a-Calculate the maximum frequency deviation for the FM signal
v(t)= 5 cos(6000t+ 4sin2π.200t)
b-What is the modulation index. Is it a NBFM or WBFM
c-Calculate the transmission bandwidth by using Carson’s rule.
d-What are the significant frequencies of the transmitted signal.
a-Calculate the maximum frequency deviation for the FM signal v(t)= 5 cos(6000t+ 4sin2π.200t) b-What is the...
Q2 The output signal of an angle modulator is given as V(t) = 6 cos(2000000net + 40 cos(2000xt) + 15cos (400nt)) (v) Determine the following: The average power of the signal. b) The carrier frequency of the signal. The instantaneous frequency of the signal. d) The instantaneous maximum frequency deviation of the signal. e) The wavefom of the message signal, assuming a frequency modulation (FM). f) The modulation index, assuming a FM. Is it a broadband FM or narrowband FM...
Question 4: (20 points) An FM signal is modulated with message m(t)Am cos(2Tmt). The measured amplitude spectrum, SPM(f), is shown below: Amplitude spectrum of the frequency modulated signal 2 -2 5000 4000 3000 2000 -1000 1000 2000 3000 4000 5000 frequency f [Hz] a) What is the carrier frequency fe? b) What is the message frequency fm c) What is the FM modulation index Bf? Is it a narrowband or a wideband signal? d) Using Carson's rule, estimate the transmission...
Consider frequency modulation with a sinusoidal message signal (tone modulation) m(t) = a cos(2πfmt). The modulated signal is: vFM(t) = Ac cos[2πfct + βf sin(2πfmt)]. with βf = kfa/fm being the modulation index. What is the bandwidth of the modulated signal.
Consider frequency modulation with a sinusoidal message signal (tone modulation) m(t) = a cos(2πfmt). The modulated signal is: vFM(t) = Ac cos[2πfct + βf sin(2πfmt)]. with βf = kfa/fm being the modulation index. What is the bandwidth of the modulated signal.
Prob. 3 An FM modulator output signal is given by Prm 5 cos(2nft + 2nk, m(t)dr). where k, = 30 H2/V. Assume that the message signal is the rectangular pulse m(1) = 8rect «- 2) (a) Sketch the phase deviation in radians. (b) Sketch the frequency deviation in Hz. (c) Determine the peak frequency deviation in Hz. (d) Is this NBFM or WBFM?
a. For the wideband FM signal given by SFM(t) = cos[2πfct+ 3sin2π25t], draw only positive side of the spectrum, (from n=-5 to n=+5). Assume the carrier frequency (fc) of 1 KHz. Hint: First calculate β by comparing the signal with SFM(t) equation b. The FM signal of part (a) is passed through a bandpass filter centered at 1 KHz with a bandwidth of 210 Hz, as shown below. Draw the new spectrum and calculate the bandwidth and power of the filtered FM...
below is used to modulate a carrier to generate the AM signal yt) (Am()) cos(1000t) The periodic signal m() shown a) The power efficiency of the system is measured to be 1 () The type of AM modulation, i.e. SSB, DSBSC, (i) The constant A. (ili) The modulation index 1/13. Determine DSB with carrier enit -3 b) An angle modulated signal is given by d(t-2 cos (2n1061+ sin 2 1000). Find i) The carrier frequency. ii) The baseband signal bandwidth....
Prob. 5 (a) Consider the FM signal with modulation index B 2 is passed through an ideal band-pass filter (BPF) with mid-band frequency f and bandwidth 5f. where f is the carrier frequency and fmis the frequency of the baseband modulating signal (i) Sketch the spectrum of the BPF output. (ii) Determine the fraction of the power of the FM signal that is present at the output of the filter (b) Consider the FM signal given by фFM (t)-100 cos...
Consider a FM system that is used to communicate the following message signal: S. m(t) 20 0.05 0.1 015 10 -0.05 with a frequency deviation constant ky 10, and a message bandwidth of W =15 kHz the one-sided noise power-spectral density in the transmission channel is No= 10-8 W/Hz, and an attenuation of 10 is introduced during transmission in the channel as well. a. What is the average-to-peak-power ratio of the message (or, equivalently the power content of the normalized...
Consider a FM system that is used to communicate the following message signal: S. m(t) 20 0.05 0.1 015 10 -0.05 with a frequency deviation constant ky 10, and a message bandwidth of W =15 kHz the one-sided noise power-spectral density in the transmission channel is No= 10-8 W/Hz, and an attenuation of 10 is introduced during transmission in the channel as well. a. What is the average-to-peak-power ratio of the message (or, equivalently the power content of the normalized...