Part A. Briefly answer the following questions (30 PTs): 1. What is the major difference between...
Two large parallel plates with surface conditions approximating those of a blackbody are maintained at 800°C and 100°C, respectively. Determine the rate of heal transfer by radiation between the plates in Wim and the radiative heat transfer coefficient in W/m K ) 12 Write down the one-dimensional sent heal conduction equation for a plane wall with constant thermal conductivity and heat generation in its simplest form, and indicate what each variable represents 13 Write down the one-dimensional transient heat conduction...
1. (25 pts) Answer the following conceptual questions. Write down full explanations and derivations on a clean piece of paper. h, 8 h(x) 80) 1 a. The effect of transition from laminar to turbulent flow on local velocity boundary layer thickness, 8(x) and local convection coefficient, h(x) for steady flow over an isothermal plate is illustrated in the following figure. Why does the convection coefficient decrease with x in the laminar region? How would the local heat flux change with...
Ω testinal i Answer the following What is the difference between PD and PID respect to the effect of control parameter? a) controller Explain with the b) For the experiment, in which we did thc Pl control ofIIVAC with cifieations, why was the response feter Explain? response beter than the oa-off of the HVAC c) What is the steady state error of a PID controller? Scanned by CamScanner d) Whats is the transfer function of HVAC? devices or e) After...
1.I need short answer of the questions? 1. What is the major difference between gram postive and negetive bacteria. 2. What are endospores? 3. what are the name of 4 phase of bacterial growth? 4. name three ways DNA can be transfered from one bacteria to other. 5. What is LPS ( lipopoly saccharide) which types of bacteria have them and where? What is Capsule? 6. what is Fimbrae? What is Pilli?
1. What is the purpose of a constant volume gas thermometer. How does it work? 2. What is the difference, if any, between a isothermal and adiabatic thermodynamic process. Draw them on a pV diagram. 3. Does the First Law of Thermodynamics apply to solids and liquids? Why or why not. 4. What is the most important heat transfer mechanism on earth where there is an atmosphere? Explain how this can cool a nuclear or coal fired power plant, and...
summatize the following info and break them into differeng key points. write them in yojr own words apartus 6.1 Introduction—The design of a successful hot box appa- ratus is influenced by many factors. Before beginning the design of an apparatus meeting this standard, the designer shall review the discussion on the limitations and accuracy, Section 13, discussions of the energy flows in a hot box, Annex A2, the metering box wall loss flow, Annex A3, and flanking loss, Annex...
summarizr the followung info and write them in your own words and break them into different key points. 6.5 Metering Chamber: 6.5.1 The minimum size of the metering box is governed by the metering area required to obtain a representative test area for the specimen (see 7.2) and for maintenance of reasonable test accuracy. For example, for specimens incorporating air spaces or stud spaces, the metering area shall span an integral number of spaces (see 5.5). The depth of...
Chapter overview 1. Reasons for international trade Resources reasons Economic reasons Other reasons 2. Difference between international trade and domestic trade More complex context More difficult and risky Higher management skills required 3. Basic concept s relating to international trade Visible trade & invisible trade Favorable trade & unfavorable trade General trade system & special trade system Volume of international trade & quantum of international trade Commodity composition of international trade Geographical composition of international trade Degree / ratio of...