Please make it an easy circuit 4. Design a synchronous counter that counts from 0 to...
Design a synchronous counter that can repeatedly counts from 14 to 2 and then returns to 14. Show the circuit. Please try to use logicly.
2. Synchronous Counters: a. Design a count up/count down counter that counts from 0 up to 4, then 4 down to 0 using D flip flop. b. Design a count up counter that counts from 0 up to 12 using JK flip flops.
Can you please help answer b)
and c) ?
Design a synchronous counter that counts through the following sequence using J-K flip flop. 7+9+1+3+8+0+5+4+6+2+10+12+11+1413 Step of programming: a) Build an Excitation Table b) Create an expression of the flip-flop c) Sketch the circuit based on expression
9) Using JK flip flops and in the space below, design a synchronous counter that counts up from 0 to 5 and recycles to 0. (Positive edge triggered, PRE & CLR active low) Show all connections except the power and ground inputs to the flip flops.
Design an asynchronous counter that can repeatedly counts from 7 to 3 and then returns to 7. Show the circuit. Make sure you count from 7 to 3 and not 3 to 7. And implement this using logicly if possible and explain every step. Don't copy from others, I'll rate. Thanks.
03. (8 pts) Synchronous two-digit BCD counter, with the two four-bit up-counters with synchronous loading function as shown below. 1) Draw the circuit that counts from 0 to 36.
03. (8 pts) Synchronous two-digit BCD counter, with the two four-bit up-counters with synchronous loading function as shown below. 1) Draw the circuit that counts from 0 to 36.
Design a MOD 4 Synchronous Counter to count in a 2753,2753, etc. when x=0. Draw Circuit diagram as well.
pleas help fast
Problem #3 (30 points) a. Design an Asynchronous Modulo 9 counter (a counter that counts from 0 to 8) using JK Flip-Flops. Sketch the circuit only. (15 pts) b. Design a Synchronous Modulo 9 counter (a counter that counts from 0 to 8) using JK Flip- Flops. Sketch the circuit only. (15 pts)
Design a counter that counts from 0-5. Use negative-edge JK FFs. Draw the circuit showing the connections between the FFs..
2. Design of one Synchronous counter to count from 0 to 10, in which the circuit displays LEDs with the diameter of 5 mm, each Q output is connected to three 5 mm LEDs in parallel a. Design the whole circuit using Proteus software b. Calculate and choose devices (R,L,C,BJT and others) using laws, theorems to simplify expressions and to find values of the devices for the circuit so that it can run well c. Explain functions of the devices...