Your answer is partially correct. Try again. A motor supplies 178 ho at 540 rpm to...

Question

Question

Answer 1

Answer #1

13421.76 lb ,in -8D A C in 2.6 2 cle f うdi-d222-62-in 不dc0 CO t. 13421-7612y 32 2077454 xAS2一十134267( x14-4 3 2

Answer 2

Similar Homework Help Questions

The motor shown in the figure supplies 14.0 kW at 1880 rpm at A. Shafts (1)...

The motor shown in the figure supplies 14.0 kW at 1880 rpm at A. Shafts (1) and (2) are each solid 26 mm diameter shafts. Shaft (1) is made of an aluminum alloy [?G=26??GPa], and shaft (2) is made of bronze [?G=45??GPa]. The shaft lengths are L1=3.1m and L2=2.7m, respectively. Gear B has 55 teeth, and gear C has 99 teeth. The bearings shown permit free rotation of the shafts. Determine: (a) the maximum shear stress produced in shafts (1)...
sel engine for a commercial boat operates at 200 rpm and delivers 800 hp through a...

sel engine for a commercial boat operates at 200 rpm and delivers 800 hp through a 1) A die with a ratio of 4 to 1 to the propeller as shown below. Because the propeller shaft gearbox ed is four times that of the crank shaft, the torque on the propeller shaft is one-fourth that spe o the crank shaft. Both the shaft from the engine to the gearbox and the propeller shaft are to be solid and made of...
Question 1 The motor shown in Fig. 1 supplies power to Gear C through solid steel...

Question 1 The motor shown in Fig. 1 supplies power to Gear C through solid steel motor shaft GF (having a diamet of 200 mm) and Gear F. The torque delivered to Gear C is 200 kNm. Gears A, B, D and E supply powers to er three machines. The torques delivered by gear A, gear B and gear E to the machines are 60 kNm, 30 kNm and 40 kNm, respectively. Shaft ABCDE is also made of steel (G...

In the mechanical system represented in Figure 2(a), a motor supplies a torque of 45 kN-m,...

In the mechanical system represented in Figure 2(a), a motor supplies a torque of 45 kN-m, and powers two machines through gears D and E. The torque delivered to gear E is 8 kN-m The two shafts are made of steel, with E200 GPa, G 80 GPa and yield strength of 300 MPa The shaft AB has an outer diameter of 150 mm and an inner diameter of 80 mm; the shaft DCE has an outer diameter of 80 mm...
Question 2: The shaft ABC shown in the figure is driven by a motor that delivers...

Question 2: The shaft ABC shown in the figure is driven by a motor that delivers 300kW at a rotational speed of 32 rev/sec. The gears at B and C take out 120k W and 180kW respectively. diameter of the shaft if the allowable shear stress is 50MPa, the allowable angle of twist between points A and C is 4° and G- 75GPa. of the two parts of the shaft are Li = 1.5m and L,-0.9m. Determine the required Motor...