R1 R2 V S R3 R4 For the circuit above, Vs 100 V, R1 220 2, R2- 330 2, R3 470 2 and R4 560 Q. Use any circuit reduction and calculation techniques learned so far to find the power absorbed by R2 PR2 1.80 W PR2 5.09 W O PR2-3.39 w PR2 2.14 W
R1 R2 R4 Is R3 Given that Vs is 18 V, Is is 6 A, R1 is 2 Ohm, R2 is 2 Ohm and R3 is 1 Ohm and R4 is 4 Ohm. Use the superposition principle to find Vo in the circuit. (Unit V) Submit Answer Tries 0/99
R1 R2 R4 Is vo R3 Vs Given that Vs is 18v,is is 6 A, Rİ İS 2 Ohm, R2 is 2 아nn and R3 is 1 Ohr" and R4 is 4 Ohm. Use the superposition, principle to find Vo in the circuit. (Unit : V) Subenit Answer Tries o/s SstentAsaer Thies 5
2. Given the circuit schematic shown and R1-110 ? R2-220 ? R3-330 ? R4-440 ? R2 2 3 R1 R3 R4 Determine the following: a. b. c. What is the equivalent resistance in the circuit? Report your answer in exact form. If 13-527 mA what is¼?? Report your answer to 4 significant figures. If 12 840 mA what is the power dissipated by R1? Report your answer to 3 significant figures. d. If the voltage source is 24 V, what...
Consider a circuit with four resistors in series. R1 R2 R3 R4 The battery has a voltage of 12 V. The resistor values are R1-800 Ω. R2-600 Ω R3-500 Q . R4-500Q Complete the following table by noting the voltage drop across each listed resistor. Resistor (Q) Voltage Drop (V) R1 00Select R3500Select ] 00 Select ] R2 R4
Problem 1. Values:R1-R2-R3-R4-1KO: Vs-10 V; Is-10 mA. Use multiple choice correct answers to: Find in the network in Fig. P1 using Thevenia's - R R1 R2 Figure P1 What circuit below is used to find RTH? B 0 A What equation below is used to find RTH? O Rth=(R1+R2+R4)/(R1+R2)*R4 ORth= (R1+R2)*R4/R1+R2+R4 ORth= (R1+R2)*R4/(R1+R2)+R4 O Rth= (R1+R2)*R4/(R1+R2+R4) Question 3 What is the value of RTH? O 1500 O 4000 O 2000 O 666.67 What superposition circuit is used to find th...
Part A. Wheatstone Bridge Circuit with a Voltage Source Vs R5 R1 R2 Vs RL R3 R4 For the circuit as shown below, given that R1: 23 Ω, R2° 13 O, R,-230, R4% 3 Ω. RS: 28 Ω , RL: 13 Ω ,Vs-90 . I. Wheatstone Bridge Circuit Analysis (a) Determining the load voltage VL-Vab for the Wheatstone bridge circuit with LTspice 1 Submit Answer Tries 0/3 (b) Determining the load current I following from a to b for the...
The circuit shown in the figure below contains three resistors (R1, R2, and R3) and three batteries (VA, Vs, and Vc). The resistor values are: R1=2 Ohms, R2=R3=6 Ohms, and the battery voltages are VA=25 V, V8=15 V, and Vc=20 V. When the circuit is connected, what will be the power dissipated by R2? Vc R1 VA t: VB R2 mm LM R3 O 1.0 W O 2.0 W O 5.0 W O 6.0 W O 7.5 W
In the circuit below, for R1= 484 Ω, R2= 242 Ω, R3= 484 Ω, R4= 242 Ω, and EMF=134 V. Find the current through R1. (in mA). Ri R3 } R2 R4
Problem 3: Determine explicitly the voltage across R3 in the circuit below R2 R1 R3 R4 (Hint: R2 and R3 are in parallel with R1... this combination is in series with R4. The total resistance can give you the total voltage drop AND then you can just analyze as a voltage divider.)