7. (18 pt) The member is composed of an aluminum shaft with a brass core. The...
In the assembly below, rod AB is made of C83400-red-brass and BC of 2014-T6 aluminum at T1= 25.48°F there is no load in the members. Calculate the average normal stress in each member when the resulting force acting on the assembly is F = 14,495.94 lb due to an increase in temperature, given the cross-section of each rod is 4.41 in?. Give your answer in ksi and 2 decimal places. A B с 3 ft 2 ft
ר The shaft shown consists of asteeltubeT bonded to a brass core (2)The shearmodulusofsteeTs 11,400 ksi and the elastic modulus of brass is 5,200 ksi. A torque of 250 lb-ft is applied at A. a) Write the equilibrium and compatibility equation(s) needed to solve the problem along with supporting sketches Calculate the internal torques of each member in lb-in. Calculate the maximum shear stress in the system in psi. You will have to look at each individual piece of the...
The cantilevered beam shown below is a sandwich beam with a plastic core and aluminum alloy faces. The member is subjected to a concentrated load at the free end. The plastic core (240mm x 200 m m in cross section) has an elastic modulus of 100 GPa and allowable normal stress of 220 MPa, while the 6 mm thick aluminum face plates have an elastic modulus of 75 GPa and allowable normal stress of 260 MPa. Question I: 118 marks]...
The flanged member shown below is subjected to an internal axial force of P = 6500 lb, an internal shear force of V = 4500 lb, and an internal bending moment of M = 19200 lb-ft, acting in the directions shown. d M Iw y HI a y Ilk thu The dimensions of the cross section are: bf = 8.0 in. tp = 0.61 in. d = 11.0 in. tw = 0.38 in. The cross-sectional area of the flanged shape...
Learning Goal: To determine the angle of twist for a circular shaft that is composed of varying cross sections and that is subjected to a given power and frequency load. As shown, a shaft is composed of five cylindrical sections. A motor is attached at Fand supplies the shaft with P = 235.0 hp at a speed of w = 1800 rpm. This power is transferred through the shaft without any loss and is completely removed by the pulley at...
please help ASAP
1.5-7 A hollow, brass circular pipe ABC (oce figure supports a load P, 118 kN acting at the top A second load P -98 kN is uaiformly distributed around the cap plate at B. The diameters and thicknesses of the upper and lower parts of the pipe are 31 mm ,,-12 mm, dae" 57 mm, and tac· 9 mm, respectively. The modulus of clasticity is 96 GPa. When both loads are fully applied, the wall thickness of...
A 3 m rigid bar AB is supported with a vertical translational spring at A and a pin at B The bar is subjected to a linearly varying distributed load with maximum intensity g Calculate the vertical deformation of the spring if the spring constant is 700 kN/m. (ans: 21.43 mm) 2. A steel cable with a nominal diameter of 25 mm is used in a construction yard to lift a bridge section weighing 38 kN. The cable has an...