What value of resistor R is needed for this oscillator to generate a 250 KHz clock signal? What i...

Question

Question

What value of resistor R is needed for this oscillator to generate a 250 KHz clock signal? What is the duty cycle of the cloc

Answer 1

Answer #1

Uent) 1-44 Crt 26)そ470 x 10-12. 256x10 470x10 FRt dulyyde- <2.24/.

Answer 2

Similar Homework Help Questions

Answers are at the end of the chapter 1. If an S-R latch has a 1...

Answers are at the end of the chapter 1. If an S-R latch has a 1 on the S input and a 0 on the R input and then the S input goes to 0, the latch will be (a) set (b) reset (c) invalid (d) clear 2. The invalid state of an S-R latch occurs when (c) S 1,R-1 (d) S-0, R-O 3. For a gated D latch, the output always equals the D input (a) before the enable...
(a) Design a inverting Schmitt trigger circuit to be used as a zero crossing detector with transition voltages about ±25...

(a) Design a inverting Schmitt trigger circuit to be used as a zero crossing detector with transition voltages about ±25 mV. Assume the saturation voltages for the op–amp are ±13 V. Draw the voltage transfer characteristic (VTC), i.e., vout vs. vin. (b) Design an astable multivibrator to produce a square signal with a frequency of 1 kHz using C=0.01 µF, R1 = 30 kΩ, and R2 = 20 kΩ. Sketch the circuit waveforms (vo, v +, and v −) assuming...