LUS Philpot, M of Mechanics of Solids (EAS 209) TEW PRINTER VERSIONBACK NEXT shafts. allow the...
The motor shown in the figure supplies 14.0 kW at 1880 rpm at A. Shafts (1) and (2) are each solid 26 mm diameter shafts. Shaft (1) is made of an aluminum alloy [?G=26??GPa], and shaft (2) is made of bronze [?G=45??GPa]. The shaft lengths are L1=3.1m and L2=2.7m, respectively. Gear B has 55 teeth, and gear C has 99 teeth. The bearings shown permit free rotation of the shafts. Determine: (a) the maximum shear stress produced in shafts (1)...
Philpot, Mechanics of Materials, 3e Mechanics of Materials (CENE 253 STANDARD VIEW PRINTER VERSION BACK NEXT P9.026 The ctever beam is sublected to a concentrated load of P - 46 kips. The cross-sectional dimensions of the wide-flange shape are shown in the second figure. (a) the shear stress T- at point H, which is located 3.1 in. below the centroid of the wide-flange shape. x Not Correct Assume yw-3.1 in., -1.9 in., d-10.1 in., t 0.261 in., tr-0.321 in., br...
20 mm (t1)allow- 80MPa (T2 allow 95 MPa 0.25 ×106 mm" 75 GPa J1= 35 mm 322.36x106 mm 50 GPa 2500 mm 3000 mm T (kN-m A composite torsion member consists of two solid shafts joined at flange B. Shafts (1) and (2) are attached to rigid supports at A and c, respectively. 1 (MPa Using the allowable shear stresses indicated on the sketch, determine the maximum torque T that may be applied to flange B in the direction shown....
(1allow = (ta)allow = 80 MPa 65 MPa 35 mm 2.36x10 mm 75 GPa Shaft properties 60 mm 20.36 x 10 mm 25 GPa 2300 mm 3500 m (kN-m A composite torsion member consists of two solid shafts joined at flange B. Shafts (1) and (2) are attached to rigid supports at A and c, respectively. (MPa) Ital (MPa) Using the allowable shear stresses indicated on the sketch, determine the maximum torque T that may be applied to flange B...