Homework Answers
Add Answer to:
Consider a transmission line terminated with a capacitor. a) How much power is dissipated in the...
1) A transmission line with z, = 120o is terminated with a load Z. = 120 If the line is /4 long, ...
1) A transmission line with z, = 120o is terminated with a load Z. = 120 If the line is /4 long, find (a) The reflection coefficient T (b) The standing wave ratio VSWR. (c) The input impedance Zm 120X2. 2S points) 14
1) A transmission line with z, = 120o is terminated with a load Z. = 120 If the line is /4 long, find (a) The reflection coefficient T (b) The standing wave ratio VSWR. (c) The input...
1) A lossless transmission line that is 3N2 long with an impedance of 75Ω terminated by a load of...
1) A lossless transmission line that is 3N2 long with an impedance of 75Ω terminated by a load of 25 Ω The generator has a voltage of V,r-2sin(et) V and an internal impedance Ζ'50Ω (a) For this circuit give Vg, T, and the voltage standing wave ratio. (b) Give Vin. Inand Vo (c) Give and I (d) Give the voltage and current at the midpoint of the line (ie. P(z) and I(2) at z-3/4). (e) From the answer of (d)...
9.45 In a laboratory experiment conducted on a 50-(2) lossless transmission line terminated in an unknown...
9.45
In a laboratory experiment conducted on a 50-(2) lossless transmission line terminated in an unknown load impedance, it is found that the standing-wave ratio is 2.0. The successive voltage minima are 25 (cm) apart, and the first minimum occurs at 5 (cm) from the load. Find (a) the load impedance, and (b) the reflection coefficient of the load, (c) Where would the first voltage minimum be located if the load were replaced by a short-circuit?
A lossless transmission line of electrical length l = 0.35λ is terminated in a load impedance...
A lossless transmission line of electrical length l = 0.35λ is terminated in a load impedance as shown in the following figure, where ZL = 60Ω, and Z0 = 100Ω. Find: a) Relfection coefficient Γ, b) Standing wave ratio S (or VSWR), c) Input impedance Zin.
Question 4 (a) The input impedance of a lossless air-core transmission line with characteristic impedance Ro. phase constant B and length I terminated in an impedance Z, is given by R,+Z, tan( i....
Question 4 (a) The input impedance of a lossless air-core transmission line with characteristic impedance Ro. phase constant B and length I terminated in an impedance Z, is given by R,+Z, tan( i. Determine the length of an open circuit 50Ω line required to create a 0.1 nH inductor at a frequency of 10 GHz. (6 marks) ii. Determine the input impedance of the line in part () if the open circuit is changed to a short circuit. (3 marks)...
A 75 Ω lossless transmission line is terminated into a load 100 +j150 Ω. For this line, find: i. Reflection coefficient; ii. An antenna receiving a signal of 500 MHz has the following specificati...
A 75 Ω lossless transmission line is terminated into a load 100 +j150 Ω. For this line, find: i. Reflection coefficient; ii. An antenna receiving a signal of 500 MHz has the following specifications: input power Prad 3.25 kw; effective area of antenna Aeff 3.5 m2; total efficiency of antenna,-42%; radiation efficiency of antenna ecd-65%; tilt angle of the received signal ψ = 35°. Determine Voltage standing voltage ratio; b. i. Gain of the antenna (in dB) ii. Maximum radiation...
A 50-Ω air transmission line terminated with an unknown load ZL is excited by a 6...
A 50-Ω air transmission line terminated with an unknown load ZL is excited by a 6 GHz sinusoidal signal source. The standing wave ratio on the line is measured to be 4 and the position of one of the voltage minimums on the line with respect to the load position is 9 cm. Determine the value of the load impedance ZL and box your answer.
Please help! A 75-12 lossless transmission line has l = 0.752. An inductive load, Zl, is...
Please help!
A 75-12 lossless transmission line has l = 0.752. An inductive load, Zl, is terminated where ZL = 75 + 75 12. (a) Find the standing wave ratio S on the line. (b) Find the load reflection coefficient, r(O), and the reflection coefficient seen at input, 7(1). (c) Find the input impedance of the line, Zin, for four different line lengths: 11 = 1/8, 12 = 9/4, 13 = 34/8, and 14 = 1/2, respectively. V(z), 7(z) ZO.B
Please answer all parts. Thank you! (25 points) A half wavelength long 50 Ohm transmission line is terminated with a load of 100 Ohm. The voltage across the load is 16V 2. Determine standing wave rat...
Please answer all parts. Thank you!
(25 points) A half wavelength long 50 Ohm transmission line is terminated with a load of 100 Ohm. The voltage across the load is 16V 2. Determine standing wave ratio on the transmission line. Determine the incident voltage and reflected voltage at the load. Determine the incident current and reflected current a quarter wavelength away from the load. Determine the wave impedance a quarter wavelength away from the load. Design a matching network to...
A 50-Ohm lossless air-spaced transmission line is terminated in a load. The voltage standing wave pattern...
A 50-Ohm lossless air-spaced transmission line is terminated in a load. The voltage standing wave pattern on the line is measured and the resulting curve is presented in the figure. V[V] -1 -0.8 -0.6 -0.4 -0.2 0 - [m] (a) Determine the signal frequency. (b) Find the percentage of the incident power that is delivered to the load.
1) A transmission line with z, = 120o is terminated with a load Z. = 120 If the line is /4 long, find (a) The reflection coefficient T (b) The standing wave ratio VSWR. (c) The input impedance Zm 120X2. 2S points) 14
1) A transmission line with z, = 120o is terminated with a load Z. = 120 If the line is /4 long, find (a) The reflection coefficient T (b) The standing wave ratio VSWR. (c) The input...
1) A lossless transmission line that is 3N2 long with an impedance of 75Ω terminated by a load of 25 Ω The generator has a voltage of V,r-2sin(et) V and an internal impedance Ζ'50Ω (a) For this circuit give Vg, T, and the voltage standing wave ratio. (b) Give Vin. Inand Vo (c) Give and I (d) Give the voltage and current at the midpoint of the line (ie. P(z) and I(2) at z-3/4). (e) From the answer of (d)...
9.45
In a laboratory experiment conducted on a 50-(2) lossless transmission line terminated in an unknown load impedance, it is found that the standing-wave ratio is 2.0. The successive voltage minima are 25 (cm) apart, and the first minimum occurs at 5 (cm) from the load. Find (a) the load impedance, and (b) the reflection coefficient of the load, (c) Where would the first voltage minimum be located if the load were replaced by a short-circuit?
Question 4 (a) The input impedance of a lossless air-core transmission line with characteristic impedance Ro. phase constant B and length I terminated in an impedance Z, is given by R,+Z, tan( i. Determine the length of an open circuit 50Ω line required to create a 0.1 nH inductor at a frequency of 10 GHz. (6 marks) ii. Determine the input impedance of the line in part () if the open circuit is changed to a short circuit. (3 marks)...
A 75 Ω lossless transmission line is terminated into a load 100 +j150 Ω. For this line, find: i. Reflection coefficient; ii. An antenna receiving a signal of 500 MHz has the following specifications: input power Prad 3.25 kw; effective area of antenna Aeff 3.5 m2; total efficiency of antenna,-42%; radiation efficiency of antenna ecd-65%; tilt angle of the received signal ψ = 35°. Determine Voltage standing voltage ratio; b. i. Gain of the antenna (in dB) ii. Maximum radiation...
Please help!
A 75-12 lossless transmission line has l = 0.752. An inductive load, Zl, is terminated where ZL = 75 + 75 12. (a) Find the standing wave ratio S on the line. (b) Find the load reflection coefficient, r(O), and the reflection coefficient seen at input, 7(1). (c) Find the input impedance of the line, Zin, for four different line lengths: 11 = 1/8, 12 = 9/4, 13 = 34/8, and 14 = 1/2, respectively. V(z), 7(z) ZO.B
Please answer all parts. Thank you!
(25 points) A half wavelength long 50 Ohm transmission line is terminated with a load of 100 Ohm. The voltage across the load is 16V 2. Determine standing wave ratio on the transmission line. Determine the incident voltage and reflected voltage at the load. Determine the incident current and reflected current a quarter wavelength away from the load. Determine the wave impedance a quarter wavelength away from the load. Design a matching network to...
A 50-Ohm lossless air-spaced transmission line is terminated in a load. The voltage standing wave pattern on the line is measured and the resulting curve is presented in the figure. V[V] -1 -0.8 -0.6 -0.4 -0.2 0 - [m] (a) Determine the signal frequency. (b) Find the percentage of the incident power that is delivered to the load.
Most questions answered within 3 hours.
-
A suggestion is made that the proportion of people who have food
allergies and/or sensitivities is...
asked 1 hour ago -
A refrigerator operates between temperatures of 294 and 253 K.
What would be its maximum coefficient...
asked 2 hours ago -
CHEM 2 (Step by step explanation please prefer if it were
handwritten)
A 100 mL aqueous...
asked 2 hours ago -
Doing a bio paper on Ann Atwater.
Born: July 1, 1935
Ann Atwater was an American...
asked 3 hours ago -
can the neoclassical and endogenous growth model help us to
explain the lack of growth in...
asked 3 hours ago -
This section aims to convince the client of the importance and
benefits, and outline some potential...
asked 4 hours ago -
Match each class operation with its most likely category type.
1. SelectCamera( ); 2. ComputeArea( );...
asked 4 hours ago -
Show all work and calculations.
Find the ΔH for the target reaction below, given the following...
asked 4 hours ago -
Assume the user always enters the correct values for a. Next,
your program should compute and...
asked 4 hours ago -
you created an application named
QuartsToGallonsInteractive that accepts a number of quarts
from a user and...
asked 4 hours ago -
The Friendly Sausage Factory (FSF) can produce hot dogs at a
rate of 5,000 per day....
asked 4 hours ago -
What is the component concentration ratio,
[BrO−]/[HBrO], of a buffer that has a pH of 8.02?...
asked 4 hours ago