i) The telephone line has 3400 Hz bandwidth. What is the maximum bit rate we can send using each of the following methods? Assume d=0 and no noise:
ii) Calculate the bit rate for the given baud rate and type of modulation:
i) The telephone line has 3400 Hz bandwidth. What is the maximum bit rate we can...
Data communication Qs A signal has a bandwidth frequency of 150 Hz and the highest frequency is 170 Hz. What is the lowest frequency of the signal? (just put the whole number. No decimal values. No units next to the number) A periodic signal completes one cycle in 0.04 second. What is the frequency? A sine wave completes 7200 cycles in one hour. What are its frequency and period? I: 50 Hz, II: 10 Hz, 0.1 seconds I: 25 Hz,...
Question 4 (a) A 3,000 bit/second data terminal is connected to a modem with 25% raised-cosine roll-off pulse shaping is used. Calculate the transmission bandwidth Bt required at the modem output for each of the following schemes: (0) Binary amplitude-shift keying (ASK) transmission. [2 marks] (ii) Binary frequency-shift keying (FSK) transmission with a frequency deviation of +2,400 Hz around the carrier. [2 marks] (iii) 16-level quadrature amplitude modulation (QAM). [2 marks] (b) FSK transmission is used to transmit 750 bps...
3. (20 points) The local spatial average of a power delay profile is shown in the following figure. We assume that the coherence bandwidth is approximated by B and the coherence time is estimated using the popular rule of thumb for modern digital communications. Pr(r) -10 dBm -20 dBm -30 dBm 0 5 10 excess delay r rs) If a baseband message with a bit rate R, 400 kbps is modulated by an RF carrier frequency of 5.8 GHz and...
Q1: You can find a file that defines the CircularlyLinked List class similar to what we discussed in the class. Download the file and work on it. Your task is to: 1. Complete the missing methods in the file as discussed in the class. Search for the comment/" MISSING / in the file to see the methods that need to be completed. 2. Add the following methods to the class a. public Node getMin 1. Task: find the node with...
check my answers for Networking I came up with these answers, can check my answers Question 1: General What data rate is needed to transmit an uncompressed 4" x 6" photograph every second with a resolution of 1200 dots per inch and 24 bits per dot (pixel)? 691,200 kb/s 28.8 kb/s 8.29 Mb/s 829 Mb/s Question 2: Layering "Layering" is commonly used in computer networks because (check all that apply): -It forces all network software to be written in ‘C’....