I keep getting the wrong answer from everyone else pls help me get the right answer
I keep getting the wrong answer from everyone else pls help me get the right answer...
I keep getting the wrong answer from everyone else pls help me get the right answer For the BJT bias circuit shown, what value of Rc in kilohms is needed to allow the maximum possible peak-to-peak signal swing on the collector without clipping? Use Vcc-9V, Vee--7V, Vb-1.2V, and Re -9.9k2. Assume that to keep the transistor in the forward-active region, the base-collector junction cannot be forward biased. Use B 20 and Vbe(on) 0.7V. Neglect the effects of base-width modulation. Vcc...
For the BJT bias circuit shown, what value of Rc in kilohms is needed to allow the maximum possible peak-to-peak signal swing on the collector without clipping? Use Vcc = 8V, Vee = -6V, Vb = 2.0v, and Re = 9.1k02. Assume that to keep the transistor in the forward-active region, the base- collector junction cannot be forward biased. Use B = 65 and Vbelon) = 0.7V. Neglect the effects of base-width modulation. VCC 芒Vs windows
attaced the correct answer if you did not get the same DON'T POST IT For the MOSFET bias circuit shown, what value of Rd in kilohms is needed to allow the maximum possible peak-to- peak signal swing on the drain without clipping? Use: Vdd = 6V, Vss =-7V, Vg = 1.5V, Rs 9.7kQ, Vt =-0.5V, and IVonl = 0.18. (Remember that [Vonl-[Vov Vgsl-Vt) Neglect the effect of channel-length modulation and body effect. (Hint: Be sure to keep the MOSFET in...
the correct answer attachd if u did not get the same asnwer DO NOT POST it For the MOSFET bias circuit shown, what value of Rd in kilohms is needed to allow the maximum possible peak-to- peak signal swing on the drain without clipping? Use: Vdd = 6V, Vss =-7V, Vg = 1.5V, Rs 9.7kQ, Vt =-0.5V, and IVonl = 0.18. (Remember that [Vonl-[Vov Vgsl-Vt) Neglect the effect of channel-length modulation and body effect. (Hint: Be sure to keep the...
Could someone please help me on how I should be configuring the circuit in Figure 4(a) in Multisim? Basically not understanding question #1 in the Procedure. Cannot keep Vrb the same value while adjusting Vcc. Then when trying to adjust Vbb to hold Vrb, Ib changes. Any help is appreciated! Discrete Devices Section LAB 4 BJT CHARACTERISTICS AND BIASING Objective: The objective of this laboratory is to examine the operation of a bipolar junction transistor and plot its output characteristics...