Compression members (4 points): The hydraulic cylinder shown below has a bore of 80 mm and is to ...
--Trunnion Clevis Problem II (10 Marks) For the shown trunnion mounted hydraulic cylinder, the internal diameter of the cylinder is 75 mm and the maximum operation pressure is the cylinder is 25 MPa. The pistion rod is made of steel 40Cr1 (Sy = 530 MPa and E=207 GPa). For buckling considerations, the effective length of the psiton rod is considered as the distance between the trunnion and the clevis-mount, when the piston rod is extended to its full working stroke...
The crane shown in the sketch is to be designed to lifl a load of 70 KN to a maximum height which corresponds to the position where the beam will be making an angle of 70P with the ground You are required to: Draw necessary free body diagrams and caculate all the forces acting on the beam, piston rod and mount joints for the configuration shown in the sketch 2) Design the beam based on bending stress only, assuming a...
QUESTION 4 Two storey column shown below has hqof 4.72m and h2 of 5.08m. Determine the effective length which must be used in design of this column. Give your answer in mm. IP hal h₂ 2 points Save Answer QUESTION 5 Two storey elastic steel column shown below hash of 3,434mm and H of 6,352mm. It has rectangular cross section with b of 64mm and d of 128mm. At the bottom it is free to rotate in Y-Y plane but...