Question

Question 1 1.1 If the velocity distribution of a fluid flowing over a 1m² flat plate is given by u=l+ y + y, find the m. Assu

please help

0 0
Add a comment Improve this question Transcribed image text
Answer #1

o u=1492+1 Eau du dy du O+29+1 -2771 dy fa = 2XA A.2142 F = M(24+1) = 6x10 (25+1 fa :0006(24+1) Newton 2 u=2x24292 vane_uy 23 VX Vzo for Ire-tational flow And XV to for Rotational frow a Da Ito 3 + 2 x2 on z Rea 으 Puertia force riscons force fv Res

Add a comment
Know the answer?
Add Answer to:
please help Question 1 1.1 If the velocity distribution of a fluid flowing over a 1m²...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions
  • The drag force Fp on a smooth sphere falling in water depends on the sphere speed...

    The drag force Fp on a smooth sphere falling in water depends on the sphere speed V, the sphere density P. the density p and dynamic viscosity of water, the sphere diameter Dand the gravitational acceleration g. Using dimensional analysis with p. V and D as repeating variables, determine suitable dimensionless groups to obtain a reneral relationship between the drag force and the other variables. If the same sphere were to fall through air, determine the ratio of the drag...

  • could you please make clear answer? 5. Flow over a Bod;y (a) The drag coefficient for...

    could you please make clear answer? 5. Flow over a Bod;y (a) The drag coefficient for a smooth sphere is shown in the figure below. Determine the speed at the critical Re for a 42 mm diameter sphere in air. (This is a golf ball sized object.) You may assume air at 60°F. 0.5 0.4 0.3 0.2 0.1 4 105 Re-Du/v 103 106 107 (b) Ģolthal, "dimples" cause the drag drop to occur at a lower Reynolds number. The table...

  • A streetlight is approximated by a 50cm diameter sphere mounted on a (a) 0.10m diameter cylinder...

    A streetlight is approximated by a 50cm diameter sphere mounted on a (a) 0.10m diameter cylinder 2.5m long. Estimate, using the data below and stating any assumptions you make, the bending moment at the root of the cylinder due to aerodynamic forces with:- 2 winds of 6.3m/s and an air temperature of 15'C; (i) slightly stronger winds of 7m/s and an air temperature of 22'C (ii) Comment on your answers and what advice would you give with regards the (b)...

  • Q3. Drag measurements were taken for a 5 cm diameter sphere in water at 20°C to...

    Q3. Drag measurements were taken for a 5 cm diameter sphere in water at 20°C to predict the drag force of a 1 m diameter balloon rising in air with standard temperature and pressure. Given kinematic viscosity of water (v) = 10 X 106 m²/s and kinematic viscosity of air (v) = 1.46 X 10-5 m2/s. 1. Perform the Buckingham Pi theorem to generate a relationship for Fo as a function of the independent variables. Assume the drag Fo is...

  • Air at T=25°C and pressure P=1 bar flows over a square plate with a velocity V=1...

    Air at T=25°C and pressure P=1 bar flows over a square plate with a velocity V=1 m/s. This plate has a length L= 1 m and it is heated over its entire length; the plate temperature is constant Tp=100°C. The following data are given. For air: dynamic viscosity: mu = 1.9*10–5 kg/(m.s); density: rho = 1.05 kg/m3; conductivity k = 0.03 W/(m K); Specific heat Cp = 1.007 kJ/(kg K); Prandtl number Pr = 0.7 For laminar flow over a...

  • Water at 25°C is flowing over a long flat plate with a velocity of 8 m/s....

    Water at 25°C is flowing over a long flat plate with a velocity of 8 m/s. The density and dynamic viscosity of water at 25°C are respectively, 997 kg/m3 and 0.891 x 10- 3 kg/m s. The distance from the leading edge of the plate where the flow becomes turbulent is: 30 mm 78 mm 47 mm 45 mm 56 mm

  • 10.13. The shear stress, Tw, on a flat surface that is caused by a fluid of density p and vis- cosity u flowing over the surface at a velocity V is given by where Re,- V Re where r is the distance fr...

    10.13. The shear stress, Tw, on a flat surface that is caused by a fluid of density p and vis- cosity u flowing over the surface at a velocity V is given by where Re,- V Re where r is the distance from the upstream end of the flat surface. (a) Use the given shear stress distribution, w(x), to determine the drag force on a flat plate of width W and length L in terms of W, L, V, p,...

  • Air is flowing over a long flat plate with a velocity of 3 m/s. The density...

    Air is flowing over a long flat plate with a velocity of 3 m/s. The density is 1.127 kg/mº, and the dynamic viscosity is 1.918-10-kg/m s. The hydrodynamic boundary layer thickness at a distance 0.3 m from the leading edge is: 0 6.41 mm 52,883 mm 5.85 mm 3.22 mm None of the above

  • Please don't attempt if you can not write a MATLAB PROGRAM. I don't need numerical physics...

    Please don't attempt if you can not write a MATLAB PROGRAM. I don't need numerical physics solution, I need MATLAB code. Read the question carefully 2) Falling Drops Imagine a solid sphere of diameter, d, falling through the air. After its release, the sphere accelerates until it reaches its terminal velocity. The terminal velocity is obtained when the drag force due to air friction, Fa, balances the weight of the sphere, W. The weight of the sphere is simply its...

  • Question 4 Oil flows with a velocity of 4 m/s through a 30 mm diameter tube....

    Question 4 Oil flows with a velocity of 4 m/s through a 30 mm diameter tube. A model of this system is to be developed using standard air as the model fluid. The air velocity is to be 2 m/s. What tube diameter is required for the model if dynamic similarity is to be maintained between model and prototype? Kinematic viscosity of air = 16 x 105 m2/s, Kinematic viscosity of oil 1,2 x 103 m2/s 0.45 mm 0.8 mm...

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT