A copper hot water pipe (outer diameter ½”) has an exterior temperature of 49oC. For insulation,it...
A copper hot water pipe (outer diameter ½”) has an exterior temperature of 49oC. For insulation,it is wrapped in polyethylene foam that is ½” thick. If the pipe is 12 feet long and runs through a utility room whose temperature is 7oC
Find the rate at which heat is lost through the insulation. Polyethylene foam has a thermal conductivity of 0.024W/(m·K) (Hint: use the outer surface area of the insulation)
Homework Answers
Add Answer to:
A copper hot water pipe (outer diameter ½”) has an exterior
temperature of 49oC. For insulation,it...
Problem 1. Steam at 120°C is transported in a long 8" outer diameter pipe. Its outer surface is c...
Problem 1. Steam at 120°C is transported in a long 8" outer diameter pipe. Its outer surface is covered with a 1" thick fiberglass (thermal conductivity, 0.05 W/(mK)) insulation. When the outer temperature is 0°C, the rate of condensation of steam is measured to equal 0.06 g per meter of the pipe length. Estimate the heat transfer coefficient. The heat of vaporization of the steam is 2600 J/g. The resistance to the heat transfer through the pipe wall may be...
Al m diameter sphere is exposed to an en covered with a layer of insulation 2.5...
Al m diameter sphere is exposed to an en covered with a layer of insulation 2.5 cm thick whose thermal conductivity temperature of the sphere on the inside of the insulation is 315ºC. Assuming emissivity of 0.9, compute the value of the conve 's compute the value of the convection heat transfer coefficient that must be maintained on the outer surface of the insulation to ensure that the outer surface not exceed 41°C. exposed to an environmental temperature of 28°C....
Exercise 10 Consider a 2-m-high electric hot water heater that has a diameter of 40 cm...
Exercise 10 Consider a 2-m-high electric hot water heater that has a diameter of 40 cm and maintains the hot water at 55°C. The tank is located in a small room whose average temperature is 27°C, and the heat transfer coefficients on the inner and outer surfaces of the heater are 50 and 12 W/m2.°C, respectively. The tank is placed in another 46-cm-diameter sheet metal tank of negligible thickness, and the space between the two tanks is filled with foam...
Hot CO2 gas at a temperature T-1 = 250°C is flowing through a steel pipe (kı...
Hot CO2 gas at a temperature T-1 = 250°C is flowing through a steel pipe (kı = 70 W/(m.K)) whose inner and outer radiuses are 12 cm and 14 cm, respectively, in a cold environment at Tm2 = -10°C. As shown in the figure below, the steel pipe is insulated with 7.0 cm thick spray-foam insulation (k2 = 0.03 W/(m.K)) and 5.0 cm thick glassfiber insulation (k3 = 0.05 W/(m.K)). Consider the heat transfer coefficients of CO2 gas and the...
Consider a 2-m-high electric hot-water heater that has a diameter of 40 cm and maintains the...
Consider a 2-m-high electric hot-water heater that has a diameter of 40 cm and maintains the hot water at 60 C. The tank is located in a small room at 20°C whose walls and ceiling are at about the same temperature. The tank is placed in a 44-cm-diameter sheet metal shell of negligible thickness, and the space between the tank and the shell is filled with foam insulation. The average temperature and emissivity of the outer surface of the shell...
Problem : A cryogenic flui d is flowing in a 304 SS pipe. The pipe is...
Problem
:
A cryogenic flui
d is flowing in a
304 SS
pipe.
The pipe is insulated
on its outside surface
with
6
-
mm thick,
evacuated,
aluminum foil/glass mat insulation.
(“Evacuated” means a partial vacuum is drawn on the
insulation to
remove air that would otherwise fill
pores inside the insulation.)
The pipe
inside diameter
is 127 mm; it’s outside diameter is 138 mm.
The
fluid temperature is
-
173
o
C
.
T
he
air temperature
outside the...
A pipe with insulation material is used to carry steam to an operating plant. The conditions...
A pipe with insulation material is used to carry steam to an operating plant. The conditions and dimensions for the system are as follows Variable Value Length of pipe, L 100 ft Inner diameter of pipe, Do 1 inch Outer diameter of pipe, D1 1.24 inches Outer diameter of insulation, D2 2 inches Inside film heat transfer coefficient for condensing saturated steam, ho 800 Btu/hr-ft2.oF Outside film heat transfer coefficient for air, ht 2 Btu/hr-ft2.oF Thermal conductivity of the pipe,...
Question 3 34 pts ro 1 ri = 0.05m A pipe with surface temperature T1 -...
Question 3 34 pts ro 1 ri = 0.05m A pipe with surface temperature T1 - 458 K is wrapped with 0.04 m of glass fiber pipe insulation. The outer surface temperature of the insulation, T2 is equal to 347 K and its emissivity is equal to 0.68. The insulation is also subject to natural convection with a bulk fluid temperature of 298 K and h = 4 W/m2-K. For a pipe length of 100 m, and assuming that the...
2.24 A pipe of 0.3 m outer diameter at a temperature of 160°C is insulated with...
2.24 A pipe of 0.3 m outer diameter at a temperature of 160°C is insulated with a material having a thermal conductivity of k = 0.055 (1 + 2.8 × 10–3T) W/mK where T is in °C. The outside surface temperature is 40°C. Determine the heat flow/m length and the temperature at the mid radius
Exercise 1.16 An insulated district heating pipe with a total diameter d = 0.4 m is laid in the ground at a depth of h = 1.2 m. For a long cold period with an average ground surface temperature o...
Exercise 1.16 An insulated district heating pipe with a total diameter d = 0.4 m is laid in the ground at a depth of h = 1.2 m. For a long cold period with an average ground surface temperature of 0°C and a temperature at the outer edge of the pipe insulation of 20°C, the heat loss per 1km of steam pipe must be calculated. The thermal conductivity of the soil should be assumed to be 0.6 W/mk
Exercise 1.16...
Problem 1. Steam at 120°C is transported in a long 8" outer diameter pipe. Its outer surface is covered with a 1" thick fiberglass (thermal conductivity, 0.05 W/(mK)) insulation. When the outer temperature is 0°C, the rate of condensation of steam is measured to equal 0.06 g per meter of the pipe length. Estimate the heat transfer coefficient. The heat of vaporization of the steam is 2600 J/g. The resistance to the heat transfer through the pipe wall may be...
Al m diameter sphere is exposed to an en covered with a layer of insulation 2.5 cm thick whose thermal conductivity temperature of the sphere on the inside of the insulation is 315ºC. Assuming emissivity of 0.9, compute the value of the conve 's compute the value of the convection heat transfer coefficient that must be maintained on the outer surface of the insulation to ensure that the outer surface not exceed 41°C. exposed to an environmental temperature of 28°C....
Exercise 10 Consider a 2-m-high electric hot water heater that has a diameter of 40 cm and maintains the hot water at 55°C. The tank is located in a small room whose average temperature is 27°C, and the heat transfer coefficients on the inner and outer surfaces of the heater are 50 and 12 W/m2.°C, respectively. The tank is placed in another 46-cm-diameter sheet metal tank of negligible thickness, and the space between the two tanks is filled with foam...
Hot CO2 gas at a temperature T-1 = 250°C is flowing through a steel pipe (kı = 70 W/(m.K)) whose inner and outer radiuses are 12 cm and 14 cm, respectively, in a cold environment at Tm2 = -10°C. As shown in the figure below, the steel pipe is insulated with 7.0 cm thick spray-foam insulation (k2 = 0.03 W/(m.K)) and 5.0 cm thick glassfiber insulation (k3 = 0.05 W/(m.K)). Consider the heat transfer coefficients of CO2 gas and the...
Consider a 2-m-high electric hot-water heater that has a diameter of 40 cm and maintains the hot water at 60 C. The tank is located in a small room at 20°C whose walls and ceiling are at about the same temperature. The tank is placed in a 44-cm-diameter sheet metal shell of negligible thickness, and the space between the tank and the shell is filled with foam insulation. The average temperature and emissivity of the outer surface of the shell...
Problem
:
A cryogenic flui
d is flowing in a
304 SS
pipe.
The pipe is insulated
on its outside surface
with
6
-
mm thick,
evacuated,
aluminum foil/glass mat insulation.
(“Evacuated” means a partial vacuum is drawn on the
insulation to
remove air that would otherwise fill
pores inside the insulation.)
The pipe
inside diameter
is 127 mm; it’s outside diameter is 138 mm.
The
fluid temperature is
-
173
o
C
.
T
he
air temperature
outside the...
A pipe with insulation material is used to carry steam to an operating plant. The conditions and dimensions for the system are as follows Variable Value Length of pipe, L 100 ft Inner diameter of pipe, Do 1 inch Outer diameter of pipe, D1 1.24 inches Outer diameter of insulation, D2 2 inches Inside film heat transfer coefficient for condensing saturated steam, ho 800 Btu/hr-ft2.oF Outside film heat transfer coefficient for air, ht 2 Btu/hr-ft2.oF Thermal conductivity of the pipe,...
Question 3 34 pts ro 1 ri = 0.05m A pipe with surface temperature T1 - 458 K is wrapped with 0.04 m of glass fiber pipe insulation. The outer surface temperature of the insulation, T2 is equal to 347 K and its emissivity is equal to 0.68. The insulation is also subject to natural convection with a bulk fluid temperature of 298 K and h = 4 W/m2-K. For a pipe length of 100 m, and assuming that the...
Exercise 1.16 An insulated district heating pipe with a total diameter d = 0.4 m is laid in the ground at a depth of h = 1.2 m. For a long cold period with an average ground surface temperature of 0°C and a temperature at the outer edge of the pipe insulation of 20°C, the heat loss per 1km of steam pipe must be calculated. The thermal conductivity of the soil should be assumed to be 0.6 W/mk
Exercise 1.16...
Most questions answered within 3 hours.
-
What specific indicators can point to lack of progress for
African Americans in American society?
asked 48 minutes ago -
1-The Electrons in a beam are moving at 2.7×108 m/s in an
electric field of 15000...
asked 1 hour ago -
A gas tank is a vertical cylinder. It has a radius of 1m, a
height of...
asked 1 hour ago -
Accent Software faces the following conditions. All of these
support Accent’s use of a market-penetration pricing...
asked 2 hours ago -
A mathematically inclined friend emails you the following
instructions: "Meet me in the cafeteria the first...
asked 2 hours ago -
A monopoly sells in two countries . The demand curves in the two
countries are p1...
asked 3 hours ago -
A .15kg rubber ball is bounced off a wall. Before hitting the
wall, the ball moves...
asked 4 hours ago -
A manufacturing company preparing to build a new plant is
considering three potential locations for it....
asked 4 hours ago -
B. If compound Y has approximately the same values of solubility
in toluene as compound X,...
asked 4 hours ago -
Oscar Inc. has inventory in Japan valued at 39,051,000 Yen one
year ago. One year ago...
asked 5 hours ago -
If Canada suffered from "fundamental disequilibrium," and its
government choose not to devalue its currency, a...
asked 5 hours ago -
4. How many input & output Key Value Pairs are passed into,
and emitted out of...
asked 5 hours ago