We need at least 10 more requests to produce the answer.
0 / 10 have requested this problem solution
The more requests, the faster the answer.
Class: Week 7 10. Where multiple power supplies serve the same de system, the dc side...
(12 If a conductor is covered, it is: A) Encased with an insulation recognized by the Code 8) Encased with an outer covering not recognized as electrical insulation C) Effectively isolated from ground faults D) Covered with a material of a composition and thickness recognized by UL (13 Open motors with commutators shall material, but this: A) Is only required for over 600 volts B) Does not prohibit these motors from a Class I location C) Shall not prohibit these...
Name HW Due 530/19 ART 430, 440 1. The motor disconnecting means is not required to be in sight from the motor and the driven machinery location, provided_ (a) the (b) the provisions for locking are permanently installed on, or at, the switch or circuit breaker used as the controller disconnecting means (c) locating the motor disconnecting means within sight of the motor is impractical or introduces additional or increased hazards to people or property (d) all of these controller...
answer the following multiple choice questions 5. The most common phase serving . residence would be single phase bwo or double phase three phase multiple phases none of the answers provided RV9,1110 11. A KVA code letter indicates the innush current per hp. size of the short circult protectors size of the overcurrent protectors size of the thermal overloads none of the answers provided 6. RPM is the approximate speed under full-Hoad conditions when voltage is at rated value when...
can anyone help me with this test please? I'm struggling with it QUESTION 1 A permanently installed overhead strip light is a ____. a.foot light b.track light c.border light d.head light QUESTION 2 Egress lighting for carnivals, circuses and fairs shall not ____. a.contain metal raceways b.be integrated into a central switchboard c.contain branch circuits d.be protected by a GFCI protection device QUESTION 3 The attachment plug cap in a mobile home shall be a ____, rated 50...
(1). In regard to installation of electrical conductions and equipment, who may grant exceptions to the requirements of the NEC? A. nfpa b. ahj c. ieee d. ul. (2). Exceptions to the Code permit alternate methods to the general (main) rule. Exceptions are permitted. A. when all of the provisions of the exception are met. B. when a written request is submitted to and approved by the NEC. C. any time the electrician deems it necessary. D. not more than...
pleas help me in this do any question you know using National Electrical Code 2011 Applied Electricity NEC worksheet t hree Copper conductors with THHN insulation run in Electrical A branch-circuit Consther conductors. The conductor terminations are rated for a maximum ure in the area of this installation is not expected to exceed 30C size 8 AWG, the maximum ampacity of the conductors If the conductors for this circuit are permitted A 40 amperes. B. 50 amperes. to be used...
CODE 102_8 Welding Many welding processes require the application of heat and/or pressure to produce a suitable bond between the two parts being joined. There are a number of conventional and commercially practiced welding processes, which possess limitations in relation to material type and thickness, and in addition, the cost analysis may not allow for a process to be used on a specific application. The selection of suitable welding consumable (electrode or wire) is also an important factor in producing...