Hi,
Hope you are doing well.
Note: I have provided the density of the liquid in various units. You can Choose your choice.
We know that, Density of a fluid is given by,
Where,
is mass of
the fluid .
is the volume of the
fluid .
Given that,
Mass of the fluid,
Volume of the fluid,
Density of a
fluid is given by,
Hope this helped for your studies. Keep learning. Have a good day.
Feel free to clear any doubts at the comment section.
Please don't forget
to give a thumbs up.
Thank you. :)
18. Find the weight density (in lb / in3) of a block 5.00 in by 7.50 in x 9.00 in. that weighs 750. lb.
Consider a typical adult weighing 165.0 lb and possessing a density of 819.0 kg/m3. How low will the chamber need to drop in pressure at minimum to measure the person\'s density if the weight scale can only measure to the nearest 0.20 lb? (Assume air is an ideal gas and the chamber is maintained at standard temperature as the air is evacuated. The density of air at sea level is roughly 1.22 kg/m3.)
a 4.00 lb weight stretches a certain spring 0.500 ft. With this weight attached, the spring is pulled 3.00 inches longer than its equilibrium length and released. Find the equation of the resulting motion, assuming no damping. y=?
An engineer is going to redesign an ejection seat for an airplane. The seat was designed for pilots weighing between 140 lb and 181 lb. The new population of pilots has normally distributed weights with a mean of 145 lb and a standard deviation of 30.3 lb. a. If a pilot is randomly selected, find the probability that his weight is between 140 lb and 181 lb.The probability is approximately _______ (Round to four decimal places as needed.)
A conical container of radius 6 ft and height 24 ft is filled to a height of 20 ft of a liquid weighing 62.4 lb/ft. How much work will it take to pump the contents to the rim? How much work will it take to pump the liquid to a level of 4 ft above the cone's rim? The amount of work required to pump the liquid to the rim of the tank is ft-lb. (Round to the nearest whole...
The following is the result from the determination of the density of a liquid using the graphical procedure from Lab 1. What is the volume of 10.0 g of the liquid? Report answer with correct sig figs and units. Determination of Density for an unknown Liquid 8.0000 Mass (8) 6.0000 4.0000 2.0000 y = 1.0247x -0.0093 R? = 1 o 0 1.00 2.00 5.00 6.00 3.00 4.00 Volume (mL)
Q1. The beam below has two forces (loads) applied Fi and F2 each weighing 38 lb. The support at D is fixed and cable BE is attached to the weight W. Find the reaction at point D when (a) W 85 lb (b) W=95 lb
an engineer is going to redesign an ejection seat for an airplane the seat was designed for Pilots weighing 150 lb and 191 lb the new population of Pilots has normally distributed weights with a mean of 158 lb and a standard deviation of 33.9 pounds if a pilot is randomly selected find the probability that his weight is between 150 lb and 191 lb ..the probability is approximately ? If 33 different Pilots are randomly selected find the probability...
A cylindrical buoy weighing 100 lb (thus of mass m=3.125 slugs in ft-lb-s (fps) units) floats in water with its axis vertical. When depressed slightly and released, it oscillates up and down four times every 10 s. Find the radius of the buoy.
Given the following information, calculate the density in g/mL of an irregular solid. Mass of weighing vessel 1.005g Mass of solid + weighing vessel 9.441g Volume of liquid in graduated cylinder 3.45 mL Volume of liquid in graduated cylinder + volume of solid 5.15 mL