Solution :
if you have any doubts then you can ask in comment section if you find the solution helpful then upvote the answer. Thank you.
Consider the following network. IP and Ethernet addresses are marked for all interfaces. Assume a client...
In the network shown below, nodes A through G are hosts, node H is an Ethernet hub. node S is an Ethernet switch. Host G acts as an IP-level router (i.e. a gateway) between the two subnets. Subnet 1 is allocated IP block 197.15.35.0/24. and Subnet! is allocated IP block 200.40.1 S. 192/26. All of the network interfaces in Subnet 1 were manufactured by Intel. All of the network interfaces in Subnet2 were manufactured by Apple. Suppose a DXS resolver...
The figure below shows a wired network with IP and MAC addresses assigned for each host. The client sends a packet to the server (labels 1 and 2) 65.55.251.214 00:0d:93:30:c1:da S: D: 152.160.3.254 00:23:12:f4:e7 S: D: 2 152.160.3.2 01:d3:12:45:f3 4.125.228.39 Router 00:34:12:a8:c1:de Server Client The source MAC address for the packet between the client and the router (label 1) is address is and the destination MAC
1. Change the IP multicast address 233.50.18.2 to Ethernet multicast addresses. . 2. Answer the following question about client-server programs: a. Which program is running on the local machine b. Which program is running on the remote machine (client or server)? c. Which program is an infinitive program (client or server)? d. Which program is a finite program (client or server)? . 3. The following is a dump of a UDP header in hexadecimal format: CB820045007C12B2 a. What is the...
2) IP and MAC addressing. True or False. One point for each correct answer, zero points for each incorrect answer. Many of the questions refer to the following network consisting of three 10Mbps Ethernet segments, one switch, and one router. Assume all ARP tables are up-to-date unless otherwise stated. a) Consider a network consisting of Ethernets, hubs, switches, and routers. Suppose one of the hubs is replaced with a switch. Then the network administrator must redefine some IP addresses. True...
Consider the scenario below in which three hosts, with private IP addresses 10.0.1.13, 10.0.1.15, 10.0.1.20 are in a local network behind a NATted router that sits between these three hosts and the larger Internet. NAT Translation Table WAN side addr LAN side addr 35.122.196.219:517 10.0.1.27:3435 10.0.1.13 2 S: D, 10.0.1.27 135.122.196.219 10.0.1.15 4 3 10.0.1.20 IP datagrams being sent from, or destined to, these three hosts must pass through this NAT router. The router's interface on the LAN side has...
12. The combination of the source and destination IP addresses and the source and destination port numbers is known as a socket. What is a socket used for? 13. Label the following port number ranges. _0 to 1023 1024 to 49151 49152 to 65535 14. What DOS command can be used to see which active TCP connections are open and wing on a networked host? 15. Why is dividing application data into segments necessary 16. Labelcach of the following delivery...
EXPLAIN in details why is it true or false. need to be 100% POSTIVE OF ANSWER. SOLVE D E F G H I J 2) (10 points) IP and MAC addressing. True or False. Circle True or False. One point for each correct answer, zero points for each incorrect answer. Many of the questions refer the folowing network consisting of three 10Mbps Ethernet segments, one switch, and one router. Assume all ΛΕΡ tables are up-to-date unless otherwise stated Switch Ronter...
Notes: Each packet begins with a 14 byte Ethernet header A missing byte “__” denotes an unknown or corrupted byte Embedded protocol numbers in decimal are: TCP = 6; UDP = 17; and ICMP = 1 ==================================================================================== Question 1 01 00 5e 00 00 02 00 0f f8 a0 c0 80 08 00 45 00 00 30 00 00 00 00 01 11 c5 3d 0a 7b 0a 03 e0 00 00 02 07 c1 07 c1 00 1c 85...
Consider the topology shown below with following requirements Three subnets A, B, C, should have enough addresses, starting from 192.100.10.0 to support 500 interfaces, 200 interfaces, and 100 interfaces, respectively. Each of subnets, D, E, and F has 32 interfaces. (not required for address assignment.) The IP addresses for three subnets should be assigned continuously, with spacing of power-2, that means, 250 will be rounded to 256, and so on. For each subnet, the assignment should take the form a.b.c.d/x...
Q1. Hierarchical IP Address 1.1 Give a non-network example of hierarchical addressing, and discuss how it reduces the amount of work needed in physical delivery. Do not use any example in the book, the postal service, or the telephone network.1.2 A firm is assigned the network part 128.171. It selects a 10-bit subnet part. a) Draw the bits for the four octets of the IP address of the first host on the first subnet. (Hint: as we don’t use all...