We would like to modulate the message x(t) = sin(2000πt). For FM modulation take k=200000π and...
We would like to modulate the message x(t) = sin(2000πt). For FM
modulation take k=200000π
and for PM modulation take k=8000π.
a) Estimate the bandwith of FM modulated signal yFM(t) and PM
modulated signal yPM(t).
b) Repeat part (a) if the message signal amplitude is
doubled.
c) Repeat part(a) if the message signal frequency is doubled.
d) Comment on the sensitivity of FM and PM bandwidths to the
spectrum of x(t).
Homework Answers
Request Answer!
We need at least 10 more requests to produce the answer.
0 / 10 have requested this problem solution
The more requests, the faster the answer.
Add Answer to:
We would like to modulate the message x(t) = sin(2000πt). For FM
modulation take k=200000π
and...
Question 4: (20 points) An FM signal is modulated with message m(t)Am cos(2Tmt). The measured amp...
Question 4: (20 points) An FM signal is modulated with message m(t)Am cos(2Tmt). The measured amplitude spectrum, SPM(f), is shown below: Amplitude spectrum of the frequency modulated signal 2 -2 5000 4000 3000 2000 -1000 1000 2000 3000 4000 5000 frequency f [Hz] a) What is the carrier frequency fe? b) What is the message frequency fm c) What is the FM modulation index Bf? Is it a narrowband or a wideband signal? d) Using Carson's rule, estimate the transmission...
Consider frequency modulation with a sinusoidal message signal (tone modulation) m(t) = a cos(2πfmt). The modulated...
Consider frequency modulation with a sinusoidal message signal (tone modulation) m(t) = a cos(2πfmt). The modulated signal is: vFM(t) = Ac cos[2πfct + βf sin(2πfmt)]. with βf = kfa/fm being the modulation index. What is the bandwidth of the modulated signal.
Consider frequency modulation with a sinusoidal message signal (tone modulation) m(t) = a cos(2πfmt). The modulated...
Consider frequency modulation with a sinusoidal message signal (tone modulation) m(t) = a cos(2πfmt). The modulated signal is: vFM(t) = Ac cos[2πfct + βf sin(2πfmt)]. with βf = kfa/fm being the modulation index. What is the bandwidth of the modulated signal.
FM spectrum: A message signal m(t) (shown below) is used to modulate a carrier with frequency (fc...
Solve using Matlab:
FM spectrum: A message signal m(t) (shown below) is used to modulate a carrier with frequency (fc) in a FM system with kr 90, find and plot the FM signal s(t) in both time and frequency domains. Use the value of fc-1000. m(t) (V) 3.5 t (ms) 250 [Note that m(t) is zero for t<0 and t>250 ms
FM spectrum: A message signal m(t) (shown below) is used to modulate a carrier with frequency (fc) in a...
the message signal input to the modulator is given as x(t)=4cos(2pi*10^4t) and the carrier Xc(t)=10cos(pi*10^8t) if...
the message signal input to the modulator is given as x(t)=4cos(2pi*10^4t) and the carrier Xc(t)=10cos(pi*10^8t) if freq modulation is performed with freq sensitivity as being kf=1000pi verify that the modulated signal Meets the criteria for being narrow band FM also obtain an expression for the modulated signal and its spectrum sketch the spectrum
1. Given a baseband signal m(t) sin(1000mt) cos(3000nt) + cos(3700nt a. Sketch the spectrum of m(...
1. Given a baseband signal m(t) sin(1000mt) cos(3000nt) + cos(3700nt a. Sketch the spectrum of m(t) (Hint. sin(a) cos(b) 0.5 sin(a +b) +0.5sin a-b)) b. Sketch the spectrum of DSB-CS signal m(t)cos(10000mt) C ldentify the upper sideband {USB) and lower sideband (LSB) spectra d. Give the black diagram of the receiver to receive DSB-CS signal in (b). 2. baseband signal m(r)--0.5 + Σ..小(t-n)-u(t-0.5-n)] where ult) is the Given unit step function, an amplitude modulated signal is as SAM 107+ m(0cos...
18. Given the message signal m(t) = sin(3000nt) + cos(10,000nt), kf= 250,000n and kp= 20. a....
18. Given the message signal m(t) = sin(3000nt) + cos(10,000nt), kf= 250,000n and kp= 20. a. Estimate the bandwidth of the FM modulated signal 0 b. Estimate the bandwidth of the PM modulated signal 0
Given an energy signal x(t) = (t-5T)e-t-T) , where T-0.1 compute its energy spectrum density in...
Given an energy signal x(t) = (t-5T)e-t-T) , where T-0.1 compute its energy spectrum density in Matlab 1. use two different methods to a. Get its spectrum using Fourier transformation, follovfed by the squaring its amplitude. Plot its Fourier transformation and its energy spectrum density. Get its autocorrelation function, followed by its Fourier transformation. Plot its autocorrelation function and its energy spectrum density. b. 2. In a multipath channel, the received signal y (t) x(t) 0.15x(t -6T) +0.09x(t 10.5T), plot...
Problem 1: An angle modulated waveform is given as s(t)=A_cos (1000 at +8071 +3204) where 0.=10001...
Problem 1: An angle modulated waveform is given as s(t)=A_cos (1000 at +8071 +3204) where 0.=10001 , max|m(t)=3 , and m(t)=0,+<0. In a previous ICE, we determined that if the signal is phase modulated (PM), the phase sensitivity is k= 4001 - 133.31 , the message signal is m(t)=1 12 and the frequency deviation is Am=-80 tn 5-55.51 . Similarly, if the signal is frequency modulated (FM), the frequency sensitivity is kr , the message signal is m(t)==3(3), and the...
Please do Part 4 and Show all work! 1. 145 points) <FM/FSK Modulation/Demodulations A periodic wave m(t) in Figure 1 below The resulting FM signal is demodulated as shown in the following figure b...
Please do Part 4 and Show all work!
1. 145 points) <FM/FSK Modulation/Demodulations A periodic wave m(t) in Figure 1 below The resulting FM signal is demodulated as shown in the following figure by using frequency discriminator. Assume no attenuation of the signal due to propagation loss (in other words assume amplifiers properly restored the amplitude of the transmitted signal at the receiver) [10 points] Find the Fourier Series (trigonometric Fourier Series) of the message signal m (t) where To...
Question 4: (20 points) An FM signal is modulated with message m(t)Am cos(2Tmt). The measured amplitude spectrum, SPM(f), is shown below: Amplitude spectrum of the frequency modulated signal 2 -2 5000 4000 3000 2000 -1000 1000 2000 3000 4000 5000 frequency f [Hz] a) What is the carrier frequency fe? b) What is the message frequency fm c) What is the FM modulation index Bf? Is it a narrowband or a wideband signal? d) Using Carson's rule, estimate the transmission...
Solve using Matlab:
FM spectrum: A message signal m(t) (shown below) is used to modulate a carrier with frequency (fc) in a FM system with kr 90, find and plot the FM signal s(t) in both time and frequency domains. Use the value of fc-1000. m(t) (V) 3.5 t (ms) 250 [Note that m(t) is zero for t<0 and t>250 ms
FM spectrum: A message signal m(t) (shown below) is used to modulate a carrier with frequency (fc) in a...
1. Given a baseband signal m(t) sin(1000mt) cos(3000nt) + cos(3700nt a. Sketch the spectrum of m(t) (Hint. sin(a) cos(b) 0.5 sin(a +b) +0.5sin a-b)) b. Sketch the spectrum of DSB-CS signal m(t)cos(10000mt) C ldentify the upper sideband {USB) and lower sideband (LSB) spectra d. Give the black diagram of the receiver to receive DSB-CS signal in (b). 2. baseband signal m(r)--0.5 + Σ..小(t-n)-u(t-0.5-n)] where ult) is the Given unit step function, an amplitude modulated signal is as SAM 107+ m(0cos...
18. Given the message signal m(t) = sin(3000nt) + cos(10,000nt), kf= 250,000n and kp= 20. a. Estimate the bandwidth of the FM modulated signal 0 b. Estimate the bandwidth of the PM modulated signal 0
Given an energy signal x(t) = (t-5T)e-t-T) , where T-0.1 compute its energy spectrum density in Matlab 1. use two different methods to a. Get its spectrum using Fourier transformation, follovfed by the squaring its amplitude. Plot its Fourier transformation and its energy spectrum density. Get its autocorrelation function, followed by its Fourier transformation. Plot its autocorrelation function and its energy spectrum density. b. 2. In a multipath channel, the received signal y (t) x(t) 0.15x(t -6T) +0.09x(t 10.5T), plot...
Problem 1: An angle modulated waveform is given as s(t)=A_cos (1000 at +8071 +3204) where 0.=10001 , max|m(t)=3 , and m(t)=0,+<0. In a previous ICE, we determined that if the signal is phase modulated (PM), the phase sensitivity is k= 4001 - 133.31 , the message signal is m(t)=1 12 and the frequency deviation is Am=-80 tn 5-55.51 . Similarly, if the signal is frequency modulated (FM), the frequency sensitivity is kr , the message signal is m(t)==3(3), and the...
Please do Part 4 and Show all work!
1. 145 points) <FM/FSK Modulation/Demodulations A periodic wave m(t) in Figure 1 below The resulting FM signal is demodulated as shown in the following figure by using frequency discriminator. Assume no attenuation of the signal due to propagation loss (in other words assume amplifiers properly restored the amplitude of the transmitted signal at the receiver) [10 points] Find the Fourier Series (trigonometric Fourier Series) of the message signal m (t) where To...
Most questions answered within 3 hours.
-
Many communist or socialist countries have a department that
addresses public health as well as the...
asked 1 minute from now -
the following questions are either true or false answers
1. The Central Limit Theorem allows one...
asked 58 seconds from now -
The patient recovery time from a particular surgical procedure
is normally distributed with a mean of...
asked 4 minutes ago -
Human relations refer to the way a company arranges people,
jobs, and communications so that work...
asked 22 minutes ago -
Python Program: Design the logic for and implement a program
that merges the two files into...
asked 20 minutes ago -
The specific radiocarbon activity of a sample of wood is 6.25
gms dpm/gm of carbon. The...
asked 25 minutes ago -
An aqueous magnesium chloride solution is made by dissolving
6.96 moles of MgCl2 in sufficient water...
asked 28 minutes ago -
Ken believes the average age of men who come to get a haircut at
his barber...
asked 50 minutes ago -
(Ratio Analysis): Last year Co. XYZ had sales of $ 400,000, with
“cost of goods sold”...
asked 58 minutes ago -
can someone please write the balanced chemical
equation for the synthesis of Bromoacetanilide
from;
aniline +...
asked 54 minutes ago -
1. If a corporation purchases land and building and subsequently
tears down the building and uses...
asked 1 hour ago -
Consider a 23-year bond with 7 percent annual coupon payments.
The market rate (YTM) is 6.4...
asked 1 hour ago