3. Consider the signal h(t) -2u(t) +4u(t-2) 6u(t-6) (a) Sketch h(t). (b) Find H(f) in terms of si...
Problem 3: a) (2 points) Find the Fourier transform of g(t) = 4u(t)-2u (t-1)-2u (t-2). b) (3 points) Determine the autocorrelation of the signal (t)sin(4rt).
A signal f(t) sinc (200 t) is sampled by periodic pulse train pr(t) resented in Fig. P5.1-6. Find and sketch the spectrum of the sampled signal. Explain if you 0.8 ms 4 ms 8 ms Fig. P5.1-6 will be able to reconstruct f(t) from these samples. If the sampled signal is passed through an ideal lowpass filter of bandwidth 100 Hz and unit gain, find the filter output. What is the filter output if its bandwidth is B Hz, where...
l, f) is a periodic signal with period f(t)-n(t)-u(t-t/2 ) for 0 2π a.) Find the exponential Fourier series of f() and sketchf). What is the fundamental radian frequency. b.) Evaluate and sketch |Dml, the magnitude of the Fourier series coefficients vs.o in the range of -4s n S4 c.) Evaluate and sketch the phase angle of D, vs. co in the same range (-4S n S4) d.) Find the signal average power e) Find the approximate average power of...
6. Signal x()- exp(-t) u() and signal ho) is as shown. (a) Express h(t) in terms of ramp functions only 2 O2 3 4 (b) Find y(t) x(t)*h(t) 0) 6. Signal x()- exp(-t) u() and signal ho) is as shown. (a) Express h(t) in terms of ramp functions only 2 O2 3 4 (b) Find y(t) x(t)*h(t) 0)
2) (Fourier Transforms Using Properties) - Given that the Fourier Transform of x(t) e Find the Fourier Transform of the following signals (using properties of the Fourier Transform). Sketch each signal, and sketch its Fourier Transform magnitude and phase spectra, in addition to finding and expression for X(f): (a) x(t) = e-21,-I ! (b) x(t)-t e 21 1 (c) x(t)-sinc(rt ) * sinc(2π1) (convolution) [NOTE: X(f) is noLI i (1 + ㎡fy for part (c)] 2) (Fourier Transforms Using Properties)...
(b) The signal f(t) is shown in the figure below 3 2 f(t) _ 0 I 1 -4 -3 -2 -1 0 1 2 3 4 5 6 7 t and is given by 21 (1) + 3A (132), where A is the triangle function defined as 10-{ It a It <a It > a 0 Write the Fourier transform F [A(t)] (s) of f(t) exploiting the fact that FA(t)](s) = sinc-(s) where sin(TTS) sinc(s) ITS and the theorem for...
5. Consider the following message signal: m(t) -2 .3 10 Assume that the carrier frequency is f are kf = 105, kp-25 respectively. 108 Hz, and frequency and phase deviation constants Find the maximum and minimum frequency deviation for FM, and sketch the FM wave for a duration of 103 seconds shown in the above figure (5 points). a. b. Find the maximum and minimum frequency deviation for PM, sketch the PM wave for a duration of 103 seconds shown...
3. For the active filter circuit below, complete the following: a) Find the magnitude of the transfer function | H | starting from the nodal equations. b) Find the phase shift of the transfer function (W) c) Find the cutoff frequency fc in Hz d) Is this a high pass or low pass filter? e) Find the passband gain of the filter 62 k2 ANA EVA 22 nF 3.3k f) Given the following input signal: vi(t) = 1.0 sin(2nft +...
(1) Consider the following continuous-time signal: (1) 2ua(-t+t)ua(t), where its energy is 20 milli Joules (2 x 103Joules). The signal ra(t) is sampled at a rate of 500 samples/sec to yield its discrete-time counter part (n) (a) Find ti, and hence sketch ra(t). (b) From part (a), plot r(n) and finds its energy (c) Derive an expression for the Fourier transform of a(n), namely X(ew). (d) Plot the magnitude spectrum (1X(e)) and phase spectrum 2(X(e). (e) Consider the signal y(n)...
Parts e through f only 3. Let the RF signal s(t)A cos(8,() where Here β-0.2 and A,-2.0V andfel 00MHz andf-2kHz and A,-10V a. Is the phase or frequency modulation? b. What is the modulation index? c. Find the frequency deviation d. Find the frequency sensitivity factor in Hz/V. e. Plot the amplitude spectrum of s(t). State any approximations f. What is the total power in s(t)? g. How much power is at f-100MHz? h. What is the RF bandwidth?