbine is 80 percent, and that of the both pump is 95 percent. Steam is extracted from the...
1. An industrial plant needs 20,000 lbm of saturated steam at 280°F per hour for heating purposes and ten MW of electrical power. A small turbine system is to be designed to handle both of these needs. Steam is supplied to a turbine at 400 psia pressure from a boiler and expanded until 280°F saturated steam is obtained whereupon the steam needed for heating is extracted. The rest of the steam is expanded in a second turbine to a condenser...
Most questions answered within 3 hours.
-
use
hardy wineberg equation to find equilbrium.
AA 150. Aa 120. aa 90
asked 16 minutes ago -
Why don't law enforcement or prosecutors always investigate
crimes as hate crimes
asked 7 minutes ago -
Describe how Rio Tinto is a main competitor of BHP.
asked 10 minutes ago -
Two children (m = 31.0 kg each) stand opposite each other on the
edge of a...
asked 17 minutes ago -
A 2180-kg car is slowed down uniformly from 24.6 m/s to 5.2 m/s
in 3.32 s....
asked 43 minutes ago -
Jesse’s Machining is looking to buy a new machine to handle a
new four-year contract for...
asked 49 minutes ago -
5. A slide mount of a fungal specimen is prepared. A slide and
coverslip are flame-sterilized....
asked 51 minutes ago -
A parallel plate capacitor has a charge Q, plates of area A and
separation d, where...
asked 54 minutes ago -
This question goes along with my test results for a psychology
seminar. The results were the...
asked 55 minutes ago -
A calorimeter contains 35.0 mL of water at 13.0 ∘C . When 1.40 g
of X...
asked 1 hour ago -
[The following information applies to the questions
displayed below.]
Arndt, Inc. reported the following for 2021...
asked 1 hour ago -
Equivalent Units of Conversion Costs
The Rolling Department of Kraus Steel Company had 2,370 tons in...
asked 1 hour ago