Find the following for an input of 120 VAC(RMS), 60 hertz, given
a 20:1 stepdown transformer. The secondary is less voltage than the
primary. Rload is 100 ohms. Round off to the nearest tenths
place.
1a: Primary or input peak voltage =
1b: Secondary peak voltage =
1c: Primary peak current =
We need at least 10 more requests to produce the answer.
0 / 10 have requested this problem solution
The more requests, the faster the answer.
Find the following for an input of 120 VAC(RMS), 60 hertz, given a 20:1 stepdown transformer....
O Modules S Agile Product Life y erse... ROADP $ Nevlersey local N. G Google a Northersey Nev. Pages. Welcome. me t Question 3 6 pts (TCO 1) Find the following for an input of 120 VAC(RMS), 60 hertz, given a 15:1 stepdown transformer and a full-wave bridge rectifier. Rload is 82 ohms. Round off to the nearest tenth place. 1a: Primary or input peak voltage - 1b: Secondary peak voltage - 1c: Peak voltage out of the rectifien id:...
TCO 2) For the circuit below, if Vcc is 28 volts and Rb is 4.7k ohms, find the base and collector voltages and currents for an input of OV and 5V. Beta 300, the motor resistance is 400 ohms. AG1 NI MOTOR SERVO Vin N Yout Rb 1a: When Vin OV, find: lb = Ic = Vbase Vcol 1b: when Vin 5V, find: IC Vbase HTML Editor Question 6 7 pts TCO 1) Find the following for an input of...
For the block diagram below, find the following if Vsecondary =
36Vrms, 60 Hz, and Rload = 150 ohms. Round off to the tenths
place.
i. Peak Voltage out of the Diode Bridge:
ii. DC Voltage out of the Diode Bridge with no filter
capacitor:
iii. DC Load Current
On/off ...Switch T2 DI UE J? .. . uSE Vltage AC input PlugTransforrmerBridgeCapacitorRegutator Fuse StepDownDiodeFilter
5. We might power a Crooke's tube using a Tesla coil transformer with 20 turns on the primary; 10,000 turns on the secondary, using 2.0 A from a 6 VAC 60 Hz sine wave source to the primary. a) what RMS voltage would occur across the secondary? b) what would the peak voltage from the output? c) what current would flow in the secondary?
5. We might power a Crooke's tube using a Tesla coil transformer with 20 turns on the primary; 10,000 turns on the secondary, using 2.0 A from a 6 VAC 60 Hz sine wave source to the primary. a) what RMS voltage would occur across the secondary? b) what would the peak voltage from the output? c) what current would flow in the secondary?
A transformer has 500 primary turns and 2200 secondary turns. The input voltage is 120 v and the output current is 15.0 A. What is the output voltage and input current assuming 100 percent efficiency?
An ideal transformer has the next nominal values: 20 kVA, 480/120 v, 60 Hz. The primary winding has a power supply of 240 V connected. The secondary winding powers a 6 A charge with a power factor of 0.85 forward. Calculate: a) The voltage on the secondary winding expresed in per unit. b) The impedance of the charge in per unit. c) The impedance of the charge refered to the primary, in ohms. d) Active and reactive power, in W...
Problem 1: The secondary winding of a transformer has a terminal voltage of v, (t) 282.8 sin 377t V. The turns ratio of the transformer is 100:200 (a0.50) The impedances of this transformer referred to the primary side are The equivalent circuit is shown below lf (a) If the secondary current of the transformer is i,()-7.07sin(3771-36.87) A, what is the primary current of this transformer? (20 points) HINTS: I. Peak values of the secondary voltage and current are specified in...
Given an input voltage of 120VAC (RMS) +/- 1% mains voltage with 60 Hz frequency (plugged into your wall), design a rectifier circuit that outputs +9V and -5V (account for diode voltage drop). The output voltages should be within +/- 5% of their specification (including peak-peak voltage ripple) with a load of up to 40 mA on the +9V supply and 20 mA on the -5V supply. (6 points) Show circuit diagram of design. For transformer, simply specify turns ratio(s)....
4.70 A full-wave bridge-rectifier circuit with a 500-22 load operates from a 120-V (rms) 60-Hz household supply through a 6-to-1 step-down transformer having a single Secondary winding. It uses four diodes, each of which can be modeled to have a 0.7-V drop for any current. What is the peak value of the rectified voltage across the load? For what fraction of a cycle does each diode conduct? What is the average voltage across the load? What is the average current...