1. When a TLC plate was developed, detection by UV light showed a single spot at the...
1. When a TLC plate was developed, detection by UV light showed a single spot at the origin. YOU concluded that the sample consisted of a single pure compound. Was your conclusion justified? Why or why not? Be explicit in your response.
Homework Answers
Add Answer to:
1. When a TLC plate was developed, detection by UV
light showed a single spot at the...
1) A student develops their TLC plate and places it under a UV light, but nothing...
1) A student develops their TLC plate and places it under a UV light, but nothing appears. What mistake might the student have made? a) Spotted the compound below the level of eluent b) Spotted the compound above the level of eluent c) Used a sample that was too concentrated d) Used too much sample 2)Thin layer chromatography, TLC, is commonly used to monitor reactions to completion. Using this technique, what would indicate to a student that the reaction is...
A TLC plate was run in 1:1 ethyl acetate and hexane, but when developed the plate...
A TLC plate was run in 1:1 ethyl acetate and hexane, but when developed the plate only showed baseline spots. What change could be made to get the spot(s) to move further up the plate? -Spot a new plate and run again in the same solvent system -Spot a new plate and run in neat hexane -Spot a new plate and run in 1:2 ethyl acetate/hexane -Spot a new plate and run in 2:1 ethyl acetate/hexane
Possible Quiz Questions 1 What two methods of visualizing spots on a TLC plate will you...
Possible Quiz Questions 1 What two methods of visualizing spots on a TLC plate will you use in this Give two reasons why would you predict that the elution solvents (hexanes or acetate) would not be visible under UV visualization? week's lab? ethyl 2. Define R 3. Calculate the R of the spot on the following TLC plate. 4. Which compound in each pair is predicted to have the higher Ri? a. CH3CH2CH2CH2OH and CH3CH2CH2CH28r b. CH3CH2CH2CH2OH and CH3CH2CH2CH2CH2CH2CH3 c....
1. A student spots an unknown sample on a TLC plate and develops it in dichloromehane solbv Only ...
help !!!
1. A student spots an unknown sample on a TLC plate and develops it in dichloromehane solbv Only one spot, for which the Ry value is 0.15, is observed. Does this indicate that the unknown material is a pure compound? What can be done to verify the purity of the sample?
1. A student spots an unknown sample on a TLC plate and develops it in dichloromehane solbv Only one spot, for which the Ry value is 0.15,...
3. TLC analysis of an unknown sample using pure ethyl acetate as a developing solvent gives a single spot with an Rf va...
3. TLC analysis of an unknown sample using pure ethyl acetate as a developing solvent gives a single spot with an Rf value of 0.08 1 points A. Explain why this result does not guarantee that the sample is a pure compound. B. Suggest two changes that could be made to the experiment to improve the analysis of the unknown sample. 2 points Change 1 Change 2
4. Consider the following silica gel TLC plac or compounds A, B, and hexines: developed in...
4. Consider the following silica gel TLC plac or compounds A, B, and hexines: developed in Fo-o- og a) Determine the Rr values of compounds A, B, and C run on a silica gel TLC plate using hexanes as the solvent b) Which compound, A, B, or C. is the most polar? values if you used acetone instead c) What would you expect to happen to the of hexanes as the eluting solvent? 5) Consider a sample that is a...
1) Calculate the Rf value of a spot that travels 5.7 cm, with a solvent front...
1) Calculate the Rf value of a spot that travels 5.7 cm, with a solvent front that travels 13 cm. 2) A student spots an unknown sample on a TLC plate and develops it in pentane solvent. Only one spot, for which the Rf value is 0.05, is observed. Is the unknown material a pure compound? What can be done to verify the purity of the sample using thin-layer chromatography? 3) You try to synthesize n-hexyl bromide as a product...
1. A solution of the sample to be analyzed has been made in a suitable solvent...
1. A solution of the sample to be analyzed has been made in a suitable solvent and wil l be provided for you. With this solution, a small spot is applied at a distance hear the bottom of the edge of a TLC plate using an applicator. (see Figure 1) This spot must be above the level of solvent in the TLC chamber. Why? 2. The plate is placed in a developing chamber containing the appropriate solvent (eluent), covered, and...
can you please answer all 1. When you run a TLC of the reaction in ethyl...
can
you please answer all
1. When you run a TLC of the reaction in ethyl acetate : hexanes 1:1, the plate below is produced. Give a solvent system that would be expected to produce greater separation and a BRIEF (8 words) justification about your choice. (5 points) 7 6 5 4 3 b. Calculate the R for the bottom spot. (5 points) c. Which compound on the TLC plate is the most polar? (5 points) 2. Why is it...
can you please answer all 1. When you run a TLC of the reaction in ethyl...
can
you please answer all
1. When you run a TLC of the reaction in ethyl acetate : hexanes :: 1:1, the plate below is produced. Give a solvent system that would be expected to produce greater separation and a BRIEF (8 words) justification about your choice. (5 points) 9 10 8 7 LLLLLLL 6 5 4 001 2 3 b. Calculate the R for the bottom spot. (5 points) c. Which compound on the TLC plate is the most...
Possible Quiz Questions 1 What two methods of visualizing spots on a TLC plate will you use in this Give two reasons why would you predict that the elution solvents (hexanes or acetate) would not be visible under UV visualization? week's lab? ethyl 2. Define R 3. Calculate the R of the spot on the following TLC plate. 4. Which compound in each pair is predicted to have the higher Ri? a. CH3CH2CH2CH2OH and CH3CH2CH2CH28r b. CH3CH2CH2CH2OH and CH3CH2CH2CH2CH2CH2CH3 c....
help !!!
1. A student spots an unknown sample on a TLC plate and develops it in dichloromehane solbv Only one spot, for which the Ry value is 0.15, is observed. Does this indicate that the unknown material is a pure compound? What can be done to verify the purity of the sample?
1. A student spots an unknown sample on a TLC plate and develops it in dichloromehane solbv Only one spot, for which the Ry value is 0.15,...
3. TLC analysis of an unknown sample using pure ethyl acetate as a developing solvent gives a single spot with an Rf value of 0.08 1 points A. Explain why this result does not guarantee that the sample is a pure compound. B. Suggest two changes that could be made to the experiment to improve the analysis of the unknown sample. 2 points Change 1 Change 2
4. Consider the following silica gel TLC plac or compounds A, B, and hexines: developed in Fo-o- og a) Determine the Rr values of compounds A, B, and C run on a silica gel TLC plate using hexanes as the solvent b) Which compound, A, B, or C. is the most polar? values if you used acetone instead c) What would you expect to happen to the of hexanes as the eluting solvent? 5) Consider a sample that is a...
1) Calculate the Rf value of a spot that travels 5.7 cm, with a solvent front that travels 13 cm. 2) A student spots an unknown sample on a TLC plate and develops it in pentane solvent. Only one spot, for which the Rf value is 0.05, is observed. Is the unknown material a pure compound? What can be done to verify the purity of the sample using thin-layer chromatography? 3) You try to synthesize n-hexyl bromide as a product...
1. A solution of the sample to be analyzed has been made in a suitable solvent and wil l be provided for you. With this solution, a small spot is applied at a distance hear the bottom of the edge of a TLC plate using an applicator. (see Figure 1) This spot must be above the level of solvent in the TLC chamber. Why? 2. The plate is placed in a developing chamber containing the appropriate solvent (eluent), covered, and...
can
you please answer all
1. When you run a TLC of the reaction in ethyl acetate : hexanes 1:1, the plate below is produced. Give a solvent system that would be expected to produce greater separation and a BRIEF (8 words) justification about your choice. (5 points) 7 6 5 4 3 b. Calculate the R for the bottom spot. (5 points) c. Which compound on the TLC plate is the most polar? (5 points) 2. Why is it...
can
you please answer all
1. When you run a TLC of the reaction in ethyl acetate : hexanes :: 1:1, the plate below is produced. Give a solvent system that would be expected to produce greater separation and a BRIEF (8 words) justification about your choice. (5 points) 9 10 8 7 LLLLLLL 6 5 4 001 2 3 b. Calculate the R for the bottom spot. (5 points) c. Which compound on the TLC plate is the most...
Most questions answered within 3 hours.
-
You plan to save $5,700 per year for the next 10 years. After
the last deposit,...
asked 5 minutes ago -
On January 1, 2019, ABC Corp. borrowed $81,000 by signing an
installment loan. The loan will be...
asked 9 minutes ago -
Enzyme X exhibits maximum activity at pH = 5.25. X shows a sharp
decrease in its...
asked 24 minutes ago -
Postulate a reason for why so many aliphatic amino acids are
essential.
asked 23 minutes ago -
Three samples were taken of 4 different dog food bags and their
weights were recorded:
Sample/Observation...
asked 27 minutes ago -
The Beatles had 27 number one hits; a radio station asks
listeners to send in a...
asked 24 minutes ago -
Help with Java Program Please
Create a simple graph class. The graph class should have the...
asked 25 minutes ago -
Which of the following statements is true regarding the nature
of culture?
A.We are born with...
asked 46 minutes ago -
(a) 2
NO2(g) à 2
NO(g) +
O2(g)
The rate law for this reaction
is 2nd...
asked 49 minutes ago -
Write the overall reaction for the RedOx
reaction (below) when it occurs in an acidic environment....
asked 55 minutes ago -
Two forces are acting on an object. Force 1 on the object is 6.0
N and...
asked 56 minutes ago -
You are planning for retirement. You plan to work for 20 years.
Starting a year from...
asked 1 hour ago