(2) Weigh the solid in a glass weighing bottle.
Transfer the solid to a volumetric flask.
Add water/solvent to volumetric flask to halfway mark.
Rinse the weighing bottle with the water/solvent and transfer to the flask.
Stir/shake the solution to dissolve the solid.
Make up the volume with water/ solvent up to the mark of 100 mL.
(3) Once you added an excess of water, a small portion of sugar might already be dissolved in the excess water, so If you remove a small/excess portion the little-dissolved sugar will also get lost hence the measured density will be less.
(4) Volume = 100 mL
Mass of solution = 103.87 g
Density = 103.87 g / 100 mL = 1.0387 g/mL
The fitted linear equation, y = mx + c
slope = m = 0.0038
intercept = c = 0.9959
Density = y = 1.0387 g/mL
Mass of sugar, x = (y - c) / m = (1.0387 - 0.9959) / 0.0038 = 11.2632 g
Please do 2,3 and 4 Experiment 3 Pr 1. A student weigh be 98.595 oth mark,...
b) In this experiment an aspirin tablet mark with deionized water. Using a pipette into a 100-mL volumetric flask and diluted to t make a 'diluted aspirin solution'. an aspirin tablet was placed in a 250-ml volumetric flask o dissolved in 10 mL of 1.0M NaOH solution, the flask was then 1.0M NaOH solution, the flask was then filled to the nized water. Using a pipette, 5.0 mL of this solution was added mL volumetric flask and diluted to the...
b) In this experiment an aspirin ta and dissolved in 10 mL of 1.0M Na mark with deionized water. Using a into a 100-mL volumetric flask and make a diluted aspirin solution'. ent an aspirin tablet was placed in a 250-ml volumetric flask 10 mL of 1.OM NaOH solution, the flask was then filled to the zed water. Using a pipette, 5.0 mL of this solution was added IL Volumetric flask and diluted to the mark with FeCl solution to...
Can you please tell me the grams i need for these 2 solutions? Thank You Weigh out the necessary mass of KNO3 to make 50 mL of 1.0 M supporting electrolyte solution. Transfer the KNO3 to a 50- mL volumetric flask and dilute to the mark with deionized Analyte motion water. Ensure the solid is dissolved completely before using the solution. Transfer to a small beaker. This is your supporting electrolyte solution. Weigh out the necessary mass of K3Fe(CN)6 to...
II. Digestion of Acetylsalicylic acid(standard and tablet) with NaOH . Digestion of Acetylsalicylic Acid Standard to Prepare Stock Solution: Obtain ca. 0.1 g dried acetylsalicylic acid (MM = 180.16 g/mol), accurately weighed, and quantitatively transfer to a 125-ml Erlenmeyer flask. Add 5 ml 1.0 M NaOH and heat mixture to boiling on a hot plate. This will hydrolyze the acetylsalicylic acid to sodium salicylate. If necessary, rinse down the walls of the Erlenmeyer with DI water to ensure complete hydrolysis...
Heres are the steps that were followed... Please help. Let me know if their is any missing information. ii) Nickel analysis - Prepare three standard nickel solutions using the following procedure. Accurately weigh approximately 1.0 g of [Ni(H20)6]504 into a 50 mL volumetric flask. Add 10 mL of D.I. water followed by 10 mL of 1 M H2SO4(aq) to dissolve the salt and then dilute to the mark with deionized water. Pipet 10 mL of the solution into one 25...
ACTIVITY ACTIVITY 2 A Determining the Densities of Solutions 1. Weigh an empty 50-ml graduated cylinder. Record the mass in Data Table 2. 2. Add 5 mL of water (0% sucrose) to the 50-ml graduated cylinder. Use the pipet to add or remove small quantities of liquid so that the water is exactly at the 5-mL mark. 3. Record the Mass of Solution + Graduated Cylinder in Data Table 2. 4. Add more water until the cylinder contains 10 mL...
Question: Prelab Question #2: A student has weighed out 850 mg of 1-pentanol in 50 mL volumetric flask and prepared four standard solutions as described in this procedure. Calculate concentrations of 1-pentanol in mg/mL in each of these solutions. Instructional Videos to Watch before Lab Fundamentals of GC EXPERIMENTAL PROCEDURE Preparation of Solutions. Get a glassware bin from your TA. Rinse five 10 .00 mL volumetric flasks with 2-propanol (isoproponal) to remove any al cohols remaining in the nprevious usage....
Calculate initial concentration of Fe+3 for tubes 1-3. Show your work. Procedure A. Determination of B for Beer's Law 1. Using a buret, add 4.00 mL of 0.0025 M Fe(NO3)s (which is in 0.1 M HNOs) to a 100- mL volumetric flask. Add enough deionized water to bring the total volume to the mark on the neck of the flask. Stopper and shake the flask. Label this flask “Diluted Fe.” spectrophotometer tubes (cuvettes), they are too small to use at...
question one question two Aspirin lab (10 points) 5. a) Spectroscopy is being used to determine the concentration of aspirin in an unknown sample. The absorbance spectrum of the highest concentration standard [Fe3+, SA) prepared is given below. What wavelength should be used to create the calibration curve for the experiment? Explain your reasoning. 0.14 Absorbance 0.02 250 300 450 500 350 400 Wavelength (nm) Wavelength Explain your reason briefly. b) In this experiment an aspirin tablet was placed in...
1. The solubility of a gaseous solute in water is by an increase in pressure. Increased decreased not affected 2. A supersaturated solution may be prepared by slowly cooling down a solution saturated at an elevated temperature. TRUE FALSE 3. A dilution is a solution made by adding a solvent to a supersaturated solution. TRUE FALSE 4. When sugar & water are mixed, a clear liquid results. In this scenario, the sugar is considered a Solute Solution Solvent All of...