There are two bearings support each end of a shaft. Bearing at right side has vertical stiffness,...
7-25 A shaft is to be designed to support the spur pinion and helical gear shown in the figure on two bearings spaced 700 mm center-to-center. Bearing A is a cylindrical roller and is to take only radial load; bearingB is to take the thrust load of 900 N produced by the helical gear and its share of the radial load. The bearing at B can be a bal bearing. The radial loads of both gears are in the same...
2. A shaft carrying a 10KN load is supported by two identical plain journal bearings. The shaft, which normally rotates at 3000 rev/min has, at the bearing region, a nominal diameter of 50 mm and a length of 16 mm. Starting with a radial clearance ratio of 0.0015 and neglecting thermal effects a) Calculate the temperature of the lubricant which will produce an eccentricity ratio of 0.7 if the oil used is SAE10 b) Comment of the necessity to supply...
The gears attached to the fixed-end steel shaft are subjected to the torques shown in the figure. If the shear modulus of elasticity is 150 GPa a determine the following: nd the shaft has a diameter of 14 mm, a. Sketch the torque diagram along the steel shaft. b. Determine the maximum shear stress at Tmax and specify location. c. Sketch the shear stress distribution along the radial line at location specified in (b). d. Determine the displacement of the...
A 3 m rigid bar AB is supported with a vertical translational spring at A and a pin at B The bar is subjected to a linearly varying distributed load with maximum intensity g Calculate the vertical deformation of the spring if the spring constant is 700 kN/m. (ans: 21.43 mm) 2. A steel cable with a nominal diameter of 25 mm is used in a construction yard to lift a bridge section weighing 38 kN. The cable has an...