Strain gages A, B, C, and D are mounted on a plate subjected to a simple bending moment M and an axial load F, as shown in Fig. 3. The bending strain, axial strain, and thermal strain on the upper surface are denoted εb, εa, εT, respectively. A bridge circuit (Fig. 4.) was built to sense the strains.
Strain gages A, B, C, and D are mounted on a plate subjected to a simple bending moment M and an ...
P2: (40points) As shown below (Fig.1), A strain gage with gage factor of 2.02 is mounted on the bottom of a beam to measure the strain on the surface of the beam. The beam's Young's Modulus is 193 GPa. A wheatstone bridge circuit was constructed as sketched in Fig. 2. All resistors including the gage itself is 12002. Supply voltage is 5.0 V DC. The bridge is initially balanced when there is no load Strain gage Fig.1 Ri R2 DC...
As shown below (Fig.1), A strain gage with gage factor of 2.02 is mounted on the bottom of a beam to measure the strain on the surface of the beam. The beam's Young's Modulus is 193 GPa. A wheatstone bridge circuit was constructed as sketched in Fig. 2. Al resistors including the gage itself is 1202. Supply voltage is 5.0 V DC. The bridge is initially balanced when there is no load (a). when a downward load is added, will...
A 3 m rigid bar AB is supported with a vertical translational spring at A and a pin at B The bar is subjected to a linearly varying distributed load with maximum intensity g Calculate the vertical deformation of the spring if the spring constant is 700 kN/m. (ans: 21.43 mm) 2. A steel cable with a nominal diameter of 25 mm is used in a construction yard to lift a bridge section weighing 38 kN. The cable has an...