Please show work legible and clear. Diagrams Math NEEDED.
Imagine that you have a small positive charge sitting between two fixed positively charged plates. The small charge starts at rest and is sitting exactly at the midpoint between the two plates. Explain what happens to the small charge and why. Next, you start with the same initial setup, but give the small charge a slight nudge. Again, explain what happens to the charge and why.
Please show work legible and clear. Diagrams Math NEEDED. Imagine that you have a small positive...
Suppose you have a glass tube with metal plates at the ends, which are connected to wires leading outside the tube. The air has been removed from the interior of the tube leaving a very good vacuum. There is a positively charged particle initially sitting at rest between the two plates. See the accurate diagram below. A positively charged rod is brought in contact with the left hand wire. What, if anything, happens to the charged particle? Explain your answer...
Why is it important to use very small objects such as the polystyrene spheres in order to perform the lab? What is it that causes the polystyrene spheres to become electrically charged as they leave the atomiser? Is it theoretically possible for an object to have a charge of 4.00 x 10-19 C? Explain why or why not. Suppose the separation between charged plates is 4.00 mm, the voltage of the plates is 200.0 V, and that the charge on...
3.1 Pre-lab In the lab on electric potential and electric field lines, you noted that charged par- ticles produce electric fields and these electric fields, in turn, act on charged par- ticles. However, you then proceeded to produce an electric field geometry using conductors held at a particular electric potential. What happened to the electric charges? Electric charge and electric potential are closely related to each other. Putting charge on a conductor raises its electric potential. It is usually much...
No need to fully answer each question but could someone please give me a brief run down of what is supposed to happen in all three of those scenarios? Wad a small amount of aluminum foil into a ball about 3 cm in diameter and suspend it from a piece of thread about 30 cm long. 1. Tape the loose end of the thread to a support so that the ball hangs freely at a reachable height which is at...
Can you please check my work and explain everything, I'm a little unsure Map the Electric Field Created by Differently Shaped Electric Plates What is the voltage (change in electric potential) between the two terminals in your experiment? How much work is done in transferring a unit of charge (an electron) from one terminal to the other in this experiment? Does the geometry of the terminals affect the shape of the equipotential lines? Explain why or why not. Yes, because...
1. Parallel plates. You have two equal but oppositely charged parallel conducting plates, separated by 10 cm. A voltmeter shows that the potential difference between the plates is 500 V. (a) Which is at a higher potential, the positive or negative plate? (b) How big is the electric field between the plates? (c) You let go of an electron next to the negative plate. How much work does the electric field do in moving the electron to the positive plate?...
(please show work for each step) You own a small networking startup. You have just received an offer to buy your firm from a large, publicly traded firm, JCH Systems. Under the terms of the offer, you will receive 1 million shares of JCH. JCH stock currently trades for $24.11 per share. You can sell the shares of JCH that you will receive in the market at any time. But as part of the offer, JCH also agrees that at...
please and please answer completion4, completion5, and completion6 also please try to make it clear for my understanding thank you very much in advance 2.3 Chasing and Colliding Have you ever seen a collision in a computer game? Right silly question. That's most of what happens. Collislons (and avolding them) are critically important in computer graphics, robotics, self-driving cars, automatic lawn mowers, and countless other applications. Suppose we have two robots whose positions are glven by (t and x(). The...
PLEASE SHOW WORK AND ANSWER ALL PARTS. WHEN I ASKED THE SECTIONS SEPARATELY THE ANSWERS DID NOT MATCH, THANK YOU!!! All of the questions on this concern a space station, consisting of a long thin uniform rod of mass 4.4 x 106kg and length 171 meters, with two identical uniform hollow spheres, each of mass 1.3 x 106 kg and radius 57 meters, attached at the ends of the rod, as shown below. Note that none of the diagrams shown...
the concentration is .1000 M for NaOH. you cN disregard the second column. but there is no further information. equivalence point is 22.95. i dont have mL NaOH this is all i have DATA TABLE sor CHCOOH Trial Volume CHCOOH (ml) [NTOH (M) Equivalence point Md point (ML) (ml) NE 100CM 1000M a.so DATA ANALYSIS moles -(CX) 1. Calculate the number of moles of NaOH used in the reaction with the acetic acid (CH.COOH) solution . OOON NaoH 2. How...