(a) 1 ns (b) 2 ns (c) 1µs (d) 0.5 ns
Consider a signal with a maximum frequency of 500 MHz. In order to avoid loss of...
Consider a superheterodyne receiver designed to receive the frequency band 1 to 30 MHz with IF frequency 10 MHz. The local oscillator generates frequencies such that the ratio between the maximum and the minimum generated frequency is the smallest. a) What is the range of frequencies generated by local oscillator for this receiver? b) An incoming signal with carrier frequency 6 MHz is received at 6 MHz setting. At this setting we also get interference from a signal with some...
an expression nM() for an AM signal with a carrier frequency of 2 MHz that conveys a 1. (a) Write down sine wave message whose frequency is 2 peak-to-peak amplitude is 70 Volts. 500 Hz. The AM signal's modulation index is 0.75 and its (b) Compute the power efficiency n of this signal.
My real-world signal has frequency components that extend into the MHz range, however I am most interested in a signal that occurs near 100 kHz. Also, my AtoD has a max sampling rate of 1 MHz. What type of analog filter will I apply to this signal to avoid aliasing? Can you recommend a particular filter design, knowing that I am more interested in spectral content than a time-domain analysis?
5. Consider the following message signal: m(t) -2 .3 10 Assume that the carrier frequency is f are kf = 105, kp-25 respectively. 108 Hz, and frequency and phase deviation constants Find the maximum and minimum frequency deviation for FM, and sketch the FM wave for a duration of 103 seconds shown in the above figure (5 points). a. b. Find the maximum and minimum frequency deviation for PM, sketch the PM wave for a duration of 103 seconds shown...
Find the instantaneous frequency of the next signal at t = 4. (a) x(t) = 10 cos[20xt+10 sin(t/4)) (b) x(t) = 262719) () X(t)=10[cos(2nt) cos(atº/4) + sin(24t) sin( nt/ 4)] Suppose that the information signal is as shown in the following figure. When each modulating this signal using 100KHz as the carrier frequency, find the frequency shift and phase shift when FM is modulated with 5,=10. What is the maximum frequency shift and maximum phase shift? 0.5+ -0.5 ost Suppose...
7) If f1= 5MHz and f2=7 MHz, find: a. 2nd order harmonics. b. 3rd order harmonics. c. 3rd order inter-modulation products (IMD) 8) In a superheterodyne receiver, the input RF frequency is 1 GHz. Find the IF frequency if the local oscillator frequency is 950 MHz? 9) Rank from 1 to 3 for linearity and efficiency with 1 as the most linear and most efficient. Class of amplifier Linearity Efficiency Class A Class B Class C 10) Which of the...
An FM signal has an intelligence frequency of 5 KHz, a maximum deviation of 30 KHz, and a carrier frequency of 162.4 MHz. Use the Bessel Function chart to answer the following: a) Its bandwidth b) How many frequency components are there in the output spectrum? c) What is the frequency of the highest frequency component within its bandwidth?
A sinusoidal signal of amplitude 1 V and frequency of 1 MHz is measured by means of a direct measurement frequency meter that uses a measurement time Tg = 0.1 s. What is the quantization uncertainty?
2) KERA radio transmits at a frequency of 90.1 MHz. The station broadcasts its signal with a power of 100 MW a) What is the wavelength of this radio station's radio signal? b) Assume that KERA broadcasts omnidirectionally (it doesn't, really). Knowing this, what is the intensity of the radio signal for KERA received by a radio a distance of 34.2 kilometers from the broadcast tower? What is the strength of the electric and magnetic fields of the radio signal...
Q2.) Consider the sampling of the continuous-time signal x(t) to obtain a discrete-time signal x[n (1)-10cos(1000m + π/3) + 20cos(2000m + π/6). 110points! ], where x a) What is the maximum sampling interval (minimum sampling frequency) that could be used to ensure an aliasing free sampling of this signal? b) Plot the spectrum of the sampled signal if x() is sampled using a sampling frequency of (i) 2500 Hz (ii) 1800 Hz and state whether there will be an aliasing...