Peak to peak voltage of a sine wave = The voltage difference between positive peak and the negative peak of the wave.
Here in the picture,
A is the Time axis.
E is the time period of positive half of the wave.
C is the amplitude of positive half of the wave.
D is the amplitude of negative half of the wave.
B is the difference between positive peak to negative peak of the wave. So it is the peak to peak voltage.
ko A- B E- Figure 11-1 Given the sine wave in Figure 11-1, identify the peak-to-peak...
2 For the sine wave below in Figure 1, dewesise the peak, peak to peak, rms and Figure I 3. A simusoidal voltage is applied to the resistive cireuit in Figure 2 as below. Determine () i (d) Ipo (e) at the positive peak ()b)1 Figure 2 Determine the frequency and time period for the angular velocity 1256 rad/s? Sine wave A has a positive going zero crossing สเ 0°. Sine wave B has a positive zero crossing at 20P....
Determine the following about the sine wave ac voltage shown: a. Amplitude and peak-to-peak voltage. b. Period, frequency and angular frequency (o). c. Write the sine wave equation for the ac voltage. d. Calculate the voltage at 2.5us. e. Calculate the voltage at 2ms. volts (v) 7 2 14 0 8 10 12 time (us
(5pts) 11. A 0.5V peak-to-peak 1kHz sine wave with a 100mV DC offset is provided as the input into a non- inverting operational amplifier with a gain of 20. If the output of the op-amp is read using an oscilloscope with AC coupling, then the value is close to a. 2V DC b. 2V peak-to-peak 1kHz sine wave c. 10V peak-to-peak 1kHz sine wave with 2V DC offset d. 10V peak-to-peak 1kHz sine wave only (5pts) 12. Which of the...
a. A 1V peak to peak sine wave with a frequency of 1 kHz is applied across a 5 kΩ resistor. Find an expression for the current through the resistor as a function of time. b. The same input voltage is applied across a single 2 µF capacitor, what is the current through the capacitor as a function of time? c. The frequency of the sine wave is now increased to 5 kHz. How does this affect the current in...
A half-wave diode rectifier circuit is driven by a 60Hz sine wave with a peak value of 19V. If the load resistance this circuit drives is 4.3kΩ and the ripple voltage at the output is 0.43 Vpeak-to-peak, then what is the peak current in the diode in milliamps? Answer: Check The diode circuit shown is a Select one: O a. Voltage doubler circuit O b. DC restorer circuit c. Limiter circuit O d. Peak detector circuit O e. None of...
8. vin ?s a 3V peak-to-peak 1 Hz sine wave with +2v dc offset. Find vout pp peak-to-peak voltage Rc 3k o Vout in lk 20 points
Given taple 3,please solve for part(d)-part(f) hange the mode on the signal generator to sine-wave, with a peak-to-peak amplitude of eak-to-peak amplitude of the voltage across the capacitor for various frequencies (100, 4 500, 2000, and 5000 Hz), and complete Table 3, (0.4%) Table 3 Frequency (in Hertz) 100 400 800 1000 1500 2000 5000 Vc (peak-to-peak) ange the mode on the signal generator to sine-wave, with a peak-to-peak amplitude of 2V. Measure the 1500, 2000, and 5000 Hz), and...
An AC sine wave voltage has a peak amplitude of 170 V. What is the rms value?
given table 4 and nowing tau was measured(0.15ms) please solve for part d,e,f Thanks hange the mode on the signal generator to sine-wave, with a peak-to-peak amplitude of 2 eak-to-peak amplitude of the voltage across the resistor for various frequencies (100, 400 500, 2000, and 5000 Hz), and complete Table 4, (04%) Table 4 Frequency (in Hertz) 100 400 800 1000 1500 2000 50 VR (peak-to-peak) (d) From Table 4, sketch the frequency response curve (lv versus frequency) of the...
A 1V peak input sine wave is amplified to 9V peak across a 1kW load. The input current of the amplifier is a sine wave of 0.1 mA peak. The amplifier draws 9.5 mA from each of its +/- 10 V DC power supplies. Find h, the efficiency of the amplifier.