em V 5 A 4Ω Using KVL, KCL, and Ohm's Law, Determine Vx and ix. 60...
a) The value of Ix= 3A, use KCL to determine the values of IA and IB. b) Use KVL or knowledge of voltage across parallel elements to determine the voltage across Ra. Then use Ohm's Law to determine the value of RA. c) Use KVL to determine the value of the independent voltage source, Vx. d) Fill out a power table and determine the value of the power absorbed by each element. e) Add the absorbed powers and verify that...
Is1 15 mA R. 1ΚΩ In the circuit shown, use KCL, KVL, and Ohm's Law to find the two resistor currents R1 R2 K. S2 25 V 0.5 kΩ 5 mA iR2 1R2 =
please, only use KCL, KVL, ohm's law, and/or nodal analysis.
7 u e
3-3: Use KVL/KCL and Ohm's Law as needed to find the values of v1 and v2. You must show separate KCL and KVL equations, no credit will be given if other methods such as nodal analysis are used. 80 80 Ω υ,Σ 120 Ω V140 6 A
4. Find in the circuit below if V = 4/0° VAMS- Note: use KVL, KCL, and Ohm's Law to solve. {0.52 WM 5. Determine the average power and complex power supplied by the source, V , in problem 4.
Pre-lab EM-5 Ohm's Law and Kirchhoff's Rules Ohm's Law The resistance R of a device can be determined by either directly measuring the resistance using an ohmmeter, or by measuring the current I through it and the voltage Vacross it, and then calculating R using Ohm's Law V R= (1) If the voltage across a resistor is 10V, and the current passing through it is 2.5 mA. of the resistor? What is the resistance R= Ω. Kirchhoffs Loop Rule Around...
(b) Find the total current delivered by the source using Ohm's law in the circuit in (a) if the applied voltage V 100 V rms and phase angle 0o. (Hint: use ohms laand complex calculation.) (5 points) aw I= R1 4Ω Xc1 10 ohm XL1 6 ohm
Determine Vx in the circuit of Figure 3. 4Ω 2/ 2Ω 6Ω ΙΩ +8 V 1Ω Figure 3
1. SUPERPOSITION (25 POINTS) 1Ω + 2 v, + 1V A 2A 222 w + 12 1.1 By using KCL, KVL, & Ohm's Law, determine the value of the voltage v. (10 points) 1.2 By using Superposition, determine the value of the voltage v (15 points)
find volatges and currents across all resistors using ohms law
, kcl, and kvl.
Rl R2 1.5 kJ2 R3 는 2kl2 Rt J1 12 inl voltage anol current throush all resistors R1, R2, R3, R4 in Voltage ah no