Iinkage mechonisnt: coupler b)t the bar For a four if the Coup Increaies er is kis ncreased how C...
[MATLAB Coding] A four-bar linkage system is shown above. The first link, a, is an input link (crank) of length 1. The second link, b, is a coupler link of length 2. The third link, c, is an output link of length 4. The forth link, d, is the fixed link (ground) of length 5. All lengths are provided in metres. Please answer the whole question in MATLAB coding. 4 A four-bar linkage system is shown above. The first link,...
c) How would your answer to (b) above change if consumption in Oregon were a negative function of the interest rate. Fpr each of the four variables state: rises more, rises less, rises same, falls less, falls more, falls same, no change, or ambiguous. No computations necessary. In 2-3 sentences explain why this assumption for consumer behavior might be more realistic. This exercise is similar to exam question. Please hand it in on Oct 10, 2019. It will be counted...
Please show full working. Please only answer if you know how. Calculate the 2-D flux of a constant vector field F-a across a curve C : r(t) :r(t)s l y/ t 3. (z < t < b. İll(licatiu" il . What is the ilux when the curve C is closed? Explain e positive direction Calculate the 2-D flux of a constant vector field F-a across a curve C : r(t) :r(t)s l y/ t 3. (z
5. (9pts) You are studying an ER membrane protein, YFG1 (outlined in yellow), with three transmembrane domains (rectangles A, B & C at the amino acid positions according to the following map, connected by soluble domains (wavy lines): N-term 10 10 Com Amino acid position (not to scale) 30 60 80 140 160 310 ABCI YFG1 alkaline phosphatase To determine how the protein is arranged in the ER membrane, you construct a series of shortened YFG1 proteins that are connected...
DTO23/3 SECTION A Figure Ql illustrates four micrographs (A, B, C, and D) taken using a scanning electron microscope. For each micrograph: ) Draw a sketch outlining the main features. (ii) Identify the microstructure explaining your decision. (iüi) Explain in detail with the aid of illustrated sketches and graphs how these m (2 marks) I mark were formed. Where possible justify your answer for and against. (I mark) iv) Comment on the mechanical or environmental properties or an improvement strategy...
SECTION Δ 01 Figure Ql illustrates four micrographs (A, B, C, and D) taken using a scanning electron microscope. For each micrograph: ) Draw a sketch oudining the main feature (ii) Identify the microstructure explaining your decision. Gii) Explain in detail with the aid of illustrated sketches and graphs how these microstructures (iv) Comment on the mechanical or environmental properties or an improvement strategy (2 marks) I mark (6 mrtu were formed. Where possible justify your answer for and against....
Can explain how to get the answer for (d) ? tried to understand but failed. Question 2 (10 marks) a. Find the algebraic equation for the logic circuit in Figure l (2.5 marks) A B C Dt 1.St 1,St B.p Use algebraic simplification property to simplify the algebraic equation obtained from (a). b. (2.5 marks) (2.5 marks) d. If each NOT gate delay DNAND gate delaf3OR gate delay inverted input AND get delay @yand XOR gate dela2, compute the total...
Parts a,b,c Only bullet points needed on what I should write about thanks Answer Question l and one other question. Question 1 is allocated 60% of the marks for the paper. The other question is allocated 40% of the marks for the paper. Questions 2 and 3 are graded as a whole The duration of the examination is 2 hours. . Answer four parts of the following question. Your answer for each part should be no longer than two pages...
01 Figure Q1 illustrates four micrographs (A, B, C, and D) taken using a scanning electron microscope. For each micrograph: Draw a sketch outlining the main features. (2 marks) (ii) Identify the microstructure explaining your decision. (1 mark) (iii) Explain in detail with the aid of illustrated sketches and graphs how these microstructures (6 marks) were formed. Where possible justify your answer for and against (iv) Comment on the mechanical or environmental properties or an improvement strategy. (1 mark) (Each...
help with these questions please ! (a) empty vector (b) my IIA (C) my IIB View larger image Figure 1 Equal numbers of COS-7 cells were transfected with (a) empty vector, (b) myosin TIA (my IIA) or (c) myosin IIB (my IIB). After 3 days, cell nuclei were stained and images were captured using a fluorescence microscope. a. The following part-questions require you to analyse and interpret the data presented in Figure 1. i. In Figure 1, which of the...