A) in dielectrics the Electric field reduced because there is polarization and the internal electric field reduces the net effect so the permittivity is more than that of vacuum so the dielectric constant which is nothing ratio of the permittivity of the material and permittivity of free space. So the dielectric constant is always greater than one.
B) in diamagnetic materials there are magnetic dipole inside the material that align themselves in opposite direction to the applied field so the magnetic field inside the material reduces and hence It's permiability is less then that of vacuum so the relative permiability is less than one.
Problem 6: A. The relative dielectric constant of a dielectric is always greater than 1 (field li...
Select the appropriate answer 1-The influence of magnetic field acting on a stationary charged particle is to: a -accelerate the particle. b- change its direction of motion. c-both accelerate and change direction of motion. d- none of the above . ----------- 2-The magnetic field Hr inside a infinite length conductor aligned to the z-axis is equal to all values of r smaller than the conductor radius a: a- True b-False ---------- 3- If the relative magnetic permeability Ur of material...
The electric field of a positive z-traveling wave in a medium with relative dielectric constant of er 4 and with frequency of 2.5 GHz is given by Ex Eox cos(ot - kz) V/m. 1. a. Find the magnetic field if Eox 400,000 V/m. b. Determine the phase velocity and wavelength.
A material with a dielectric constant greater than one (K>1) inserted into a capacitor would allow for more charge to be stored on the capacitor, assuming the voltage is below the breakdown voltage of the capacitor True False
typically the electric forces are greater than the magnetic ones. Let’s consider two parallel wires, placed at a distance d, each holding a constant line charge λ. Both wires move along their own axis at a speed v, therefore remaining in the same position (they are infinitely long) but creating a magnetic field. The two wires therefore repel each other because they old the same charge, however attract each other due to the magnetic force that they originate. At which...
Problem 6. Electromagnetic plane waves in a lossy medium The electric field of an electromagnetic plane wave traveling in a lossy medium can be written as where z is the distance, t is time, and fthe frequency. For f 1 GHz, it is found by measurement that the amplitude of the electric field is attenuated by a factor of 3 after the wave travels 100 m (i.e., to 1/3 of the amplitude at z-0 when it arrives at z- 100...
question 1) Two identical loudspeakers, A and B, are 3.00-m apart. The loudspeakers are driven by the same amplifier and emit 900-Hz sound waves in all directions. Take the speed of sound in air to be 344 m/s. A small microphone is moved out from point B along a line perpendicular to the line connecting A and B. a) At what distances from B will there be destructive interference? b) At what non-infinite distances from B will there be constructive...
[6] 2. In the previous problem, how long after switch is closed until the magnetic field is stable? Answer: (a) 1.38 ms. (6) 1.85 ms (c) 2.33 ms. (d) 2.79 ms. (e) 341 ms. (1) - [8] 3. An AC generator is connected to a circuit. The generator's emfis E(0) - 152 V sin(at). If the maximum current that results is 150 mA circuit, -5.01 x 10rad/s and the phase angle is -85.6 degrees, complete the following (0) = sin...
This is my experiment about Earth magnetic field induction by tangensgalvonometer. I must additional conclusion for my experimental values and Bo=1.68x10^-5 T. Could you compare Bo=1.68x10^-5 and my experimental values. experiment did same city which is Bo=1.68x10^-5 I need conclusion about this case. thank you. Results: Bo (1-1 )-7.66x10 Be(l 2-0107 Be (1-3 )-1.72x10 · Be (1-3, 2 )" f,79x16 Bo (Rī9小1.GC-er「 Measurement of the horizontal component of Earth's magnetic field induction by tangensgalvanometer In each point the Earth's magnetic...
Problem 5 (15pts). Suppose that we observe a random sample X. from the density Xn 1 0 2 0, else, where m is a known constant which is greater than zero, and 0>0. (a) Find the most powerful test for testing Ho : θ Bo against b) Indicate how you would find the power of the most powerful test when θ-e-Do not perform (c) Is the resulting test uniformly most powerful for testing Ho :0-00 against Ha :e> et Explain...
Microstrip line is one of the most popular types of planar transmission lines primarily because it can be fabricated by photolithographic processes and is easily miniaturized and integrated with both passive and active microwave devices. A conductor of width W is printed on a thin, grounded dielectric substrate of thickness d and relative permittivity e,. Because some of the field lines are in the dielectric region and some are in air, the effective dielectric constant satisfies the relation Where e,...