Streamlines and conical funnel.
unsure how to start this question, part a) is confusing.
Streamlines and conical funnel. unsure how to start this question, part a) is confusing. The streamlines in the conical nozzle shown in Figure 1 are essentially radial lines emanating from point A an...
PART A
PART B
PART C
PART D
(1 point) A mass m = 4 kg is attached to both a spring with spring constant k = 197 N/m and a dash-pot with damping constant c=4N s/m. The mass is started in motion with initial position to 3 m and initial velocity vo = 6 m/s. Determine the position function r(t) in meters. x(1) Note that, in this problem, the motion of the spring is underdamped, therefore the solution can...
Question 1 In the figure, two particles are launched from the origin of the coordinate system at time t = 0. Particle 1 of mass my - 5.20 g is shot directly along the x axis (on a frictionless floor), where it moves with a constant speed of 10.4 m/s. Particle 2 of mass m2 - 3.80 g is shot with a velocity of magnitude 17.0 m/s, at an upward angle such that it always stays directly above particle 1...
Question 1
Question 2:
Question 3:
Question 4:
Question 5:
Question 6:
Question 7:
Question 8:
Please number each question. Thank you
Question 1 Not yet answered Marked out of 4.00 Flag question If the number density of electrons in a wire is n 1.00 x 1028 m-3, at what drift velocity must they travel through a wire of diameter d 0.560 mm to deliver a current of 7.20 A? Give your answer in mm s1 to 3 significant figures...
please help and answer all ASAP please thank you so much
Question 49 (1 point) When light travelling in glass enters glass with a higher index of refraction, the wave will be: a) partially transmitted with a change in phase b) transmitted forming a standing wave pattern in air c) reflected so as to form a node at the junction d) totally reflected at the junction e) partially reflected without a change in phase Question 38 (1 point) The charge,...
Consider a cylindrical capacitor like that shown in Fig. 24.6. Let d = rb − ra be the spacing between the inner and outer conductors. (a) Let the radii of the two conductors be only slightly different, so that d << ra. Show that the result derived in Example 24.4 (Section 24.1) for the capacitance of a cylindrical capacitor then reduces to Eq. (24.2), the equation for the capacitance of a parallel-plate capacitor, with A being the surface area of...