What layer of the Internet protocol does a non-routing switch operate at? What values does it use to determine output port? If it does not hold this value in its table, what is its default action?
A non - routing switch operate at Layer 2 (Data Link Layer) of the internet protocol.
It uses MAC address to determine output port. Each packet which comes to switch contains source and destination physical address in it, on basis of which switch forwards packet to other machine. Switch always sent packet based on destination MAC address. If MAC Address is found, packet is sent out to port against which MAC Address was matched.
For this switch uses one table in its cache memory called MAC Address table or Forwarding Table in which switch stores that at which port which machine is connected by storing its physical address (MAC Address). So table contains two columns (Physical Address and Port Number) and rows equal to number of ports in switch. When switch is turned ON, by default there is no entry in MAC address table, as communication starts, based on devices involved entries are created in table.
If MAC address not found then ARP Request is generated and MAC address is obtained. If MAC Address not found then the packet is broadcasted to all ports, except on which it has received the packet.
What layer of the Internet protocol does a non-routing switch operate at? What values does it use...
Morriss Math 22 Dual Activation Switch Desigrn Imagine a hardware protocol that treats negations () and conditionals ->) as fundamental logical operations. Under this protocol, design an electronic switch with four input wires arranged in two pairs. To allow current to flow, the switch must be activated by a voltage from exactly one input wire in each pair. A second wire from either pair acts as an inhibitor and stops the current flow Let p, q, r, and s represent...
Q1 Error detection/correction Can these schemes correct bit errors: Internet checksums, two-dimendional parity, cyclic redundancy check (CRC) A. Yes, No, No B. No, Yes, Yes c. No, Yes, No D. No, No, Yes E. Ho, hum, ha Q2 CRC vs Internet checksums Which of these is not true? A. CRC's are commonly used at the link layer B. CRC's can detect any bit error of up to r bits with an r-bit EDC. c. CRC's are more resilient to bursty...
A protocol is a set of rules that define some operation. For example, the Internet Protocol (IP) specifies how messages are routed throughout the internet. In this problem, you are asked to implement your 1st messaging protocol (MP1). MP1 is a binary protocol that is used to efficiently encode a set of arithmetic operations using a 4-byte data type (e.g., int). The specification of the protocol is as follow. Using a 4-byte (32-bit stream), MP1 messages encode the ‘+’, ‘-‘,...
Question 26 In the TCP/IP model, what layer combines the responsibilities of the Application, Presentation, and Session layers from the OSI model? a. Internet b. Application c. Transport d. Link 1.25 points Question 27 In the TCP/IP model, what layer is considered so simple that it is ignored entirely? a. Network b. Data Link c. Application d. Physical 1.25 points Question 28 In the United States, who is able to activate the Emergency Alert System at the national level? a....
1. To which of the following subnets does IP address 225.3.2.22 belong? 225.3.2.0/24 225.3.2.22/24 225.2.3.0/24 225.0.0.0/24 none of the above Question 2 On which of the following devices does the transport layer NOT run? laptop router cellphone A, B and C none of the above Question 3 What is the source address contained in the discover message sent by a host that is wanting to obtain an IP address? 255.255.255.255 0.0.0.0 the IP address of the server the last IP...
Refer to the network figure above, showing two Ethernet Subnets connected through an IP Router, for questions #1, #2 and #3. For each device, both its Internet Protocol (IP) address and its MAC address (also called the Physical address or the Ethernet address) are shown. The Subnet Mask used by all devices is 255.255.255.192 (which is same as prefix length “/26”). (5 points) Assuming that Client #1 sent a packet to Client #3 and then Client #3 sent a packet...
QUESTION 8 Which layer of the TCP/IP hierarchy presents incoming messages to the computer user? a. Network b. Link c. Transport d. Application 2.5 points QUESTION 9 A relational database is a collection of one or more tables that are related by key values. True False 2.5 points QUESTION 10 Which standards organization produced the OSI reference model for internet communication? a. IEEE b. ISO c. ANSI 2.5 points QUESTION 11 Which of the following is used...
A researcher wishes to estimate the proportion of adults who have high-speed Internet access. What size sample should be obtained if she wishes the estimate to be within 0.04 with 99% confidence if (a) she uses a previous estimate of 0.54? (b) she does not use any prior estimates? Х i Table of critical values Click the icon to view the table of critical values. (a) n= (Round up to the nearest integer.) Level of Confidence, (1 - «). 100%...
In java The Java language has a math class with several methods you can use for mathematical calculations. For instance, to find the square root of a number you can use the Math.sqrt method: double value = 9.0; double result = Math.sqrt(value); In the above example the variable result will hold 3.0. The same holds true for the cube root: double value = 9.0; double result = Math.cbrt(value); You can also get the base 10 logarithm of a number: double...
Subject. Internet & web design technology I need the questions number. 27, 28, 29,30,35,,37,39 , 40,43,45,49,50 Please send me the correct answer The last page have 43,45,49,50 We were unable to transcribe this imageprotocol (32) t an application attempts to send a UDP do? message that exceeds the Maximum Transmission Unit (MTU), what will the Ip d) compress it le) expand MTU (b) truncate it (c) fragment n (a) reject it (33] Which is not true of the Transmission Controil...