A pressure cooker is a covered pot sealed everywhere except for a small circular opening in the top. A small weight placed over this opening determines the pressure at which steam is released from the pot. Suppose that the radius of the opening is 0.488 mm and the weight is 0.768 N. Find the maximum pressure inside the pot.
A pressure cooker is a covered pot sealed everywhere except for a small circular opening in...
A pressure cooker is a covered pot sealed everywhere except for a small circular opening in the top. A small weight placed over this opening determines the pressure at which steam is released from the pot. Suppose that the radius of the opening is 0.542 mm and the weight is 0.838 N. Find the maximum pressure inside the pot.
A pressure cooker is a pot whose lid can be tightly sealed to prevent gas from entering or escaping. If an otherwise empty pressure cooker is filled with air of room temperature and then placed on a hot stove, what would be the magnitude of the net force F120 on the lid when the air inside the cooker had been heated to 120C ? Assume that the temperature of the air outside the pressure cooker is 20C(room temperature) and that...
spring relief disk 3. (40 pt.) A pressure cooker cooks a lot faster than an ordinary pan by maintaining a higher pressure and temperature inside. The lid of a pressure cooker is well sealed, and steam can escape only through an opening in the middle of the lid. The pressure relief valve consists of a spring-loaded disk that is positioned over this opening. Consider that a certain portion of a pressure cooker is initially filled with water and put on...
spring relief disk 3.(40 pt.) A pressure cooker cooks a lot faster than an ordinary pan by maintaining a higher pressure and temperature inside. The lid of a pressure cooker is well sealed, and steam can escape only through an opening in the middle of the lid. The pressure relief valve consists of a spring-loaded disk that is positioned over this opening. Consider that a certain portion of a pressure cooker is initially filled with water and put on top...
1. Procedure A. Lithium 2,6-dimethylphenoxide. In a 300-ml. flask, equipped with a magnetic stirrer and a reflux condenser and flushed with nitrogen, are placed 150 ml. of toluene (freshly distilled from sodium), 1.40 g. (0.202 mole) of lithium metal (Note 1) and 25.0 g. (0.205 mole) of resublimed 2,6-dimethylphenol. The mixture is heated under reflux with stirring for 36 hours; a nitrogen atmosphere is maintained for the reflux period (Note 2). The condenser is replaced by a distillation head with...
summatize the following info and break them into differeng key points. write them in yojr own words apartus 6.1 Introduction—The design of a successful hot box appa- ratus is influenced by many factors. Before beginning the design of an apparatus meeting this standard, the designer shall review the discussion on the limitations and accuracy, Section 13, discussions of the energy flows in a hot box, Annex A2, the metering box wall loss flow, Annex A3, and flanking loss, Annex...