In Ion Exchange Chromotagraphy, ions that have a high charge become eluted with an increase in...
In Ion Exchange Chromotagraphy, ions that have a high charge become eluted with an increase in ionic strength.
I know ionic strength is kind of a measure of the dissolved ions in solution, but how does increasing the ionic strength (say adding a higher concentration of HBr) remove a +3 ion from the resin?
This has been puzzling me
Homework Answers
Add Answer to:
In Ion Exchange Chromotagraphy, ions that have
a high charge become eluted with an increase in...
In this lab exercise a solution containing K+ is passed down an ion exchange column containing...
In this lab exercise a solution containing K+ is passed down an ion exchange column containing a cation exchange resin in the acid form. The K+ ions in the solution replace the resin bound H3O+ ions which elute from the column and then are titrated. This means that the column now holds the K+ ions. To use the column again we must "recharge" the column to remove K+ ions. In your Lab Notebook, describe the exact procedure you will follow...
5. When all of the sample to be collected has left the column, will the drop...
5. When all of the sample to be collected has left the
column, will the drop of solution coming off the tip of the column
be acidic, basic or neutral?
6. How many H+ ions would be displaced from the ion
exchange column by 1 Cu2+ ion?
7. Binding sites on the ion exchange resin are saturated
with which ion before the sample solution is added?
8. Ions are displaced from the resin binding sites by
any ion that has...
22. Which of the following pairs of compounds and ions could be used to form a...
22. Which of the following pairs of compounds and ions could be used to form a buffer solution? (a) 0.10 M HCl and 0.10 M Naci (b) 0.10 M NH4Cl and 0.10 M NH3 (c) 0.10 M HNO2 and 1.0 x 10'M NaNO, 23. An activity coefficient (a) measures the deviation of behavior of ions from ideality. (b) is obtained by multiplying the concentration of a solution times the ionic strength. (c) replaces the concentration term in chemical calculations. It...
I know some of the measured pH values are a little off due to error in...
I
know some of the measured pH values are a little off due to error
in the lab, but I need help filling out the “Ion Hydrolyzed” table
and then the “Net Ionic Equation” part. I remember doing net ionic
equations in General Chemistry I, bit don’t see how it applies
here.
Thanks, in advance! (i will rate!)
Learning Objectives: 1. To test the acidic and basic properties of ionic compounds. 2. To create a buffer solution and calculate its...
need help with the Molarity of both parts EXPERIMENT 8: AN OXIDATION-REDUCTION TITRATION DATA SHEET 0.2M...
need help with the Molarity of both parts
EXPERIMENT 8: AN OXIDATION-REDUCTION TITRATION DATA SHEET 0.2M 10 m2 Concentration of original KMnO solution Volume of Original KMnO4 solution used Molarity of KNOWN HOCg04 D.ISOM Standardization of KMnO solution. Sample 3 Sample 1 Volume H2C204 11.00ML Initial buret reading (KMnO4) .00 mc Final buret reading (KMnO4) 12.00ML Volume KMnO4 12.00ml Molarity KMnO4 Average (KMnO4) Sample 2 4:00ML 12.00mL 13.5ML . SOL Determination of Unknown Solution Sample 3 Sample 1 4ml Volume...
I need help with the problem in the last photo.. I thought I’d post my lab...
I need help with the problem in the last photo.. I thought I’d
post my lab explanation and data if that helps you get a better
understanding, but it’s just the question at the end. I know I need
to use the Henderson Hasselbach equation.. so... 4.70 = pKa + log(
[acetate-ion] / [acetic-ion] ) and solve for pKa, then Ka.. but how
do I find the concentrations to put in the log fraction?
Thanks, in advance!
Learning Objectives: 1....
Exercise 2 Separation of a Mixture Based on Acid-Base Properties One purpose of this exercise is...
Exercise 2 Separation of a Mixture Based on Acid-Base Properties One purpose of this exercise is to learn how to use a separatory funnel to extract a single component away from other compounds in solution. To do so, we will apply the principles of solubility and acid-base behavior you’re seeing in class. One of the compounds is neutral in the acid-base sense. It has no ability to either donate or accept a proton from an aqueous solution, and will remain...
please correct me If I did anything wrong. im very confused on this. • Determining k...
please correct me If I did anything wrong. im very confused on
this.
• Determining k in Beer's Law 2. Determining the equilibrium constant Test Tube No. Absorbance Test Tube No. Absorbance 0,060 이79 0.253 0319 0.400 0.120 0.268 0.361 0.461 0.695 Post Laboratory Questions 1. Complete the following table and calculate k-value for the Beer's Law. All concentrations should be in M. [Fe(SCN)2) Absorbance CA Test Tube No. Diluted Fe(NO3)2 (mL) 0 . 2 3 4 s Reference 1.0...
What are the instruments that have been utilized for the review article discussions? ` 1. Introduction...
What are the instruments that have been utilized for the
review article discussions?
`
1. Introduction In recent years, nanoclays have been the object of particular interest for many scientists and researchers in chemistry, physics, engineering and biology due to their excellent properties as well as their sustain- ability [1-3]. For instance, they represent the starting point to the de velopment of smart materials for drug delivery (4-9), food packaging [10-12), environmental remediation and wastewater treatment [13], cultural heritage [14–17and...
For the preparation and standardization of NaOH with KHP im supposed to boil water for 1hr and 30 min to remove CO2
For the preparation and standardization of NaOH with KHP im supposed to boil water for 1hr and 30 min to remove CO2....the problem is that if I don't boil it for that long and (30 min) b/c of not enough time but I put the water I boiled for 1/2 hr aproximately into a NaOH bottle with a CO2 absorber and stored it there for a few days. I would assume that I would have to boil the water again...but...
5. When all of the sample to be collected has left the
column, will the drop of solution coming off the tip of the column
be acidic, basic or neutral?
6. How many H+ ions would be displaced from the ion
exchange column by 1 Cu2+ ion?
7. Binding sites on the ion exchange resin are saturated
with which ion before the sample solution is added?
8. Ions are displaced from the resin binding sites by
any ion that has...
22. Which of the following pairs of compounds and ions could be used to form a buffer solution? (a) 0.10 M HCl and 0.10 M Naci (b) 0.10 M NH4Cl and 0.10 M NH3 (c) 0.10 M HNO2 and 1.0 x 10'M NaNO, 23. An activity coefficient (a) measures the deviation of behavior of ions from ideality. (b) is obtained by multiplying the concentration of a solution times the ionic strength. (c) replaces the concentration term in chemical calculations. It...
I
know some of the measured pH values are a little off due to error
in the lab, but I need help filling out the “Ion Hydrolyzed” table
and then the “Net Ionic Equation” part. I remember doing net ionic
equations in General Chemistry I, bit don’t see how it applies
here.
Thanks, in advance! (i will rate!)
Learning Objectives: 1. To test the acidic and basic properties of ionic compounds. 2. To create a buffer solution and calculate its...
need help with the Molarity of both parts
EXPERIMENT 8: AN OXIDATION-REDUCTION TITRATION DATA SHEET 0.2M 10 m2 Concentration of original KMnO solution Volume of Original KMnO4 solution used Molarity of KNOWN HOCg04 D.ISOM Standardization of KMnO solution. Sample 3 Sample 1 Volume H2C204 11.00ML Initial buret reading (KMnO4) .00 mc Final buret reading (KMnO4) 12.00ML Volume KMnO4 12.00ml Molarity KMnO4 Average (KMnO4) Sample 2 4:00ML 12.00mL 13.5ML . SOL Determination of Unknown Solution Sample 3 Sample 1 4ml Volume...
I need help with the problem in the last photo.. I thought I’d
post my lab explanation and data if that helps you get a better
understanding, but it’s just the question at the end. I know I need
to use the Henderson Hasselbach equation.. so... 4.70 = pKa + log(
[acetate-ion] / [acetic-ion] ) and solve for pKa, then Ka.. but how
do I find the concentrations to put in the log fraction?
Thanks, in advance!
Learning Objectives: 1....
please correct me If I did anything wrong. im very confused on
this.
• Determining k in Beer's Law 2. Determining the equilibrium constant Test Tube No. Absorbance Test Tube No. Absorbance 0,060 이79 0.253 0319 0.400 0.120 0.268 0.361 0.461 0.695 Post Laboratory Questions 1. Complete the following table and calculate k-value for the Beer's Law. All concentrations should be in M. [Fe(SCN)2) Absorbance CA Test Tube No. Diluted Fe(NO3)2 (mL) 0 . 2 3 4 s Reference 1.0...
What are the instruments that have been utilized for the
review article discussions?
`
1. Introduction In recent years, nanoclays have been the object of particular interest for many scientists and researchers in chemistry, physics, engineering and biology due to their excellent properties as well as their sustain- ability [1-3]. For instance, they represent the starting point to the de velopment of smart materials for drug delivery (4-9), food packaging [10-12), environmental remediation and wastewater treatment [13], cultural heritage [14–17and...
Most questions answered within 3 hours.
-
The free energy change for the following reaction at 25 °C, when
[Sn2+] = 1.17 M...
asked 1 hour ago -
An MNE is this kind of industry when competition in one country
is essentially independent of...
asked 3 hours ago -
. For this set of questions, determine what
proportion of a normal distribution is located betweeneach...
asked 3 hours ago -
A college student is employed as a door-to-door newspaper
salesman. Historical data suggests that the student...
asked 4 hours ago -
MATLAB HW 11 problem using Switch Case and Input commands
Write a script file that calculates...
asked 4 hours ago -
Considering gravitational time dilation, calculate the time that
passes in Earth’s surface while 1 hour passes...
asked 5 hours ago -
Minitab Problem: Take the Lake Hume June rainfall data and find
use the processes outlined in...
asked 5 hours ago -
X Company is trying to decide whether to continue using old
equipment to make Product A...
asked 5 hours ago -
IN PYTHON ONLY !! Program 2: Re-work
program #5 (WeeklyHours) from the previous assignment such that...
asked 6 hours ago -
The average length of time between arrivals at a turnpike
toll-booth is 26 seconds. What is...
asked 8 hours ago -
(a) A piston at 6.1 atm contains a gas that occupies a volume of
3.5 L....
asked 9 hours ago -
Please answer true or false. Words
cannot be changed or added in to make it true...
asked 9 hours ago