Your company needs a spur gearset for speed reduction from input of 3750 to output of 1500 rpm. T...
Component design Spur gear analysis A speed-reducer has 200 full-depth teeth, and the single reduction spur-gear gearset has 22 and 60 teeth. The diametral pitch is 4 teeth/in and the face width is 3-1/4 in. The pinion shaft speed is 1145 rpm. The life goal of 5 year 24 hours per day service is about 3(10 9) pinion revolutions. The absolute value of the pitch variation is such that the transmission accuracy level number is 9. The materials are 4340...
Please help. Thx Part 2 (50 pts) A single-reduction spur gear system is as shown. The pinion "P" drives gear "G. Pinion"Pis driven at 1800 rpm with 1.5 hp Pinion "P" has a pitch diameter of 2 inches, and has 20 teeth. The gear "Ghas 120 teeth. All teeth have a pressure angle of 20, full-depth, hobbed profile, and a face width of 0.5 inches. All materials are steel. Determine: A) Minimum number of pinion teeth: Np,min This shows that...
Two 20° involute full depth spur gears are used to transmit the power and speeds shown. The material for both pinion and gear is specified as through- hardened steel tempered to 300 BHN surface hardness. Both pinion and gear are precision cut for "very accurate” gearing. For a factor of safety of 2 and assuming a diametral pitch, Pof 9. specify face widths of the pinion and gear using only the AGMA bending fatigue analysis. State all assumptions used to...
Two 20° involute full depth spur gears are used to transmit the power and speeds shown. The material for both pinion and gear is specified as through-hardened steel tempered to 300 BHN surface hardness. Both pinion and gear are precision cut for "very accurate" gearing. For a factor of safety of 2 and assuming a diametral pitch, Prof 9, specify face widths of the pinion and gear using only the AGMA bending fatigue analysis. State all assumptions used to determine...
power = 3 kW if need any more information please ask !!! You are the designer and you have been asked to design a speed reducer (gearbox) that will take power from the shaft of an electric motor rotating at 1500 rpm and deliver it to a machine that is to operate at approximately at 200 rpm Assume that you have decided to use spur gears to transmit the power [A power equal to the last one digits of your...