1)
Problem 1 Many applications require us to know the temperature distribution in an object. For example,...
Anyone able to help with this 3-D plotting on Matlab Question 1: Three edges of a rectangular plate (a 5 m, b 4 m) are kept at a temperature of O C and one side is kept at a temperature T 80 C, as shown in the figure, on bottom-left. Determine and plot the following temperature distribution Tx,y) in the plate sin ((2n-1)쯤) sinh ((2n-1) 同 (2n-1)sinh((2n-1) TEY 471 7(x, y) = Heat conduction through a square plate a) Create...
Question 1 A turning operation is carried out on aluminum. Based on the specific energy values in Table 20.2, determine material removal rate and cutting power in the operation under the following sets of cutting conditions: (a) Cutting speed 5.6 m/s, feed 0.25 mm/rev, and depth of cut 2.0 mm; and (b) cutting speed- 1.3 m/s, feed 0.75 mm/rev, and depth 4.0 mm. Question 2 Consider a turning operation performed on steel whose hardness 225 HB at a cutting speed...
summatize the following info and break them into differeng key points. write them in yojr own words apartus 6.1 Introduction—The design of a successful hot box appa- ratus is influenced by many factors. Before beginning the design of an apparatus meeting this standard, the designer shall review the discussion on the limitations and accuracy, Section 13, discussions of the energy flows in a hot box, Annex A2, the metering box wall loss flow, Annex A3, and flanking loss, Annex...
summarizr the followung info and write them in your own words and break them into different key points. 6.5 Metering Chamber: 6.5.1 The minimum size of the metering box is governed by the metering area required to obtain a representative test area for the specimen (see 7.2) and for maintenance of reasonable test accuracy. For example, for specimens incorporating air spaces or stud spaces, the metering area shall span an integral number of spaces (see 5.5). The depth of...