A thick cylinder is 100 mm outer diameter and 50 mm inner diameter. It is pressurised to 112 MPa gauge on the inside. Take E = 205 GPa and ν = 0.27. Calculate the following:
a). The circumferential stress on the outside layer
b). The circumferential stress on the inside layer
c). The longitudinal stress
d). The circumferential strain in the outside layer
e). The circumferential strain in the inside layer
f). The change in the inner diameter
g). The change in the outer diameter
We need at least 9 more requests to produce the answer.
1 / 10 have requested this problem solution
The more requests, the faster the answer.
A thick cylinder is 100 mm outer diameter and 50 mm inner diameter. It is pressurised to 112 MPa gauge on the inside. Take E = 205 GPa and ν = 0.27. Calculate the following:
A small closed cylinder has dimensions 50 mm external diameter by 160 mm long with 0.25 mm wall thickness. (a) What is the allowable internal pressure if the safe tensile stress for the material is 250MPa? (b) What change in length and diameter occurs in the cylinder if it is pressurised to this value? Take E = 200 GPa, and ν = 0.3.
please answer 18.11 and 18.12 18.11 A steel ring with an outside diameter of 150 mm and an inside diameter of 100 mm is shrunk onto another steel ring with an inside diameter of 50 mm. An axial force of 56,54 kN is needed to push the rings apart. Calculate the pressure at the mating surface and the shrinkage allowance given that both rings are 20 mm thick and the coefficient of friction between the mating surfaces is 0,2. Using...
4.A thin-walled cylindrical column carries a weightless arch and is loaded as shown in Figure 4. The column has an internal diameter of 250 mm with a thickness of 2 mm Given: E-200 GPa and 0.3 The answer to each part of the question is to be used for subsequent parts (a)Determine the stresses on the outer surface of the cylinder at points A and B due to (8 marks) (b) Determine the minimum internal pressure p required if the...
The cylindrical pressure vessel shown in the figure has an inside diameter of 980 mm and a wall thickness of 12 mm. The cylinder is made of an aluminum alloy that has an elastic modulus of E = 72 GPa and a shear modulus of G = 27.5 GPa. Two strain gages are mounted on the exterior surface of the cylinder at right angles to each other. The angle θ is 21°. If the pressure in the vessel is 1.86...
Question 1 The cylindrical pressure vessel shown has an inside diameter of 625 mm and a wall thickness of 5 mm. The cylinder is made of an aluminum alloy that has an elastic modulus of E = 70 GPa and a shear modulus of G-26.3 GPa. Two strain gages are mounted on the exterior surface of the cylinder at right angles to each other; however, the angle θ is not known. If the strains measured by the two gages are...