Please answer the question below for all parts. Please show all work and write clearly. Thanks
A sender needs to send out 5 numbers (3, 11, 12, 9, 7). Answer the following:
Please answer the question below for all parts. Please show all work and write clearly. Thanks...
Please answer the question below for all parts. Please show all work and write clearly. Thanks. (You may use Excel or Matlab to make the calculations easier, but must show work and code). What is the maximum quantization error for an A/D converter with 14 bits of resolution assuming a voltage range of +/- 10 V?
Please answer the problem below for all parts . Please show all work and write clearly. Thanks.
Please answer the question below for all parts. Please show all work and write clearly. Thanks. (You may use Excel or Matlab to make the calculations easier, but must show work and code). A 1 kHz sine wave is sampled at frequency of 5 kHz. (a) What is the Nyquist frequency of the sampling system in this case? Show your work. (b) What is the Nyquist rate of the signal? Show your work. (c) Is the signal properly sampled; that...
Please answer the problem below for all parts . Please show all work and write clearly. The answers are below, but work must be shown to get to the answers. Thanks. answers 8.14. Design a second-order digital bandpass Chebyshev filter with the following specifications: Center frequency of 1.5 kHz Bandwidth of 200 Hz 0.5 dB passband ripple Sampling frequency of 8,000 Hz a. Determine the transfer function and difference equation. 8.14 a. 0.1815-0.1815z2 1-0.6265z +0.6370z y(n)-0.1815x(n)-0.1815x(n-2)+0.6265y(n1) 0.6370y(n-2) 8.14. Design a...
Please answer the below question for all parts. Please show all work and write clearly. Using Minitab and Excel is optional, but if you can please do. Thanks! 1. Injection Molding: Many manufacturing companies in the United States and abroad use molded parts as components of a process. Shrinkage is often a major problem. Thus, a molded die for a part is built larger than nominal size to allow for part shrinkage. In an injection molding study it is known...
Please answer the problem below for all parts . Please show all work and write clearly. Thanks. (a) (0) What is the difference between an autotransformer and a conventional transformer? 2. (ii) Why are high-impedance transformer used in electric toys? (b) Three single-phase transformers each rated at 150 kVA, 7200 V/600 V, 60 Hz, are connected in wye-delta on a 12470 V, 3-phase line. If the load is 450 kVA, calculate the followings: (i) The current flowing in the incoming...
Please do all parts and write your answer clearly. thanks! 6. a. Prove that there is a finite field E with 729 elements and provide the quotient ring that is isomorphic to E. b. Draw the lattice of subfields for E.
Please answer the problem below for all parts. Please show all work and write clearly. Thanks. The gain equation is then Using an AD620 Instrumentation Amplifier and the bridge shown below and the table shown below for 0 to 100°C (AD620 specifications online) 4. 49.4k2 What gain and AD620 Gain Resistor is needed to produce an output of 0 to 3.3 volts for input to the ADC of a microcontroller? Show the circuit you would use, including the connections RG...
I'm lost on part b, please show all work/steps & write clearly please thanks!
Please write clearly and show work. Thanks! Find the average rate of change for the given function f(x)x+11x between x0 and x 5 The average rate of change is (Simplfy your answer.)