D Question 4 The capillary column is usually how long? 30 millimeters 0.3 millimeters 30 meters

Question

Question

Answer 1

Answer #1

Capillary column is usually long

Answer = 30 meter

Generly packed column have length 1.5 to 10 meter and diameter 2-4 mm

And capillary column have length 30 meter and diameter few tenth of mm

Answer 2

Similar Homework Help Questions

A beam of aluminum is 5.000 meters long at 20°C. By how many millimeters does its...

A beam of aluminum is 5.000 meters long at 20°C. By how many millimeters does its length increase if the temperature is raised to 50°C? If the cross-sectional area of the beam is 10 cm by 20 cm, by how many cm3 does its volume increase when the temperature is raised from 20°C to 50C°?
[30 Marks] Q 1(b) When comparing column performance between a capillary and a packed GC column,...

[30 Marks] Q 1(b) When comparing column performance between a capillary and a packed GC column, one is struck by how similar the plate height is on the two columns. And yet as shown in Table 1, we see that we get almost 10x better resolution on the capillary column Discuss why this difference in resolution arises, in terms of the van Deemter equation Tabie 1 Comparison of packed and wall coated open tubuiar column performance Open Tubular Packed 0.73...
A steel lift column in a service station is 3.0 meters long and. has an area...

A steel lift column in a service station is 3.0 meters long and. has an area of 0.2 m2. Young’s modulus for steel is 20 x 1010 N/m2. By how much does the column shrink when a 3000 kg load is on it? A)3.1 x 10-5 m B)2.25 x 10-7 m C)3.5 x 10-6 m D)2.2 x 10-6 m

i) Explain with a diagram how blood flow through a capillary bed is regulated. (30%) (ii) What are the main pressures driving exchange of nutrients in a capillary bed (30%), how is this affected by...

i) Explain with a diagram how blood flow through a capillary bed is regulated. (30%) (ii) What are the main pressures driving exchange of nutrients in a capillary bed (30%), how is this affected by decreased plasma osmolality? (20%), how is this affected by decreased blood volume? (20%). physiology question
3 Question 4 (1 point) The longest recorded whale shark is 12.65 meters long. How many...

3 Question 4 (1 point) The longest recorded whale shark is 12.65 meters long. How many kilometers is this shark? (1 km = 1,000 m) 6 Your Answer: 9 12 Answer Question 5 (1 point) 14 15
7. The T account is usually replaced with a: a. 4-column account b. it is not...

7. The T account is usually replaced with a: a. 4-column account b. it is not replaced c. vital to IFRS accounting O d. *** to establish that the transaction was entered. QUESTION 8 8. Cash payment on a car originally purchased on account would result in: a. decrease in liability b. increase in asset c. no entry, as it cancels out. O d.credit to interest expense

Question 1 (30P): A 2 meters long rectangular rod is connected to a 3 meters long...

Question 1 (30P): A 2 meters long rectangular rod is connected to a 3 meters long circular rod. The diameter of circular rod is 6cm. The circular rod is fixed at the other end. Determine the stresses at the points A. B and C. 800 N 6 cm Z 4 10 KN
#3 4) A mild steel solid shaft 1.8 meters long and 30 mm in diameter withstands...

#3 4) A mild steel solid shaft 1.8 meters long and 30 mm in diameter withstands a tor shear modulus for this steel is 7 shaft. o GPa. Determine the shear stress in the shaft and the angle of twist of the
The beam in the figure is 5 meters long and has a mass of 30 kg....

The beam in the figure is 5 meters long and has a mass of 30 kg. A crate with a mass of 50 kg hangs from the 4 meter mark. Calculate the tension in the wire using the attachment of the beam to the wall as the pivot point. 45 degrees 30 degrees

The column shown has a hollow rectangular cross-section. I-6 meters, the material is cold-drawn steel with...

The column shown has a hollow rectangular cross-section. I-6 meters, the material is cold-drawn steel with E-207 GPa, and Sy=580 MPa. Assume end condition to be C-1; Determine 1. Slendemess ratio 2. Transition Slenderness ratio D-80mm 200mm 3. Short or long column? Why? 4. Is the column safe if the axial load P shown is 1 MN? 100mm Column Cross-section For a rectangular cross-section 1 = bh 12 For a circular cross-section, I = *D* 64