Question

The mass of a discus is 2 kg and its radius of gyration about the spin...

The mass of a discus is 2 kg and its radius of gyration about the spin axis is 0.1 m. During a throw, the average net torque exerted on the discus about the spin axis is 50 Nm.
(a) If the discus is not spinning at the start of the throw, and the torque is applied for
0.2 s, how fast is the discus spinning when it is released?
(b) The discus hits the ground 3 seconds later. How fast will the discus be spinning just before landing (ignore air resistance)?
(c) When the discus hits the ground, the ground applies a net torque of 200 Nm about the spin axis. How long will it take for the discus to stop spinning?
0 0
Add a comment Improve this question Transcribed image text
Know the answer?
Add Answer to:
The mass of a discus is 2 kg and its radius of gyration about the spin...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions
  • A 7.5-kg wheel, with a radius of 0.3 m and a radius of gyration about point...

    A 7.5-kg wheel, with a radius of 0.3 m and a radius of gyration about point O ko 0.25 7.5-kg wheel, with a m is initially at rest (to 0) when a force P 10 2t2 IN] is applied to the cord wrapped around its perimeter, where t is in seconds (see Figure ). Four seconds after the wheel stars spinning (t14 s), a constant braking moment of Mb 25 Nm is applied to the wheel. Determine the angular velocity...

  • The 50-kg flywheel has a radius of gyration about its center of mass of ko= 250mm....

    The 50-kg flywheel has a radius of gyration about its center of mass of ko= 250mm. It rotates with a constant angular velocity of 120rev/min before the brake is applied. If the coefficient of kinetic friction between the brake pad B and the wheel’s rim is ?k= 0.5, and a force of P = 300 N is applied to the braking mechanism’s handle, determine the time required to stop the wheel. 0.5 m 1 m 0.2 m 0.3 m

  • 2. A brav e 90 kg man, named Steve, agrees to give a Gravitron a test...

    2. A brav e 90 kg man, named Steve, agrees to give a Gravitron a test ride for the first time. The Gravitron has a diameter of 10 m. It is programed to spin faster and faster until it achieves ution in 15 s. Once it maintains this speed, the floor of the Gravitron lowers itself, s. Once it leaving the riders to hang in midair. raw a picture and an FBD of Steve as if you are looking at...

  • Angling for a New Idea Conservation of L A) I Spin while holding two dumbbells close...

    Angling for a New Idea Conservation of L A) I Spin while holding two dumbbells close to your body with your arms folded, spin around on the ro- tating chair (be sure your feet are not touching the chair or ground). Next quickly push the dumbbells straight out to arm's length When you moved the dumbbells away from your trunk, was there a net torque applied to the system (you + rotating chair + dumbbells)? Explain whether or not and...

  • A wheel-axle assembly is attached to a spring as shown in the figure below. The wheel-axel assembly has a mass of m=3 kg and a radius of gyration about the polar axis of kG=75mm. The spring has a stiffness of k=0.5 kN/m ( Note the units!). The system i

    A wheel-axle assembly is attached to a spring as shown in the figure below.  The wheel-axel assembly has a mass of m=3 kg and a radius of gyration about the polar axis of kG=75mm.  The spring has a stiffness of k=0.5 kN/m ( Note the units!).  The system is released from rest with a spring extension of x1=0.2 m.  Calculate the maximum angular velocity. Assume friction can be ignored. Provide your answers in rad/s.

  • positive direction) Multiple Choice 15% each! 1. A solid uniform sphere of mass 1.85 kg and...

    positive direction) Multiple Choice 15% each! 1. A solid uniform sphere of mass 1.85 kg and diameter 45.0 cm spins about an axle through its center. Starting with an angular velocity of 2.40 revisit stops after turning through 18.2 rev with uniform acceleration. The net torque acting on this sphere as it is slowing down is dosest to (A) 0.0466 Nm (B) 0.00593 Nm (C) 0.0620 Nm (D) 0.149 Nm (E) 0.0372 Nm 2. If the torque on an object...

  • A child pushes her friend (m = 25 kg) located at a radius r = 1.5...

    A child pushes her friend (m = 25 kg) located at a radius r = 1.5 m on a merry-go-round (rmgr = 2.0 m, Imgr = 1000 kg*m2) with a constant force F = 90 N applied tangentially to the edge of the merry-go-round (i.e., the force is perpendicular to the radius). The merry-go-round resists spinning with a frictional force of f = 10 N acting at a radius of 1 m and a frictional torque τ = 15 N*m...

  • Solve exactly if possible. Express all decimals to 4 significant figures. 1) 2) 3) 4) 5)...

    Solve exactly if possible. Express all decimals to 4 significant figures. 1) 2) 3) 4) 5) 6) 7) What are Newton's Laws of motion? What is a "frame of reference"? What is a coordinate system? Express the point x-3, y-4 using polar coordinates. What is the SI unit for force? How is it defined using SI base units? What are the four fundamental forces in the universe? What is the approximate gravitational acceleration, g, near the Earth's surface? If this...

  • 2) The Oasis of the Seas has a mass of 10° kg and is floating tionless in the ocean. You are stan...

    2) The Oasis of the Seas has a mass of 10° kg and is floating tionless in the ocean. You are standing on its rear deck. You take a 0.15 kq baseball out of your pocket and throw it from the rear deck. away from the ship with a velocity of 30 m/s (about 60 mph) at an angle of20° above the horizontal. 10 pts) How fast does the Oasis move (horizontally) and in what direction? Do not consider any...

  • Work out the highlighted questions (3-6) clearly and with units, please. Thanks! 4/5 a the minimum...

    Work out the highlighted questions (3-6) clearly and with units, please. Thanks! 4/5 a the minimum kinetic energy at the apping point? (C) Use conservation of energy to determine the minimum angular velocity of the block just after the collision, (d) then use conservation of angular momentum during the collision to find the initial speed of the bullet vo. (Hint: Ignore the mass of the bullet after the collision. The moment of inertia of the cube about its bottom-right edge...

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT