A student determines that 37.2mL of 0.1543 M NaOH is required to titrate 25.0mL HCl. What...
- A student determines that 37.2mL of 0.1543 M NaOH is required to titrate 25.0mL HCl. What is the concentration of the acid?
- The student consistently titrates to a dark pink endpoint. Will the reported value for the concentration of acid be too high, too low, or unaffected by the dark pink endpoint?
- Another student performs the titration and does not notice the air bubbles trapped in the tip of the buret. How will the reported value for the concentration of the acid be affected?
I just need the answers with some explanations not a whole lot of information.
Homework Answers
Add Answer to:
A student determines that 37.2mL of 0.1543 M NaOH is
required to titrate 25.0mL HCl. What...
ost-Lab Questions 1. A student determines that 37.2 mL of 0.1543 M NaOH is required to...
ost-Lab Questions 1. A student determines that 37.2 mL of 0.1543 M NaOH is required to titrate 25.0 mL HCl. What is the concentration of the acid? 2. The student consistently titrates to a dark pink endpoint. Will the reported value for the concentration of the acid be too high, too low, or unaffected by the dark pink endpoint? 3. Another student performs the titration and does not notice the air bubbles trapped in the tip of the buret. How...
chem 110 experiment 12 tritation vinegar need help fast please!!! The density of vinegar is 1.01...
chem 110 experiment 12 tritation vinegar
need help fast please!!!
The density of vinegar is 1.01 g/mL. How would this information
affect your experimental results.
2. Weak acids, such as acetic acid, typically have an odor, whereas
strong acids often do not. Explain this is so
EXPERIMENT # 1 2 ACETIC ACID CONTENT OF VINEGAR Objectives Use chemical pll indicators to find endpoints of acid base titrations Use the burets to undertake chemical titrations PreLab questions i. Lab. If commercial...
1.If 23 ml of 2.0 M NaOH was required to neutralize 10.0 ml of HCl, what...
1.If 23 ml of 2.0 M NaOH was required to neutralize 10.0 ml of HCl, what is the molarity of the HCl? 2.What volume (in L) of a 2.08 M NaOH solution is required to neutralize 0.53 mol of HCl? *Remember to report your answer using the proper significant digits. 4.A student has finished the titration of a sample of HBr of unknown concentration with 0.2 M NaOH. The student notices small drops of unreacted NaOH were left on the...
3. If 15.0 mL of 0.125 M phosphoric acid is titrated with 0.100 M NaOH, what...
3. If 15.0 mL of 0.125 M phosphoric acid is titrated with 0.100 M NaOH, what volume of the titrant (in mL) must be added to completely neutralize the acid? Show all of your work (including the chemical equation). (1 point) Post-lab Questions: Experiment #9: Acid-Base Titrations Student Learning Objectives : Students will gain practice with the accurate preparation of solutions. Students will perform acid-base titrations and prepare titration curves. Students will identify strong and weak acids by the shapes...
i need all answers Data Table 1: Titration of Vinegar with Sodium Hydroxide Vinegar Sample 1...
i
need all answers
Data Table 1: Titration of Vinegar with Sodium Hydroxide Vinegar Sample 1 Vinegar Sample 2 Vinegar Sample 3 Mass of Vinegar (6) Volume of Vinegar (ml) Density - 1.005 g/ml Initial NaOH volume in syringe (ml) Final NaOH volume in syringe (ml) Volume of NaOH delivered (mL) Volume of NaOH delivered (L) Molarity of NaOH Moles of NaOH delivered Reaction of NaOH with Acetic Acid Moles of Acetic Acid in vinegar sample Molar mass of Acetic...
I need it right now, please help me?? PROCEDURE PART I: DILUTING THE VINEGAR SOLUTION The...
I
need it right now, please help me??
PROCEDURE PART I: DILUTING THE VINEGAR SOLUTION The vinegar solution must be diluted by a factor of 5 to be suitable for titration. 1. Obtain - 20 ml of the stock vinegar solution from the fume hood. 2. Using the 10-ml. pipet, pipet" 10 mL of the stock solution to a 50-ml volumetric flask. 3. Fill the volumetric flask to the calibration line with distilled water. Be sure not to go over...
titration lab report additional images of lab report QUESTIONS 1. A student masse 0878 of an...
titration lab report
additional images of lab report
QUESTIONS 1. A student masse 0878 of an unknown acid follows the titration procedure required to reach the endpoint on a 10.0 ml Calculate the molar mass of the acid. masses out 0.878 of die in 100 ml volume and titration procedure of Partsherds th the average volume of Non to reach the endpoint on 100 ml aliquot of the acid solution is 18.3 m . 2. In the vinegar titrations (Part...
1. What is the definition of an 'equivalence point' in an acid/base titration? (1 point) 2....
1. What is the definition of an 'equivalence point' in an acid/base titration? (1 point) 2. In part one of the experiment, you will prepare the acid solutions being titrated from a stock solution. Describe how you will accurately prepare 10.00 mL of 0.100 M HCl solution using a 1.00 M HCl stock solution. In your response to this question, be very specific about the quantities of stock solution and deionized water to be used in the dilution and the...
I don't understand what calculations I would have made to create the buffer solution from Part...
I don't understand what calculations I would have made to create
the buffer solution from Part D of the lab. I understood the
procedures I took to create the solution but when the report asks
to show the calculations used to prepare the buffer solution I am
not sure other than mixing the volumes indicated in the procedures
section.
Thank you
pH of Butter Assigned by Instructor 5.12. Measured pH of Assigned B r .9 (Read the procedural Show the...
For the preparation and standardization of NaOH with KHP im supposed to boil water for 1hr and 30 min to remove CO2
For the preparation and standardization of NaOH with KHP im supposed to boil water for 1hr and 30 min to remove CO2....the problem is that if I don't boil it for that long and (30 min) b/c of not enough time but I put the water I boiled for 1/2 hr aproximately into a NaOH bottle with a CO2 absorber and stored it there for a few days. I would assume that I would have to boil the water again...but...
ost-Lab Questions 1. A student determines that 37.2 mL of 0.1543 M NaOH is required to titrate 25.0 mL HCl. What is the concentration of the acid? 2. The student consistently titrates to a dark pink endpoint. Will the reported value for the concentration of the acid be too high, too low, or unaffected by the dark pink endpoint? 3. Another student performs the titration and does not notice the air bubbles trapped in the tip of the buret. How...
chem 110 experiment 12 tritation vinegar
need help fast please!!!
The density of vinegar is 1.01 g/mL. How would this information
affect your experimental results.
2. Weak acids, such as acetic acid, typically have an odor, whereas
strong acids often do not. Explain this is so
EXPERIMENT # 1 2 ACETIC ACID CONTENT OF VINEGAR Objectives Use chemical pll indicators to find endpoints of acid base titrations Use the burets to undertake chemical titrations PreLab questions i. Lab. If commercial...
3. If 15.0 mL of 0.125 M phosphoric acid is titrated with 0.100 M NaOH, what volume of the titrant (in mL) must be added to completely neutralize the acid? Show all of your work (including the chemical equation). (1 point) Post-lab Questions: Experiment #9: Acid-Base Titrations Student Learning Objectives : Students will gain practice with the accurate preparation of solutions. Students will perform acid-base titrations and prepare titration curves. Students will identify strong and weak acids by the shapes...
i
need all answers
Data Table 1: Titration of Vinegar with Sodium Hydroxide Vinegar Sample 1 Vinegar Sample 2 Vinegar Sample 3 Mass of Vinegar (6) Volume of Vinegar (ml) Density - 1.005 g/ml Initial NaOH volume in syringe (ml) Final NaOH volume in syringe (ml) Volume of NaOH delivered (mL) Volume of NaOH delivered (L) Molarity of NaOH Moles of NaOH delivered Reaction of NaOH with Acetic Acid Moles of Acetic Acid in vinegar sample Molar mass of Acetic...
I
need it right now, please help me??
PROCEDURE PART I: DILUTING THE VINEGAR SOLUTION The vinegar solution must be diluted by a factor of 5 to be suitable for titration. 1. Obtain - 20 ml of the stock vinegar solution from the fume hood. 2. Using the 10-ml. pipet, pipet" 10 mL of the stock solution to a 50-ml volumetric flask. 3. Fill the volumetric flask to the calibration line with distilled water. Be sure not to go over...
titration lab report
additional images of lab report
QUESTIONS 1. A student masse 0878 of an unknown acid follows the titration procedure required to reach the endpoint on a 10.0 ml Calculate the molar mass of the acid. masses out 0.878 of die in 100 ml volume and titration procedure of Partsherds th the average volume of Non to reach the endpoint on 100 ml aliquot of the acid solution is 18.3 m . 2. In the vinegar titrations (Part...
1. What is the definition of an 'equivalence point' in an acid/base titration? (1 point) 2. In part one of the experiment, you will prepare the acid solutions being titrated from a stock solution. Describe how you will accurately prepare 10.00 mL of 0.100 M HCl solution using a 1.00 M HCl stock solution. In your response to this question, be very specific about the quantities of stock solution and deionized water to be used in the dilution and the...
I don't understand what calculations I would have made to create
the buffer solution from Part D of the lab. I understood the
procedures I took to create the solution but when the report asks
to show the calculations used to prepare the buffer solution I am
not sure other than mixing the volumes indicated in the procedures
section.
Thank you
pH of Butter Assigned by Instructor 5.12. Measured pH of Assigned B r .9 (Read the procedural Show the...
Most questions answered within 3 hours.
-
R2.84: There are 2 defective products in a production lot of 10.
An inspector randomly selected...
asked 55 minutes ago -
Consider the following equilibrium system: COCl2(g) CO(g) +
Cl2(g) A 10.00 L evacuated flask is filled...
asked 1 hour ago -
1) What are the two distinct steps that one needs to perform
when developing a data...
asked 1 hour ago -
2) Write a C++ program that uses a class called “Degree” to
obtain the trigonometric
values...
asked 2 hours ago -
1. In eukaryotic cells the genomes of
&
asked 2 hours ago -
The standard enthalpy of propanol (C3H7OH) is -303.0 kJ/mol.
Compute both of the
gross and net...
asked 2 hours ago -
Why PWM using H-bridge for control motor speed is more power
effiecient than the linear amplifier...
asked 2 hours ago -
In 1999, Carly Fiorina famously said,"I hope that we are at a
point that everyone is...
asked 2 hours ago -
Individuals in a species of moth vary in wing color from white to
black, but all...
asked 3 hours ago -
The following standards for variable manufacturing overhead have
been established for a company that makes only...
asked 3 hours ago -
The United States government wanted to determine what proportion
of Americans approve of the current president,...
asked 3 hours ago -
2-N stone is dropped from the top of a cliff. The stone hits the
ground 3...
asked 3 hours ago