9 Air at 20 "C. 100 kPa and a relative humidity of 90% exists in a...
Humid air at 101 kPa, 25°C, 90% relative humidity is compressed in a steady-flow, isentropic compressor to 800 kPa. (a) What is specific humidity of the air? (b) What is the relative humidity of the air exiting the compressor? (c) What is the change in enthalpy of the dry air during this process? (d) What is the change in enthalpy of the water vapor, per unit dry air, during this process? Express your answer in kilojoules per kilogram of dry...
Q 1: In an air conditioning system return air at 26°C dry-bulb temperature and 50% relative humidity is mixed with outdoor ambient air at 34°C dry-bulb temperature and 60% relative humidity. The dry air mass flow rate of outdoor air is 30% of the supply air mass flow rate to the space. The pressure is constant at 101.3 kPa. Calculate (i) the enthalpy, (ii) the humidity ratio, and (ii) the dry-bulb temperature of the supply air. (i) Compare the results...
Problem 7 O/5 points (0%) Humid air at 1 atm, 42 °C dry bulb and 55 % relative humidity is cooled at constant pressure to a temperature 9 °C below its dew-point temperature. Sketch the psychrometric diagram for the process and determine the heat transfer from the air o kJ/kg dry air Cooling coils T2 φ2 T1 ф! 101.3 kPa i H-4」+'Condensate Condensate removal Now Problem (resets attempts) Resets Remaining: 10 Attempts Remaining: 10 Submit Problem 7 O/5 points (0%)...
10-kg moist air at the temperature of 24°C, the pressure of 100 kPa, and relative humidity of 90% is enclosed in a cylinder and piston assembly. The enclosed air is cooled down to the temperature of 12°C at a constant pressure process (when piston can move freely). Determine a) at what temperature vapor starts to condense and b) the mass of condensed water during the process using the psychrometric chart.
Moist air at 20°C, 1 atm, and 43% relative humidity and a volumetric flow rate of 900 m²/hrs. enters a control volume at steady state and flow along a surface maintained at 65°C, through which heat transfer occurs. Liquid water at 20°C is injected at a rate of 5 kg/hr and evaporates into flowing stream. For the control volume, Wev=0, and kinetic and potential energy effects are negligible. Moist air exits at 32°C, 1 atm. (a) draw the system schematic...
Water entering a wet cooling tower at 35°C at a rate of 100 kg/s is cooled to 22°C in the cooling tower by air that enters the tower at 1 atm, 20°C, and 60% relative humidity and leaves saturated at 30°C. The makeup water of 22°C is supplied to the outlet to make the mass flow rate of the cool water the same as that at the inlet, see Figure Q5. Q.5Water entering a wet cooling tower at 35°C at...
3. 1 kg of moist air at mixture pressure 100 kPa has a dry bulb temperature of 30°C and relative humidity of 60%. It is then cooled to a dry bulb temperature of 5°C where it reaches saturation. Without using the psychrometric chart, determine: (35 pts) i) Initial humidity ratio ii) Mass of dry air (kg) iii) Mass of condensate (kg) 720 Tables in SI Units Sal U; X 10 Temp. "C 01 00 ON A 10 11 12 13...