Using Fluidsim, please design a pneumatic circuit so that a large double-acting piston is used to...
Objectivel Design a simple pneumatic circuit design to activate a double-acting cylinder. Problems A roller track is to be swiveled by means of a double acting cylinder. The signals to extend and to retract are given from separate push buttons. The cylinder is to remain in position indicated by the last signal until an opposing signal is given. The retracting speed must be adjustable. [Main components 1. 2. 3. Double-acting cylinder 5/2 directional control valve with pneumatic actuated on both...
Design a relay-schematic ladder diagram to perform the following steps: Using FLUIDSIM A double-acting cylinder is initially at fully-retract position. An electrical limit switch placed at the fully-retracted position will send a signal to the device described in Step 2. A double-solenoid 5/2 valve is placed right under the cylinder to control its motions. If an NO push button is pressed and released immediately, the double-acting cylinder will be moving forward with an adjustable speed When the cylinder is at...
design using FLUIDSIM Please solve as soon as possible ***The solution for PNEUMATICS 2. A double acting cylinder is continuously punching a hole into a donut by pressing a START pushbutton. The workpiece is detected by a capacitive sensor and cylinder positions are sensed by magnetic reed sensors. The cylinder will extend very fast once a 6bar pressure is detected. The cylinder will go back to its initial position after reaching a fully extended position. Retraction speed is adjustable. Another...