1)
For Switches : Cisco Catalyst 3850 Series (3850-24XU) can be used to connect the LAN machines on each floor.
For Router : Cisco 4-Port High-Density Gigabit or 1-Port 10 Gigabit Ethernet WAN Service Module (SM-X-4X1G-1X10G)
The configuration of the network is mentioned below:
2):
Use Cisco SFP-10G-LR-S Module 10GBase as the transceiver.
3):
For connecting cables Cat 6A or Cat 7 Ethernet cables should be used to support gigabit speed.
4):
The Computers at each floow should be connected in Bus topology to the switched placed at their floors.
Each floor have a different switch and each switch is connected to the router.
The router in turn is connected to the outer WAN network (aka Internet).
5):
Router : The can be anywhere in the building where the cable from the ISP is installed.
Switch : Each of the four switchs will be placed at each floor.
Suppose you had to design a wired Ethernet network for a 4-story office building containing 20...
Complete the following short answer questions: 1. Design an Ethernet network to connect a single client PC to a single server which will contain a wired connection to both digital storage media as well as an optical device. Both the client and the server will connect to their respective workgroup switches via UTP. Their workgroup switches are connected directly by a trunk link. The two switches are 1,700 meters apart. They need to communicate at 500 Mbps. Your design should...
Design a Logical Topology with the following constraints: Material Constraints: 2x 24-Port, Layer 3 Network Switches 1x Edge Router (connected out to the local LAN, the external RV215W LAN, and the WAN - 3 total connections) 2x Wireless Access Points 1x Cisco RV215W (connected to the edge router to allow LAN communication from another building) 30 total network devices (these will determine your total subnets/VLANs and subnet scopes): 10 VoIP phones 4 Executive computers 2 Administration computers 2 Finance computers...
Question 6 After a problem and its symptoms have been identified, a theory regarding a probable cause should be established. True False 1.25 points Question 7 An open electrical circuit as a result of a failed circuit breaker is considered to be what type of failure system? a. fail-tolerant b. fail-close c. fail-open d. fail-dynamic 1.25 points Question 8 At what layer of the OSI model do the IP, ICMP, and ARP protocols operate? a. Application b. Session c. Transport...