Problems 4, 5 & 6 15) A heat-conducting rod, 0.90 m long and wrapped in insulation,...
Before beginning a long trip on a hot day, a driver inflates an automobile tire to a gauge pressure of 1.57 atm at 300 K. At the end of the trip, the gauge pressure has increased to 1.97 atm. (a) Assuming the volume has remained constant, what is the temperature of the air inside the tire? K (b) What percentage of the original mass of air in the tire should be released so the pressure returns to its original value?...
Before beginning a long trip on a hot day, a driver inflates an automobile tire to a gauge pressure of 2.70 atm at 300 K. At the end of the trip, the gauge pressure has increased to 3.20 atm. (a) Assuming the volume has remained constant, what is the temperature of the air inside the tire? 356 K (b) What percentage of the original mass of air in the tire should be released so the pressure returns to its original...
A long slender solid cylindrical rod made of copper is 2 cm in diameter. It is taken out of a liquid nitrogen bath at 77 K and exposed to a stream of warm air at a temperature of 50 C. Neglect internal temperature gradients find the time taken by the rod to heat up to a temperature of 10 C if the surface heat transfer coefficient is 20 W/m^2K. For copper, take k=330 W/mK and ?=95*10^-6 m^2/s.
How do I solve this? A copper rod is 0.450 m long. Heat is added to the rod until it expands by 0.00130 m. How much did the temperature change? la-17. 10-s ca l β-51-10-6 C-1] Copper (Unit C) 3003-201Coation All ights Reserved
006 10.0 point:s Two concrete spans of a 230 m long bridge are placed end to end so that no room is allowed for expansion T 20 I y 230 m If the temperature increases by 20°C, what is the height to which the spans rise when they buckle? Assume the thermal coefficient of expansion is 1.2 x 10-5 (C)1 Answer in units of m. 007 10.0 points An automobile tire having a temperature of -4.3°C (a cold tire on...
Consider a 2 m long metal rod. The temperature u(z,t) at a point along the rod at any time t is found by solving the heat equation k where k is the material property. The left end of the rod ( 0) is maintained at 20°C and the right end is suddenly dipped into snow (0°C). The initial temperature distribution in the rod is given by u(x,0)- (i) Use the substitution u(z,t) ta,t)+20-10z to reduce the above problem to a...
a) If an iron rod 1.5 m long at 20 degree C and expands by 1.416 mm when heated to 100 degree C. Find the coefficient of linear expansion for iron. b) A large wooden barrel needs an iron band to be placed around the rim of its base. The iron band is made slightly smaller than the diameter of the barrel's base so that it may be heated placed over the barrel and shrunk tightly into place. If the...
A rigid copper tank, initially containing 1 m^3 of air at 295K, 5 bar, is connected by a valve to a large supply line carrying air at 295K, 15 bar. The valve is opened only as long as required to fill the tank with air to a pressure of 15 bar. Finally, the air in the tank is at 310 K. The copper tank, which has a mass of 20 kg, is at the same temperature as the air in...
Heat Transfer Problems 1. A window pane (1/8 inch thick) in an old house owned by a professor is 3 ft. by 4 ft. He likes to be warm in the winter so the inside temperature is kept at 70 °F even when the outside temperature is 10 •F. For this problem assume the inside and outside temperatures are for the window surface. How much heat is transferred through the window (k=.54 BTU/hr ft ° F)? 2. A small heated...
In the diagram below, nitrogen molecules are represented by unshaded spheres, oxygen molecules by gray spheres, and chlorine molecules by black spheres. If the total pressure in the container is 900. mm Hg, what is the partial pressure of chlorine? 2. What is the partial pressure of helium in a gas mixture of He, Xe and Ar if total pressure is 5.35 atm, temperature is 55 °C, mole fraction of xenon is 0.298, and mole fraction of argon is 0.433?...