2. Given the circuit schematic shown and R1-110 ? R2-220 ? R3-330 ? R4-440 ? R2...
R1 R2 V S R3 R4 For the circuit above, Vs 100 V, R1 220 2, R2- 330 2, R3 470 2 and R4 560 Q. Use any circuit reduction and calculation techniques learned so far to find the power absorbed by R2 PR2 1.80 W PR2 5.09 W O PR2-3.39 w PR2 2.14 W
1 7 , 10A R1 > R2 > R3 ZR R5 R4 <R In the parallel circuit above, determine the current flowing through R3, i.e. 1R3. For this auto-graded question, use at least 2 significant figures with your answer in units of Amps, not mA. Also do not include units in the answer box.
R2 R1 R3 R4 E In the following circuit, R1=0.8 4 Ohm, R2-2' 4 Ohm, R3-3' 4 Ohm, R4-2° 4 Ohm, and E= 42.1 Volt. Calculate the power Loss in R2 resistor? [Picture File-Ohm-3.jpg] Your Answer: Answer
Find Power at R1, R2, and R3 Consider the circuit shown in (Figure 1). The source voltage viis 45 V. Resistance R1, R2 and R3 are 5 12,115 1 and 2512, respectively. The source current I is 20 mA. Find PR Express your answer to three significant figures and include the appropriate units. Ao aj ? Value Units PR = Submit Request Answer Part E Figure < 1 of 1 Find PR Express your answer to three significant figures and...
Consider the circuit shown where V=30 Volts and R1 = R2 = R3 = R4 = R5 = R6 = 5.2. Riş V R2 W-WWW R4 N WW-WW RO R3 A) Find the equivalent resistance of the circuit. Req Ω B) Find the current through the battery. I = A
Problem 3: Determine explicitly the voltage across R3 in the circuit below R2 R1 R3 R4 (Hint: R2 and R3 are in parallel with R1... this combination is in series with R4. The total resistance can give you the total voltage drop AND then you can just analyze as a voltage divider.)
In the circuit below. R1 = 58 Ω R2 = 200 Ω R3 = 220 Ω R4 = 22 Ω. An ohmmeter is an instrument that gives a value for the resistance seen between two terminals. What is the correct reading if the instrument is attached to the network in the figure given at points: (a) AD (b) BD (c) CD? R2 R1 50Ω 100 Ω 75 Ω R4 R3 D 25 Ω 200 Ω 2013 Paul Hummel (a) RAD...
The circuit shown in the figure below contains three resistors (R4, R2, and R3) and three batteries (VA, VB, and V). The resistor values are: R1=2 Ohms, R=R3=8 Ohms, and the battery voltages are VA-25 V, Vg-15 V, and Vc=20 V. When the circuit is connected, what will be the power dissipated by R3? Vc HA Ri د R2 ma R3 0.75 W O 1.25 W 2.67W 4.2 W O 5.5 W
In the circuit below, all four resistors are identical (R1 = R2 = R3 = R4 = R) and the battery has a voltage of 4.92 V. (a) When the switch is placed in position 1, the measured current in the battery is 1.34 mA. What is the value of each resistor? k? (b) When the switch is placed in position 2, what is the current flowing out of the battery? mA (c) When the switch is open (neither in...
In the circuit below given that R1 = 500 Ohm, R2 = 820 Ohm, R3 = 830 Ohm, R4 = 240 Ohm, E = 7 V. Find the power dissipated by resistor R4. R4 E R3 R2 R1